Searched refs:ethX (Results 1 – 14 of 14) sorted by relevance
| /linux-4.4.14/arch/m68k/emu/ |
| D | nfeth.c | 60 int ethX; member
70 res = nf_call(nfEtherID + XIF_START, priv->ethX); in nfeth_open()
86 nf_call(nfEtherID + XIF_STOP, priv->ethX); in nfeth_stop()
101 pktlen = nf_call(nfEtherID + XIF_READLENGTH, priv->ethX); in recv_packet()
122 nf_call(nfEtherID + XIF_READBLOCK, priv->ethX, virt_to_phys(skb->data), in recv_packet()
165 nf_call(nfEtherID + XIF_WRITEBLOCK, priv->ethX, virt_to_phys(data), in nfeth_xmit()
212 priv->ethX = unit; in nfeth_probe()
|
| /linux-4.4.14/drivers/net/wireless/libertas/ |
| D | README | 46 ethtool -e ethX [raw on|off] [offset N] [length N]
74 Path: /sys/kernel/debug/libertas_wireless/ethX/registers/
97 Path: /sys/kernel/debug/libertas_wireless/ethX/
117 Path: /sys/kernel/debug/libertas_wireless/ethX/subscribed_events/
167 Path: /sys/kernel/debug/libertas_wireless/ethX/
181 Path: /sys/kernel/debug/libertas_wireless/ethX/
190 Path: /sys/kernel/debug/libertas_wireless/ethX/
231 "ethtool -s ethX wol X" command before enabling host sleep.
233 Path: /sys/kernel/debug/libertas_wireless/ethX/
|
| /linux-4.4.14/Documentation/networking/ |
| D | s2io.txt | 36 To associate an interface with a physical adapter use "ethtool -p <ethX>".
118 # ethtool -K <ethX> tso on
127 c. Ensure Receive Checksum offload is enabled. Use "ethtool -K ethX" command to
|
| D | pktgen.txt | 22 /proc/net/pktgen/ethX
32 # ethtool -G ethX tx 1024
50 # ethtool -C ethX rx-usecs 30
229 Usage: ./pktgen_sample01_simple.sh [-vx] -i ethX
|
| D | ixgbe.txt | 139 ethtool -K ethX ntuple on
141 Use -U switch. e.g., ethtool -U ethX flow-type tcp4 src-ip 10.0.128.23
144 ethtool -u ethX
|
| D | altera_tse.txt | 89 ethtool -S ethX command. It is possible to dump registers etc.
115 e.g. using: ethtool -S ethX (that shows the statistics counters)
116 or sees the MAC registers: e.g. using: ethtool -d ethX
|
| D | stmmac.txt | 103 # ethtool -S ethX command
307 to get statistics: e.g. using: ethtool -S ethX
309 or sees the MAC/DMA registers: e.g. using: ethtool -d ethX
|
| D | README.ipw2200 | 390 The 'iwconfig ethX sens XX' command will not set the signal sensitivity
|
| D | bonding.txt | 1174 driver unless the ethX device is configured with an IP address.
1193 The DEVICE= line will be different for every ethX device and
1982 that the same physical device always has the same "ethX" name), it may
|
| /linux-4.4.14/Documentation/scsi/ |
| D | cxgb3i.txt | 63 iface.net_ifacename = <ethX>
67 same as the ethX's ip address or an address on the same subnet. Make
|
| /linux-4.4.14/samples/pktgen/ |
| D | README.rst | 18 Usage: ./pktgen_sample01_simple.sh [-vx] -i ethX
|
| /linux-4.4.14/drivers/net/ethernet/marvell/ |
| D | Kconfig | 102 The file /sys/kernel/debug/skge/ethX displays the state of the internal
137 The file /sys/kernel/debug/sky2/ethX displays the state of the internal
|
| /linux-4.4.14/drivers/net/usb/ |
| D | Kconfig | 182 This driver creates an interface named "ethX", where X depends on
200 This driver creates an interface named "ethX", where X depends on
226 This driver creates an interface named "ethX", where X depends on
240 This driver creates an interface named "ethX", where X depends on
|
| /linux-4.4.14/drivers/staging/unisys/Documentation/ |
| D | proc-entries.txt | 47 /proc/virtnic/ethX: This is a directory containing entries for each
|