Searched refs:pulses (Results 1 – 15 of 15) sorted by relevance
| /linux-4.4.14/drivers/leds/ |
| D | leds-lt3593.c | 37 int pulses; in lt3593_led_work() local
55 pulses = 32 - (led_dat->new_level * 32) / 255; in lt3593_led_work()
57 if (pulses == 0) { in lt3593_led_work()
66 while (pulses--) { in lt3593_led_work()
|
| /linux-4.4.14/Documentation/input/ |
| D | walkera0701.txt | 16 pulses from processor to HF part can be found at pin 2 of this connector,
18 modulation pulses to PC, signal pulses must be amplified.
56 Signal pulses:
80 (Warning, pulses on ACK are inverted by transistor, irq is raised up on sync
86 values can be sampled between sync pulses.
|
| /linux-4.4.14/drivers/net/wireless/ath/ |
| D | dfs_pri_detector.c | 163 struct list_head *l = &pde->pulses; in pulse_queue_get_tail()
216 list_add(&p->head, &pde->pulses); in pulse_queue_enqueue()
229 list_for_each_entry(p, &pde->pulses, head) { in pseq_handler_create_sequences()
258 list_for_each_entry_continue(p2, &pde->pulses, head) { in pseq_handler_create_sequences()
367 list_for_each_entry_safe(p, p0, &pde->pulses, head) { in pri_detector_reset()
430 INIT_LIST_HEAD(&de->pulses); in pri_detector_init()
|
| D | dfs_pri_detector.h | 69 struct list_head pulses; member
|
| /linux-4.4.14/Documentation/hwmon/ |
| D | g762 | 18 hardware characteristics of the system (reference clock, pulses per
32 fan1_pulses: number of pulses per fan revolution. Supported values
62 system: a reference clock source frequency, a number of pulses per fan
|
| D | g760a | 19 consecutive speed pulses. The period is defined in terms of clock
|
| D | dme1737 | 140 to the number of pulses per fan revolution that the connected tachometer
142 that generate 2 pulses per revolution. Fan inputs 5-6 also provide a max
265 number of pulses per revolution that
|
| D | smsc47b397 | 71 The SIO counts the number of 90kHz (11.111us) pulses per revolution.
|
| D | sysfs-interface | 213 fan[1-*]_pulses Number of tachometer pulses per fan revolution.
220 the number of pulses. In the absence of such a register (and
221 thus attribute) the value assumed by all devices is 2 pulses
|
| D | lm85 | 220 The number of pulses-per-rev of the fans can be set, Tach monitoring
|
| /linux-4.4.14/drivers/leds/trigger/ |
| D | Kconfig | 26 This allows LEDs to blink in one-shot pulses with parameters
|
| /linux-4.4.14/Documentation/devicetree/bindings/bus/ |
| D | ti-gpmc.txt | 65 - gpmc,cycle2cycle-delay-ns: Delay between chip-select pulses
|
| /linux-4.4.14/drivers/media/rc/ |
| D | Kconfig | 300 Note that this device can only record bursts of 36 IR pulses and
344 wave and pulses.
|
| /linux-4.4.14/Documentation/fb/ |
| D | framebuffer.txt | 210 influenced by the moments at which the synchronization pulses occur.
|
| /linux-4.4.14/drivers/pwm/ |
| D | Kconfig | 6 In Pulse-Width Modulation, a variation of the width of pulses
|