| /linux-4.4.14/Documentation/devicetree/bindings/input/ |
| D | da9062-onkey.txt | 17 - dlg,disable-key-power : Disable power-down using a long key-press. If this
19 press. If this entry does not exist then by default the key-press
|
| D | ti,palmas-pwrbutton.txt | 17 - ti,palmas-long-press-seconds: Duration in seconds which the power
23 a press for debouncing purposes. NOTE: This depends on specific
33 ti,palmas-long-press-seconds = <12>;
|
| D | e3x0-button.txt | 15 - "press", "release": For devices such as the NI Ettus Research USRP E3x0
24 interrupt-names = "press", "release";
|
| D | omap-keypad.txt | 6 The keypad controller can sense a key-press and key-release and report the
|
| D | twl4030-keypad.txt | 6 The keypad controller can sense a key-press and key-release and report the
|
| D | qcom,pm8xxx-pwrkey.txt | 21 and the second interrupt specifies the key press interrupt.
|
| D | ti,nspire-keypad.txt | 23 a key press).
|
| D | gpio-matrix-keypad.txt | 6 keypad can sense a key-press and key-release by means of GPIO lines and
|
| D | samsung-keypad.txt | 6 The keypad controller can sense a key-press and key-release and report the
|
| D | brcm,bcm-keypad.txt | 6 The keypad controller can sense a key-press and key-release and report the
|
| /linux-4.4.14/Documentation/devicetree/bindings/iio/ |
| D | st-sensors.txt | 57 - st,lps001wp-press
58 - st,lps25h-press
59 - st,lps331ap-press
|
| /linux-4.4.14/drivers/hid/ |
| D | hid-elo.c | 54 int press; in elo_process_data() local
59 press = 0; in elo_process_data()
61 press = (data[7] << 8) | data[6]; in elo_process_data()
62 input_report_abs(input, ABS_PRESSURE, press); in elo_process_data()
|
| D | hid-icade.c | 130 u8 press:1; member
186 trans->to, trans->press); in icade_event()
|
| /linux-4.4.14/Documentation/devicetree/bindings/mfd/ |
| D | da9063.txt | 61 - dlg,disable-key-power : Disable power-down using a long key-press. If this
63 press. If this entry does not exist then by default the key-press
|
| /linux-4.4.14/Documentation/ABI/obsolete/ |
| D | sysfs-driver-hid-roccat-pyra | 5 press of a button.
52 press of a button. A profile is split in settings and buttons.
67 press of a button. A profile is split in settings and buttons.
79 press of a button. A profile is split in settings and buttons.
95 press of a button. A profile is split in settings and buttons.
|
| D | sysfs-driver-hid-roccat-kovaplus | 66 press of a button. A profile is split in settings and buttons.
81 press of a button. A profile is split in settings and buttons.
93 press of a button. A profile is split in settings and buttons.
109 press of a button. A profile is split in settings and buttons.
|
| D | sysfs-driver-hid-roccat-savu | 5 press of a button. A profile is split into general settings and
28 press of a button. A profile is split into general settings and
62 press of a button. profile holds number of actual profile.
|
| D | sysfs-driver-hid-roccat-koneplus | 59 press of a button. A profile is split in settings and buttons.
74 press of a button. A profile is split in settings and buttons.
86 press of a button. A profile is split in settings and buttons.
102 press of a button. A profile is split in settings and buttons.
|
| D | sysfs-driver-hid-roccat-konepure | 5 press of a button. actual_profile holds number of actual profile.
44 press of a button. A profile is split in settings and buttons.
59 press of a button. A profile is split in settings and buttons.
|
| D | sysfs-driver-hid-roccat-ryos | 13 press of a button. profile holds index of actual profile.
|
| /linux-4.4.14/drivers/iio/pressure/ |
| D | Makefile | 7 obj-$(CONFIG_HID_SENSOR_PRESS) += hid-sensor-press.o
|
| D | Kconfig | 31 will be called hid-sensor-press.
|
| /linux-4.4.14/Documentation/ABI/testing/ |
| D | sysfs-firmware-acpi | 181 # press the power button for 3 times;
187 # press the power button for 3 times;
197 # press the power button for 3 times;
201 # press the power button for 3 times;
|
| D | sysfs-driver-hid-roccat-kone | 5 press of a button.
