1Device tree configuration for Renesas IIC (sh_mobile) driver
2
3Required properties:
4- compatible      : "renesas,iic-<soctype>". "renesas,rmobile-iic" as fallback
5		     Examples with soctypes are:
6			- "renesas,iic-r8a73a4" (R-Mobile APE6)
7			- "renesas,iic-r8a7740" (R-Mobile A1)
8			- "renesas,iic-r8a7790" (R-Car H2)
9			- "renesas,iic-r8a7791" (R-Car M2-W)
10			- "renesas,iic-r8a7792" (R-Car V2H)
11			- "renesas,iic-r8a7793" (R-Car M2-N)
12			- "renesas,iic-r8a7794" (R-Car E2)
13			- "renesas,iic-sh73a0" (SH-Mobile AG5)
14- reg             : address start and address range size of device
15- interrupts      : interrupt of device
16- clocks          : clock for device
17- #address-cells  : should be <1>
18- #size-cells     : should be <0>
19
20Optional properties:
21- clock-frequency : frequency of bus clock in Hz. Default 100kHz if unset.
22- dmas            : Must contain a list of two references to DMA
23		    specifiers, one for transmission, and one for
24		    reception.
25- dma-names       : Must contain a list of two DMA names, "tx" and "rx".
26
27
28Pinctrl properties might be needed, too. See there.
29
30Example:
31
32	iic0: i2c@e6500000 {
33		compatible = "renesas,iic-r8a7790", "renesas,rmobile-iic";
34		reg = <0 0xe6500000 0 0x425>;
35		interrupts = <0 174 IRQ_TYPE_LEVEL_HIGH>;
36		clocks = <&mstp3_clks R8A7790_CLK_IIC0>;
37		clock-frequency = <400000>;
38		#address-cells = <1>;
39		#size-cells = <0>;
40	};
41