1* Marvell Armada 375 Ethernet Controller (PPv2)
2
3Required properties:
4
5- compatible: should be "marvell,armada-375-pp2"
6- reg: addresses and length of the register sets for the device.
7  Must contain the following register sets:
8	- common controller registers
9	- LMS registers
10  In addition, at least one port register set is required.
11- clocks: a pointer to the reference clocks for this device, consequently:
12	- main controller clock
13	- GOP clock
14- clock-names: names of used clocks, must be "pp_clk" and "gop_clk".
15
16The ethernet ports are represented by subnodes. At least one port is
17required.
18
19Required properties (port):
20
21- interrupts: interrupt for the port
22- port-id: should be '0' or '1' for ethernet ports, and '2' for the
23           loopback port
24- phy-mode: See ethernet.txt file in the same directory
25
26Optional properties (port):
27
28- marvell,loopback: port is loopback mode
29- phy: a phandle to a phy node defining the PHY address (as the reg
30  property, a single integer). Note: if this property isn't present,
31  then fixed link is assumed, and the 'fixed-link' property is
32  mandatory.
33
34Example:
35
36ethernet@f0000 {
37	compatible = "marvell,armada-375-pp2";
38	reg = <0xf0000 0xa000>,
39	      <0xc0000 0x3060>,
40	      <0xc4000 0x100>,
41	      <0xc5000 0x100>;
42	clocks = <&gateclk 3>, <&gateclk 19>;
43	clock-names = "pp_clk", "gop_clk";
44	status = "okay";
45
46	eth0: eth0@c4000 {
47		interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
48		port-id = <0>;
49		status = "okay";
50		phy = <&phy0>;
51		phy-mode = "gmii";
52	};
53
54	eth1: eth1@c5000 {
55		interrupts = <GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH>;
56		port-id = <1>;
57		status = "okay";
58		phy = <&phy3>;
59		phy-mode = "gmii";
60	};
61};
62