Home
last modified time | relevance | path

Searched refs:impedance (Results 1 – 28 of 28) sorted by relevance

/linux-4.4.14/Documentation/devicetree/bindings/sound/
Dnau8825.txt13 otherwise pin in high impedance state.
17 - nuvoton,vref-impedance: VREF Impedance selection
36 …nuvoton,micbias-voltage', SAR_VOLTAGE is configured by 'nuvoton,sar-voltage', R - button impedance.
39 - nuvoton,sar-hysteresis: Button impedance measurement hysteresis.
41 - nuvoton,sar-voltage: Reference voltage for button impedance measurement.
87 nuvoton,vref-impedance = <2>;
89 // Setup 4 buttons impedance according to Android specification
/linux-4.4.14/Documentation/hwmon/
Dda905519 Channel 1: ADC_IN1 - high impedance input (0 - 2.5V)
20 Channel 2: ADC_IN2 - high impedance input (0 - 2.5V)
21 Channel 3: ADC_IN3 - high impedance input (0 - 2.5V)
Dda905222 Channel 4: ADC_IN4 - high impedance input (0 - 2.5V)
23 Channel 5: ADC_IN5 - high impedance input (0 - 2.5V)
24 Channel 6: ADC_IN6 - high impedance input (0 - 2.5V)
/linux-4.4.14/arch/arm/boot/dts/
Dzynq-zc702.dts201 bias-high-impedance;
224 bias-high-impedance;
308 bias-high-impedance;
321 bias-high-impedance;
342 bias-high-impedance;
365 bias-high-impedance;
Dzynq-zc706.dts149 bias-high-impedance;
229 bias-high-impedance;
242 bias-high-impedance;
263 bias-high-impedance;
286 bias-high-impedance;
Dtegra124-nyan.dtsi140 bias-high-impedance;
Dtegra124-venice2.dts673 bias-high-impedance;
Dtegra124-jetson-tk1.dts1457 bias-high-impedance;
/linux-4.4.14/drivers/staging/iio/
DMakefile18 obj-y += impedance-analyzer/
DKconfig13 source "drivers/staging/iio/impedance-analyzer/Kconfig"
/linux-4.4.14/Documentation/devicetree/bindings/pinctrl/
Dxlnx,zynq-pinctrl.txt40 groups, pins, bias-disable, bias-high-impedance, bias-pull-up, slew-rate,
97 bias-high-impedance;
Dimg,pistachio-pinctrl.txt42 - bias-high-impedance: Enable high-impedance mode.
Dpinctrl-bindings.txt178 bias-high-impedance - high impedance mode ("third-state", "floating")
Dimg,tz1090-pdc-pinctrl.txt41 - bias-high-impedance
Dqcom,pmic-mpp.txt103 - bias-high-impedance:
Dqcom,pmic-gpio.txt126 - bias-high-impedance:
Dimg,tz1090-pinctrl.txt41 - bias-high-impedance
/linux-4.4.14/Documentation/devicetree/bindings/phy/
Dphy-miphy28lp.txt44 - st,tx-impedance-comp : to compensate tx impedance avoiding out of range values.
/linux-4.4.14/drivers/staging/iio/Documentation/
Dsysfs-bus-iio-impedance-analyzer-ad593328 that are allowed to pass through the unknown impedance,
/linux-4.4.14/drivers/power/
Ds3c_adc_battery.c128 static int calc_full_volt(int volt_val, int cur_val, int impedance) in calc_full_volt() argument
130 return volt_val + cur_val * impedance / 1000; in calc_full_volt()
/linux-4.4.14/Documentation/ABI/testing/
Dsysfs-class-power112 This entry allows enabling the high-impedance mode of bq24257-type
/linux-4.4.14/Documentation/devicetree/bindings/mfd/
Das3722.txt67 bias-high-impedance, drive-open-drain.
/linux-4.4.14/Documentation/devicetree/bindings/media/
Dsamsung-fimc.txt38 ports A and B into high impedance state, especially the CAMCLK clock output
/linux-4.4.14/Documentation/networking/
Darcnet-hardware.txt100 lies in the hybrid chip installed. BUS cards use high impedance output,
101 while STAR use low impedance. Low impedance card (STAR) is electrically
102 equal to a high impedance one with a terminator installed.
158 uses 50 Ohm impedance. You use T connectors to put the computers on a single
/linux-4.4.14/drivers/message/fusion/lsi/
Dmpi_history.txt254 * Removed impedance flash from FC Port Page 1.
/linux-4.4.14/Documentation/
Dparport-lowlevel.txt1184 Places the data bus in a high impedance state, if port->modes has the
Dpinctrl.txt199 may be able to make an output pin high impedance, or "tristate" meaning it is
/linux-4.4.14/Documentation/cgroups/
Dcpusets.txt441 There is an impedance mismatch here, between cpusets and sched domains.