Searched refs:no_sync (Results 1 – 13 of 13) sorted by relevance
113 goto no_sync; in mesh_sync_offset_rx_bcn_presp()125 goto no_sync; in mesh_sync_offset_rx_bcn_presp()147 goto no_sync; in mesh_sync_offset_rx_bcn_presp()163 no_sync: in mesh_sync_offset_rx_bcn_presp()
91 hdata->no_sync = 0xff; in mvme147_detect()
257 uchar no_sync; /* bitmask: don't do sync on these targets */ member
916 if (hostdata->no_sync & (1 << cmd->device->id)) { in wd33c93_intr()1996 hostdata->no_sync = val; in wd33c93_init()2045 hostdata->microcode, hostdata->no_sync, hostdata->no_dma); in wd33c93_init()2115 set_resync(hd, x ^ hd->no_sync); in wd33c93_write_info()2116 hd->no_sync = x; in wd33c93_write_info()2145 hd->clock_freq, hd->no_sync, hd->no_dma, hd->dma_mode, hd->fast); in wd33c93_show_info()
211 hdata->wh.no_sync = 0xff; in a2091_probe()
230 hdata->wh.no_sync = 0xff; in amiga_a3000_scsi_probe()
266 hdata->wh.no_sync = 0; in sgiwd93_probe()
346 hdata->wh.no_sync = 0xff; in gvp11_probe()
1005 uint32_t no_sync:1; member
1236 if (driver_setup.no_sync || in qla1280_slave_configure()4148 driver_setup.no_sync = 1; in qla1280_setup()
270 static inline bool no_sync(struct v4l2_subdev *sd) in no_sync() function322 if (no_sync(sd)) { in tc358743_get_detected_timings()946 if (no_sync(sd) || no_signal(sd)) { in tc358743_hdmi_misc_int_handler()1023 if (!no_signal(sd) && !no_sync(sd)) in tc358743_hdmi_clk_int_handler()1075 if (no_sync(sd) || no_signal(sd)) { in tc358743_hdmi_sys_int_handler()1350 *status |= no_sync(sd) ? V4L2_IN_ST_NO_SYNC : 0; in tc358743_g_input_status()
2397 goto no_sync; in ocfs2_file_write_iter()2419 no_sync: in ocfs2_file_write_iter()
261 - 'no_sync' changed to 'no_disc' in the README file. This is an old