1ARM PL022 SPI controller
2
3Required properties:
4- compatible : "arm,pl022", "arm,primecell"
5- reg : Offset and length of the register set for the device
6- interrupts : Should contain SPI controller interrupt
7- num-cs : total number of chipselects
8
9Optional properties:
10- cs-gpios : should specify GPIOs used for chipselects.
11  The gpios will be referred to as reg = <index> in the SPI child nodes.
12  If unspecified, a single SPI device without a chip select can be used.
13- pl022,autosuspend-delay : delay in ms following transfer completion before
14			    the runtime power management system suspends the
15			    device. A setting of 0 indicates no delay and the
16                            device will be suspended immediately
17- pl022,rt : indicates the controller should run the message pump with realtime
18             priority to minimise the transfer latency on the bus (boolean)
19- dmas : Two or more DMA channel specifiers following the convention outlined
20         in bindings/dma/dma.txt
21- dma-names: Names for the dma channels, if present. There must be at
22	     least one channel named "tx" for transmit and named "rx" for
23             receive.
24
25
26SPI slave nodes must be children of the SPI master node and can
27contain the following properties.
28
29- pl022,interface : interface type:
30	0: SPI
31	1: Texas Instruments Synchronous Serial Frame Format
32	2: Microwire (Half Duplex)
33- pl022,com-mode : polling, interrupt or dma
34- pl022,rx-level-trig : Rx FIFO watermark level
35- pl022,tx-level-trig : Tx FIFO watermark level
36- pl022,ctrl-len : Microwire interface: Control length
37- pl022,wait-state : Microwire interface: Wait state
38- pl022,duplex : Microwire interface: Full/Half duplex
39
40
41Example:
42
43	spi@e0100000 {
44		compatible = "arm,pl022", "arm,primecell";
45		reg = <0xe0100000 0x1000>;
46		#address-cells = <1>;
47		#size-cells = <0>;
48		interrupts = <0 31 0x4>;
49		dmas = <&dma-controller 23 1>,
50			<&dma-controller 24 0>;
51		dma-names = "rx", "tx";
52
53		m25p80@1 {
54			compatible = "st,m25p80";
55			reg = <1>;
56			spi-max-frequency = <12000000>;
57			spi-cpol;
58			spi-cpha;
59			pl022,hierarchy = <0>;
60			pl022,interface = <0>;
61			pl022,slave-tx-disable;
62			pl022,com-mode = <0x2>;
63			pl022,rx-level-trig = <0>;
64			pl022,tx-level-trig = <0>;
65			pl022,ctrl-len = <0x11>;
66			pl022,wait-state = <0>;
67			pl022,duplex = <0>;
68		};
69	};
70	
71