| /linux-4.4.14/arch/x86/oprofile/ |
| D | nmi_int.c | 156 kfree(per_cpu(cpu_msrs, i).multiplex); in nmi_shutdown_mux()
157 per_cpu(cpu_msrs, i).multiplex = NULL; in nmi_shutdown_mux()
172 per_cpu(cpu_msrs, i).multiplex = in nmi_setup_mux()
174 if (!per_cpu(cpu_msrs, i).multiplex) in nmi_setup_mux()
184 struct op_msr *multiplex = msrs->multiplex; in nmi_cpu_setup_mux() local
191 multiplex[i].saved = -(u64)counter_config[i].count; in nmi_cpu_setup_mux()
193 multiplex[i].saved = 0; in nmi_cpu_setup_mux()
203 struct op_msr *multiplex = msrs->multiplex; in nmi_cpu_save_mpx_registers() local
209 rdmsrl(counters[i].addr, multiplex[virt].saved); in nmi_cpu_save_mpx_registers()
216 struct op_msr *multiplex = msrs->multiplex; in nmi_cpu_restore_mpx_registers() local
[all …]
|
| D | op_x86_model.h | 26 struct op_msr *multiplex; member
|
| /linux-4.4.14/drivers/video/fbdev/ |
| D | s3fb.c | 605 u32 value, mode, hmul, offset_value, screen_size, multiplex, dbytes; in s3fb_set_par() local
754 multiplex = 0; in s3fb_set_par()
809 multiplex = 1; in s3fb_set_par()
826 multiplex = 1; in s3fb_set_par()
854 multiplex = 1; in s3fb_set_par()
884 svga_wseq_mask(par->state.vgabase, 0x15, multiplex ? 0x10 : 0x00, 0x10); in s3fb_set_par()
885 svga_wseq_mask(par->state.vgabase, 0x18, multiplex ? 0x80 : 0x00, 0x80); in s3fb_set_par()
|
| /linux-4.4.14/Documentation/devicetree/bindings/phy/ |
| D | qcom,usb-8x16-phy.txt | 54 controlled by GPIO to de/multiplex D+/D- USB lines
|
| /linux-4.4.14/Documentation/devicetree/bindings/dma/ |
| D | fsl-edma.txt | 3 The eDMA channels have multiplex capability by programmble memory-mapped
|
| /linux-4.4.14/drivers/input/serio/ |
| D | i8042.c | 616 static int i8042_set_mux_mode(bool multiplex, unsigned char *mux_version) in i8042_set_mux_mode() argument
634 param = val = multiplex ? 0x56 : 0xf6; in i8042_set_mux_mode()
637 param = val = multiplex ? 0xa4 : 0xa5; in i8042_set_mux_mode()
|
| /linux-4.4.14/Documentation/devicetree/bindings/usb/ |
| D | msm-hsusb.txt | 56 SPDT USB Switch, witch is cotrolled by GPIO to de/multiplex
|
| /linux-4.4.14/Documentation/devicetree/bindings/bus/ |
| D | ti-gpmc.txt | 88 - gpmc,wr-data-mux-bus-ns: In address-data multiplex mode, specifies
|
| /linux-4.4.14/Documentation/ |
| D | pinctrl.txt | 20 can control PINs. It may be able to multiplex, bias, set load capacitance,
818 multiplex
822 whether the pin is used for GPIO or not. If you multiplex a GPIO onto a
848 multiplex
855 possible that the GPIO, pin config and pin multiplex registers are placed into
|
| D | devices.txt | 131 master multiplex (/dev/ptmx) to acquire a PTY on
241 2 = /dev/ptmx PTY master multiplex
258 they are redirected through the parport multiplex layer.
|
| /linux-4.4.14/arch/powerpc/platforms/ |
| D | Kconfig | 72 cpu. This will enable the generic code to multiplex the 4
|
| /linux-4.4.14/Documentation/devicetree/bindings/pinctrl/ |
| D | samsung-pinctrl.txt | 5 and also provides ability to multiplex and configure the output of various
|
| /linux-4.4.14/Documentation/networking/ |
| D | can.txt | 33 4.2.6 Broadcast Manager multiplex message receive filter
815 4.2.6 Broadcast Manager multiplex message receive filter
817 To filter for content changes in multiplex message sequences an array of more
823 Up to 257 CAN frames (multiplex filter bit mask CAN frame plus 256 CAN
|
| D | rxrpc.txt | 315 AF_RXRPC makes use of control messages in sendmsg() and recvmsg() to multiplex
|
| /linux-4.4.14/Documentation/hid/ |
| D | hid-transport.txt | 91 multiplex all four on a single physical channel. However, in this document we
|
| /linux-4.4.14/Documentation/vm/ |
| D | cleancache.txt | 120 multiplex physical resources across the varying demands of multiple
|
| D | frontswap.txt | 102 multiplex physical resources across the varying demands of multiple
|
| /linux-4.4.14/Documentation/filesystems/cifs/ |
| D | CHANGES | 351 specified. Ensure multiplex ids do not collide. Fix case in which
507 is the usual maximum active multiplex SMB/CIFS requests per server).
545 Change to mempools for alloc smb request buffers and multiplex structs
|
| /linux-4.4.14/tools/perf/Documentation/ |
| D | perf-script-python.txt | 103 system-wide and multiplex the per-cpu output into a single stream.
|
| /linux-4.4.14/Documentation/scsi/ |
| D | ChangeLog.megaraid | 561 multiplex command to low level RAID module(s).
|
| /linux-4.4.14/Documentation/powerpc/ |
| D | hvcs.txt | 432 Q: How do I multiplex a console that I grab through hvcs so that other
|
| /linux-4.4.14/Documentation/gpio/ |
| D | gpio-legacy.txt | 156 that board setup code probably needs to multiplex that pin as a GPIO,
|
| /linux-4.4.14/Documentation/s390/ |
| D | Debugging390.txt | 1421 and control lines on the "Tag" cable. These can operate in byte multiplex mode
|