Searched refs:headphone (Results 1 – 23 of 23) sorted by relevance
/linux-4.4.14/Documentation/sound/alsa/ |
D | HD-Audio-Controls.txt | 15 headphone and line-out jacks. If built-in speakers and headphone 22 When both headphone and line-out jacks are present, it gives 24 speaker-only is chosen, plugging into a headphone or a line-out jack 26 selected, plugging to a headphone jack mutes both speakers and 46 When this control is ON, treat the headphone jacks as line-out 47 jacks. That is, the headphone won't auto-mute the other line-outs, 66 When this enum control is enabled, the headphone output is routed 68 the primary stream. In the case the headphone DAC is shared with a 69 side or a CLFE-channel DAC, the DAC is switched to the headphone 75 the front-channel. Also, the same route is used for the headphone [all …]
|
D | ControlNames.txt | 47 Headset Mic (mic part of combined headset jack - 4-pin headphone + mic) 48 Headphone Mic (mic part of either/or - 3-pin headphone or mic)
|
D | HD-Audio-Models.txt | 5 3stack 3-jack in back and a headphone out 35 headset-mic Indicates a combined headset (headphone+mic) jack 37 headset-mode-no-hp-mic Headset mode support without headphone mic
|
D | HD-Audio.txt | 213 headphone jack. In general, you should try a headphone output at 215 the external amplifier bits. Thus a headphone output has a slightly 228 headphone plugging. This feature is implemented in most cases, but 239 - The speaker (and the headphone, too) output often requires the 448 - auto_mute (bool): enable/disable the headphone auto-mute feature; 455 - primary_hp (bool): probe headphone jacks as the primary outputs; 462 - indep_hp (bool): provide the independent headphone PCM stream and 467 I/O jack for allowing to change the headphone amp and mic bias VREF 474 - add_hp_mic (bool): add the headphone to capture source if possible
|
D | SB-Live-mixer.txt | 238 This control attenuates the samples for the headphone output. 243 left headphone output (useful for SB Live cards without separate center/LFE 249 right headphone output (useful for SB Live cards without separate center/LFE
|
D | ALSA-Configuration.txt | 2133 - swap_hp Swap headphone and master controls 2135 - ad_sharing For AD1985, turn on OMS bit and use headphone
|
/linux-4.4.14/Documentation/sound/alsa/soc/ |
D | jack.txt | 15 headphone outputs if no headphones are present). 23 mechanisms, one for the headphone and one for the microphone. Some 24 systems won't be able to use their speaker output while a headphone is 26 headphone when the headphone jack status changes.
|
/linux-4.4.14/Documentation/devicetree/bindings/sound/ |
D | nokia,rx51.txt | 8 - nokia,headphone-amplifier: phandle for the TPA6130A2 node 21 nokia,headphone-amplifier = <&tpa6130a2>;
|
D | sirf-audio.txt | 10 headphone amplifier.
|
D | imx-audio-es8328.txt | 7 - jack-gpio : Optional GPIO for headphone jack
|
D | rt5645.txt | 16 a GPIO spec for the external headphone detect pin. If jd-mode = 0,
|
D | nvidia,tegra-audio-rt5677.txt | 31 - nvidia,hp-en-gpios : The GPIO that enables headphone amplifier
|
/linux-4.4.14/sound/ppc/ |
D | Kconfig | 24 bool "Toggle DRC automatically at headphone/line plug-in" 31 headphone/line jack is plugged, and turned on when unplugged.
|
D | tumbler.c | 975 int headphone, lineout; in device_change_handler() local 984 headphone = tumbler_detect_headphone(chip); in device_change_handler() 987 DBG("headphone: %d, lineout: %d\n", headphone, lineout); in device_change_handler() 989 if (headphone || lineout) { in device_change_handler() 991 if (headphone) in device_change_handler() 1018 mix->drc_enable = ! (headphone || lineout); in device_change_handler()
|
/linux-4.4.14/Documentation/devicetree/bindings/extcon/ |
D | extcon-arizona.txt | 15 headphone detection mode is set to HPDETL.
|
/linux-4.4.14/sound/aoa/core/ |
D | gpio-pmf.c | 34 PMF_GPIO(headphone, 0);
|
D | gpio-feature.c | 159 FTR_GPIO(headphone, 0);
|
/linux-4.4.14/sound/aoa/fabrics/ |
D | layout.c | 661 AMP_CONTROL(headphone, "Headphone Switch");
|
/linux-4.4.14/sound/soc/codecs/ |
D | Kconfig | 915 tristate "Texas Instruments TPA6130A2 headphone amplifier"
|
/linux-4.4.14/arch/arm/boot/dts/ |
D | omap3-n900.dts | 132 nokia,headphone-amplifier = <&tpa6130a2>;
|
/linux-4.4.14/Documentation/laptops/ |
D | thinkpad-acpi.txt | 1055 console headphone and speakers. This circuit is after the main AC97 1077 amplifiers driving the speakers and headphone output, and the firmware 1078 also handles volume control for the headphone and speakers on these
|
/linux-4.4.14/sound/pci/ |
D | Kconfig | 299 mapped headphone out to master output. If that works for you,
|
/linux-4.4.14/drivers/platform/x86/ |
D | Kconfig | 390 (headphone and speakers), which is operated by the mute and (in
|