43 press of a button. A profile holds information like button
|
| D | sysfs-driver-hid-lenovo | 4 …ouse clicks should be generated if the trackpoint is quickly pressed. How fast this press has to be
|
| /linux-4.4.14/Documentation/devicetree/bindings/sound/ |
| D | ts3a227e.txt | 6 handles key press detection in accordance with the Android audio
|
| D | nau8825.txt | 63 - nuvoton,short-key-debounce: Button short key press debounce time.
|
| D | da7219.txt | 46 - dlg,btn-cfg : Periodic button press measurements for 4-pole jack (ms)
|
| /linux-4.4.14/drivers/input/touchscreen/ |
| D | usbtouchscreen.c | 120 int touch, press; member
286 dev->press = (tmp > 0 ? tmp : 0); in e2i_read_data()
513 dev->press = ((pkt[2] & 0x01) << 7) | (pkt[5] & 0x7F); in itm_read_data()
744 dev->press = pkt[5] & 0xff; in general_touch_read_data()
1063 dev->press = pkt[6]; in elo_read_data()
1323 input_report_abs(usbtouch->input, ABS_PRESSURE, usbtouch->press); in usbtouch_process_pkt()
|
| /linux-4.4.14/Documentation/ |
| D | sysrq.txt | 43 On x86 - You press the key combo 'ALT-SysRq-<command key>'. Note - Some
47 have better luck with "press Alt", "press SysRq", "release SysRq",
48 "press <command key>", release everything.
50 On SPARC - You press 'ALT-STOP-<command key>', I believe.
|
| D | braille-console.txt | 20 mode). To review previous messages, press the Insert key to switch to the VT
|
| D | svga.txt | 44 to continue or wait 30 secs" message. If you press <RETURN>, you enter the
45 menu, if you press <SPACE> or wait 30 seconds, the kernel will boot up in
71 you wish to set and press <RETURN>. If the computer complains something about
73 a mode. It's also possible to press only <RETURN> which leaves the current mode.
|
| D | debugging-via-ohci1394.txt | 173 After having attached to the debug target, press Ctrl-D to view the
|
| /linux-4.4.14/drivers/input/mouse/ |
| D | synaptics.h | 197 bool press; member
|
| D | synaptics.c | 746 priv->press = priv->report_press = false; in synaptics_parse_hw_state()
756 if (!priv->press) { in synaptics_parse_hw_state()
758 priv->press = true; in synaptics_parse_hw_state()
765 priv->press = false; in synaptics_parse_hw_state()
|
| /linux-4.4.14/Documentation/input/ |
| D | notifier.txt | 8 - 'down' is 1 for a key press event, 0 for a key release;
|
| D | input-programming.txt | 115 routine isn't reporting two same value events (press, press for example) to
|
| D | atarikbd.txt | 24 keyboard scan codes for each key press and release. The key scan make (key
216 ; mss=0xy, mouse button press or release causes mouse
218 ; where y=1, mouse key press causes absolute report
288 POSITIONING mode unless the ikbd has been commanded to report on button press
|
| D | gamepad.txt | 52 Analog-sticks may also provide a digital button if you press them.
|
| D | joystick-api.txt | 89 For a button, ``value'' for a press button event is 1 and for a release
|
| D | event-codes.txt | 312 the primary button press. BTN_{MIDDLE,RIGHT,4,5,etc.} should be used to report
|
| D | joystick.txt | 122 move the stick, and press its buttons. The axes should all be zero when the
|
| /linux-4.4.14/Documentation/video4linux/bttv/ |
| D | README.WINVIEW | 8 when I get time (it simple generates an interrupt for each key press, with
|
| /linux-4.4.14/Documentation/laptops/ |
| D | thinkpad-acpi.txt | 296 press to unmute, as per the ThinkPad volume mixer user
314 single key press, or to not even be detected at all.
