Searched refs:port3 (Results 1 – 11 of 11) sorted by relevance
| /linux-4.4.14/include/uapi/linux/ |
| D | serial.h | 88 int port3; member
|
| /linux-4.4.14/include/sound/ |
| D | emu8000.h | 71 unsigned long port3; /* Port usually at base+0x800 */ member
|
| D | emu8000_reg.h | 32 #define EMU8000_DATA3(e) ((e)->port3)
33 #define EMU8000_PTR(e) ((e)->port3+2)
|
| /linux-4.4.14/Documentation/devicetree/bindings/usb/ |
| D | pxa-usb.txt | 10 - "marvell,enable-port1", "marvell,enable-port2", "marvell,enable-port3"
|
| /linux-4.4.14/sound/isa/sb/ |
| D | emu8000.c | 1108 hw->port3 = port + 0x800; in snd_emu8000_new()
1111 !(hw->res_port3 = request_region(hw->port3, 4, "Emu8000-3"))) { in snd_emu8000_new()
1112 …_printk(KERN_ERR "sbawe: can't grab ports 0x%lx, 0x%lx, 0x%lx\n", hw->port1, hw->port2, hw->port3); in snd_emu8000_new()
|
| /linux-4.4.14/Documentation/devicetree/bindings/mfd/ |
| D | omap-usb-host.txt | 98 port3-mode = "ehci-phy";
|
| /linux-4.4.14/Documentation/devicetree/bindings/net/ |
| D | keystone-netcp.txt | 78 - sgmii port3/4 module registers (only for NetCP 1.4)
84 index #1 - sgmii port3/4 module registers
|
| /linux-4.4.14/arch/arm/boot/dts/ |
| D | omap5-board-common.dtsi | 624 port3-mode = "ehci-hsic";
|
| D | omap5-cm-t54.dts | 626 port3-mode = "ehci-hsic";
|
| /linux-4.4.14/Documentation/networking/ |
| D | bonding.txt | 2157 |port3 port3|
2170 the outside world ("port3" on each switch). There is no technical
2201 example, in the above example, if the "port3" link fails at the remote
2203 monitor could be configured with a target at the remote end of port3,
2274 | Host A +------------+ switch |port3 +--------+
|
| /linux-4.4.14/drivers/net/ethernet/chelsio/cxgb3/ |
| D | t3_hw.c | 593 VPD_ENTRY(port3, 2); /* PHY3 complex */
|