Searched refs:autoprobe (Results 1 – 17 of 17) sorted by relevance
| /linux-4.4.14/drivers/net/ |
| D | Space.c | 46 static int __init probe_list2(int unit, struct devprobe2 *p, int autoprobe) in probe_list2() argument
50 if (autoprobe && p->status) in probe_list2()
55 if (autoprobe) in probe_list2()
|
| /linux-4.4.14/Documentation/sound/alsa/ |
| D | ALSA-Configuration.txt | 133 This module supports multiple cards. It does not support autoprobe, so
161 This module supports multiple cards, autoprobe and PnP.
172 This module supports multiple cards. It does not support autoprobe
196 This module supports one chip and autoprobe.
205 This module supports multiple cards, autoprobe and PnP.
226 This module supports multiple cards, autoprobe and PnP.
256 This module supports one card and autoprobe.
270 This module supports one card and autoprobe.
318 This module supports multiple cards. It does not support autoprobe: port,
352 This module supports multiple cards. It does not support autoprobe: port,
[all …]
|
| /linux-4.4.14/kernel/irq/ |
| D | Makefile | 4 obj-$(CONFIG_GENERIC_IRQ_PROBE) += autoprobe.o
|
| D | Kconfig | 12 # Enable the generic irq autoprobe mechanism
|
| /linux-4.4.14/drivers/block/paride/ |
| D | paride.c | 350 int pi_init(PIA * pi, int autoprobe, int port, int mode, in pi_init() argument
363 if (autoprobe) { in pi_init()
421 if (autoprobe) in pi_init()
|
| D | paride.h | 62 int autoprobe, /* 1 to autoprobe */
|
| /linux-4.4.14/Documentation/ |
| D | parport.txt | 102 | |-- autoprobe
117 |-- autoprobe
168 autoprobe Any IEEE-1284 device ID information that has been
171 autoprobe[0-3] IEEE 1284 device ID information retrieved from
|
| /linux-4.4.14/Documentation/scsi/ |
| D | g_NCR5380.txt | 58 (255 should be specified for no or DMA interrupt, 254 to autoprobe for an
|
| /linux-4.4.14/drivers/block/ |
| D | ataflop.c | 211 int autoprobe; /* !=0 : do autoprobe */ member
1089 if (SUD.autoprobe) { in fd_rwsec_done1()
1455 UD.autoprobe = 1; in redo_fd_request()
1473 UD.autoprobe = 0; in redo_fd_request()
|
| /linux-4.4.14/Documentation/isdn/ |
| D | README.act2000 | 52 p = portbase (-1 means autoprobe)
|
| /linux-4.4.14/Documentation/networking/ |
| D | ltpc.txt | 11 While the driver will attempt to autoprobe the I/O port address, IRQ
|
| D | arcnet.txt | 127 chipset driver which will autoprobe if not told where the card is.
134 To disable the autoprobe, just specify "com90xx=" on the kernel command line.
135 To specify the name alone, but allow autoprobe, just put "com90xx=<name>"
517 Starting with v2.40 ALPHA, the autoprobe routines have changed
|
| D | de4x5.txt | 50 achieved by letting the driver autoprobe as if it were compiled into the
|
| /linux-4.4.14/drivers/parport/ |
| D | Kconfig | 160 appear in /proc/sys/dev/parport/*/autoprobe*. It is safe to say N.
|
| /linux-4.4.14/Documentation/blockdev/ |
| D | paride.txt | 208 you have connected. By default, each driver will autoprobe for a single
|
| /linux-4.4.14/sound/oss/ |
| D | Kconfig | 257 Verbose soundcard initialization -- affects the format of autoprobe
|
| /linux-4.4.14/Documentation/filesystems/ |
| D | proc.txt | 1228 autoprobe Any IEEE-1284 device ID information that has been acquired.
|