1Tegra124 SoC SATA AHCI controller
2
3Required properties :
4- compatible : For Tegra124, must contain "nvidia,tegra124-ahci".  Otherwise,
5  must contain '"nvidia,<chip>-ahci", "nvidia,tegra124-ahci"', where <chip>
6  is tegra132.
7- reg : Should contain 2 entries:
8  - AHCI register set (SATA BAR5)
9  - SATA register set
10- interrupts : Defines the interrupt used by SATA
11- clocks : Must contain an entry for each entry in clock-names.
12  See ../clocks/clock-bindings.txt for details.
13- clock-names : Must include the following entries:
14  - sata
15  - sata-oob
16  - cml1
17  - pll_e
18- resets : Must contain an entry for each entry in reset-names.
19  See ../reset/reset.txt for details.
20- reset-names : Must include the following entries:
21  - sata
22  - sata-oob
23  - sata-cold
24- phys : Must contain an entry for each entry in phy-names.
25  See ../phy/phy-bindings.txt for details.
26- phy-names : Must include the following entries:
27  - sata-phy : XUSB PADCTL SATA PHY
28- hvdd-supply : Defines the SATA HVDD regulator
29- vddio-supply : Defines the SATA VDDIO regulator
30- avdd-supply : Defines the SATA AVDD regulator
31- target-5v-supply : Defines the SATA 5V power regulator
32- target-12v-supply : Defines the SATA 12V power regulator
33