437 press events until a S3 or S4
487 For these keys, the driver generates a set of events for a key press and
490 hot key press or release, but the firmware will do it for either one, not
706 0 - Related to "Volume down" key press
707 1 - Related to "Volume up" key press
708 2 - Related to "Mute on" key press
709 3 - Related to "Access IBM" key press
710 4 - Related to "LCD brightness up" key press
[all …]
|
| /linux-4.4.14/arch/arm/boot/dts/ |
| D | ste-href-tvk1281618.dtsi | 125 compatible = "st,lps001wp-press";
|
| D | ste-snowball.dts | 301 compatible = "st,lps001wp-press";
|
| D | am57xx-beagle-x15.dts | 551 ti,palmas-long-press-seconds = <12>;
|
| D | dra72-evm.dts | 418 ti,palmas-long-press-seconds = <6>;
|
| /linux-4.4.14/drivers/input/misc/ |
| D | keyspan_remote.c | 175 static void keyspan_report_button(struct usb_keyspan *remote, int button, int press) in keyspan_report_button() argument
180 input_report_key(input, remote->keymap[button], press); in keyspan_report_button()
|
| D | adxl34x.c | 279 struct adxl34x_platform_data *pdata, int status, int press) in adxl34x_send_key_events() argument
286 pdata->ev_code_tap[i], press); in adxl34x_send_key_events()
|
| D | Kconfig | 741 in Linux, after you press the onkey, system will suspend.
|
| /linux-4.4.14/drivers/staging/speakup/ |
| D | spkguide.txt | 139 bootup messages, just press the keypad enter key. This key is located
141 that way, until you press another key.
145 effect of starting Speakup talking again, so you can press keypad enter
172 keypad 5 -- read current word (press twice rapidly to spell the current word)
175 keypad 8 -- read current line (press twice rapidly to hear how much the
183 do under DOS or Windows, you hold it like a shift key, and press other
195 In order to enter the Speakup help system, press and hold the speakup
196 key (remember that this is the keypad insert key), and press the f1 key.
202 When you press the spacebar to leave the help system, you will hear:
209 commands in a specific part of the alphabet, you may press the letter of
[all …]
|
| /linux-4.4.14/arch/metag/mm/ |
| D | Kconfig | 77 If the bootloader enables the L2 you must press y here to ensure the
|
| /linux-4.4.14/arch/x86/boot/ |
| D | header.S | 75 # Allow the user to press a key, then reboot
|
| /linux-4.4.14/Documentation/acpi/ |
| D | video_extension.txt | 80 ii) For some laptops, the press of the hotkey will not generate the
|
| /linux-4.4.14/Documentation/gpio/ |
| D | drivers-on-gpio.txt | 17 can generate interrupts in response to a key press. Also supports debounce.
|
| /linux-4.4.14/drivers/staging/panel/ |
| D | panel.c | 2094 static struct logical_input *panel_bind_key(const char *name, const char *press, in panel_bind_key() argument
2115 strncpy(key->u.kbd.press_str, press, sizeof(key->u.kbd.press_str)); in panel_bind_key()
|
| /linux-4.4.14/Documentation/power/ |
| D | basic-pm-debugging.txt | 33 (it is similar to the "reboot" mode, but it requires you to press the power
|
| /linux-4.4.14/Documentation/scsi/ |
| D | BusLogic.txt | 335 Configuration", "View/Modify Configuration", press Ctrl-F10, and then change
|
| /linux-4.4.14/drivers/platform/x86/ |
| D | Kconfig | 479 the hot key press events. If you know your ThinkPad model does not
|
| /linux-4.4.14/Documentation/sound/oss/ |
| D | README.OSS | 947 switch off power or press the reset button.
|
| /linux-4.4.14/Documentation/s390/ |
| D | Debugging390.txt | 1512 filel & press F11 to look at it
|