| /linux-4.4.14/Documentation/devicetree/bindings/sound/ |
| D | tlv320aic31xx.txt | 8 "ti,tlv320aic310x" - Generic TLV320AIC31xx with mono speaker amp
9 "ti,tlv320aic311x" - Generic TLV320AIC31xx with stereo speaker amp
10 "ti,tlv320aic3100" - TLV320AIC3100 (mono speaker amp, no MiniDSP)
11 "ti,tlv320aic3110" - TLV320AIC3110 (stereo speaker amp, no MiniDSP)
12 "ti,tlv320aic3120" - TLV320AIC3120 (mono speaker amp, MiniDSP)
13 "ti,tlv320aic3111" - TLV320AIC3111 (stereo speaker amp, MiniDSP)
34 * SPL, devices with stereo speaker amp
35 * SPR, devices with stereo speaker amp
36 * SPK, devices with mono speaker amp
|
| D | nokia,rx51.txt | 12 - speaker-amplifier-gpios: GPIO for speaker amplifier
26 speaker-amplifier-gpios = <&twl_gpio 7 GPIO_ACTIVE_HIGH>;
|
| D | sirf-audio.txt | 12 speaker amplifier.
|
| D | wm8962.txt | 13 of R51 (Class D Control 2) gets set, indicating that the speaker is
|
| D | imx-audio-es8328.txt | 8 - audio-amp-supply : Power regulator for speaker amps
|
| /linux-4.4.14/drivers/staging/panel/ |
| D | lcd-panel-cgram.txt | 20 printf "\e[LG00103071F1F070301;" => big speaker
21 printf "\e[LG00002061E1E060200;" => small speaker
|
| /linux-4.4.14/Documentation/sound/alsa/ |
| D | HD-Audio-Controls.txt | 19 "Disabled" and "Enabled" state. When enabled, the speaker is muted
24 speaker-only is chosen, plugging into a headphone or a line-out jack
25 mutes the speakers, but not line-outs. When line-out+speaker is
76 and speaker outputs. As a side-effect, when this mode is set, the
|
| D | ControlNames.txt | 36 Speaker (internal speaker)
37 Bass Speaker (internal LFE speaker)
|
| D | Channel-Mapping-API.txt | 20 corresponds to which (speaker) position. Thus, applications applied
25 Also, some devices such as HDMI are configurable for different speaker
|
| D | HD-Audio-Models.txt | 70 no-primary-hp VAIO Z/VGC-LN51JGB workaround (for fixed speaker DAC)
295 hp-envy-bass Pin fixup for HP Envy bass speaker (NID 0x0f)
296 hp-envy-ts-bass Pin fixup for HP Envy TS bass speaker (NID 0x10)
|
| D | HD-Audio.txt | 212 silent output from either or both of a built-in speaker and a
214 first. A speaker output often requires more additional controls like
224 Ditto for the speaker output. There can be "External Amplifier"
227 Another related problem is the automatic mute of speaker output by
239 - The speaker (and the headphone, too) output often requires the
|
| D | Audigy-mixer.txt | 182 This control is used to attenuate sample for center speaker of this mix.
187 This control is used to attenuate sample for LFE speaker of this mix.
|
| D | CMIPCI.txt | 90 There are some control switches affecting to the speaker connections:
|
| /linux-4.4.14/sound/drivers/ |
| D | Kconfig | 42 driver for the PC speaker which allows it to act like a primitive
51 pc-speaker a default sound device. Which is likely not
57 You don't need this driver if you only want your pc-speaker to beep.
59 in your PC instead of the real speaker.
|
| /linux-4.4.14/Documentation/sound/alsa/soc/ |
| D | jack.txt | 24 systems won't be able to use their speaker output while a headphone is
25 connected and so will want to make sure to update both speaker and
|
| D | dapm.txt | 247 e.g. connects the speaker out codec pins to the internal speaker.
249 /* ext speaker connected to codec pins LOUT2, ROUT2 */
280 /* turn speaker amplifier on/off depending on use */
|
| D | machine.txt | 86 of speaker/HP amplifiers, etc. Codec pins can be connected to the machines jack
|
| D | overview.txt | 50 (e.g. volume control for speaker amplifier).
|
| D | DPCM.txt | 98 4) Machine driver or audio HAL enables the speaker path.
|
| /linux-4.4.14/include/uapi/linux/ |
| D | telephony.h | 91 speaker enumerator
|
| /linux-4.4.14/Documentation/hwmon/ |
| D | gl518sm | 62 computer speaker. It is possible to enable all beeping globally, or only the
|
| D | w83791d | 84 The w83791d has a global bit used to enable beeping from the speaker when an
|
| D | w83781d | 122 your computer speaker. It is possible to enable all beeping globally,
|
| /linux-4.4.14/drivers/net/hamradio/ |
| D | Kconfig | 10 input and speaker output).
26 microphone input and speaker output). This protocol can be used as
|
| /linux-4.4.14/sound/soc/codecs/ |
| D | Kconfig | 630 tristate "STA326, STA328 and STA329 speaker amplifier"
635 tristate "STA350 speaker amplifier"
652 tristate "Texas Instruments TAS5086 speaker amplifier"
|
| /linux-4.4.14/Documentation/input/ |
| D | input.txt | 109 However, USB uses HID also for monitor controls, speaker controls, UPSs,
112 The monitor and speaker controls should be easy to add to the hid/input
|
| /linux-4.4.14/net/ax25/ |
| D | Kconfig | 31 microphone input and speaker output) supporting the KISS protocol or
|
| /linux-4.4.14/Documentation/gpio/ |
| D | drivers-on-gpio.txt | 29 an external speaker connected to a GPIO line.
|
| /linux-4.4.14/arch/arm/boot/dts/ |
| D | imx6qdl-nitrogen6_max.dtsi | 219 speaker-enable {
|
| D | omap3-n900.dts | 137 speaker-amplifier-gpios = <&twl_gpio 7 GPIO_ACTIVE_HIGH>;
|
| /linux-4.4.14/Documentation/usb/ |
| D | proc_usb_info.txt | 225 speaker with an audio interface for playback, and a HID interface
|
| /linux-4.4.14/Documentation/sound/oss/ |
| D | README.OSS | 1020 only recording level. Mixer control "speaker" is used to control volume of
1021 microphone signal connected directly to line/speaker out. So just decrease
1022 volume of "speaker" if you have problems with microphone feedback.
|
| /linux-4.4.14/Documentation/DocBook/ |
| D | gpu.xml.db | 420 API-drm-edid-to-speaker-allocation
|
| /linux-4.4.14/Documentation/virtual/kvm/ |
| D | timekeeping.txt | 46 speaker. Now the PIT is typically integrated as part of an emulated chipset
|
| D | api.txt | 2185 #define KVM_PIT_SPEAKER_DUMMY 1 /* emulate speaker port stub */
|
| /linux-4.4.14/Documentation/scsi/ |
| D | ncr53c8xx.txt | 138 I am not a native speaker of English and there are probably lots of
|
| /linux-4.4.14/ |
| D | CREDITS | 426 D: Updated PC speaker driver for 2.3
|
| /linux-4.4.14/Documentation/ |
| D | devices.txt | 1969 115 char TI link cable devices (115 was formerly the console driver speaker)
|
| D | kernel-parameters.txt | 376 s3_beep is for debugging; it makes the PC's speaker beep
|