Searched refs:arbitration (Results 1 – 18 of 18) sorted by relevance
| /linux-4.4.14/drivers/amba/ |
| D | Kconfig | 11 which controls AHB bus master arbitration and some performance
|
| /linux-4.4.14/drivers/i2c/muxes/ |
| D | Kconfig | 9 tristate "GPIO-based I2C arbitration"
14 I2C multimaster arbitration scheme using GPIOs and a challenge &
|
| /linux-4.4.14/Documentation/ |
| D | vgaarbiter.txt | 13 the legacy VGA arbitration task (besides other bus management tasks) when more
18 control bus resources. Therefore an arbitration scheme outside of the X server
39 scans all PCI devices and adds the VGA ones inside the arbitration. The
120 instance, if there is only one card, then it can completely escape arbitration.
156 card can be left out of the arbitration process (and can be safe to take
|
| /linux-4.4.14/arch/x86/include/asm/ |
| D | io_apic.h | 53 arbitration : 4, member
|
| /linux-4.4.14/Documentation/devicetree/bindings/spmi/ |
| D | qcom,spmi-pmic-arb.txt | 4 controller with wrapping arbitration logic to allow for multiple on-chip
|
| /linux-4.4.14/Documentation/video4linux/bttv/ |
| D | README.quirks | 80 parking, thus lowering arbitration performance. The Bt879 drivers must
|
| /linux-4.4.14/Documentation/video4linux/ |
| D | README.pvrusb2 | 38 tear-down, arbitration, and interaction with high level
132 (Policy, instantiation, and arbitration of pvrusb2 devices fall
|
| /linux-4.4.14/Documentation/networking/ |
| D | can.txt | 162 (can_id) is used for arbitration on the CAN-bus. Therefore the CAN-IDs
204 arbitration on the CAN bus the transmission of a low prio CAN-ID
226 arbitration problems and error frames caused by the different
379 bitrates for the arbitration phase and the payload phase of the CAN FD frame
1108 Shows the number of restarts, bus and arbitration lost errors,
1169 arbitration phase and the payload phase of the CAN FD frame. Therefore a
1192 at least the bitrate which was configured for the arbitration phase. This
1218 Example configuring 500 kbit/s arbitration bitrate and 4 Mbit/s data bitrate:
|
| /linux-4.4.14/Documentation/i2c/ |
| D | fault-codes | 39 Returned by I2C adapters when they lose arbitration in master
|
| /linux-4.4.14/Documentation/scsi/ |
| D | ChangeLog.ncr53c8xx | 134 - Definitely disable overlapped PCI arbitration for all dual
217 Disable overlapped arbitration. This will not make difference
425 having won arbitration, do some stuff prior to testing any SCSI
|
| D | ncr53c8xx.txt | 853 win arbitration and it has other commands to send to a device.
878 immediate arbitration disabled iarb:0
1017 every chance to win arbitration if only devices with lower priority are
1019 then it will for sure win the next SCSI BUS arbitration.
1024 the previous arbitration (boot option 'iarb:1').
1028 a) Allow the initiator with ID 7 to win arbitration when it wants so.
1029 b) Overlap at least 4 micro-seconds of arbitration time with the execution
|
| D | ChangeLog.sym53c8xx | 218 - Definitely disable overlapped PCI arbitration for all dual
464 - Disable overlapped PCI arbitration for the 896 revision 1.
588 the chip won arbitration, since executing SCRIPTS while the SCSI
|
| /linux-4.4.14/Documentation/blockdev/ |
| D | floppy.txt | 112 master arbitration error" messages from your Ethernet card (or
|
| /linux-4.4.14/Documentation/arm/ |
| D | cluster-pm-race-avoidance.txt | 441 mechanism to do this arbitration. This mechanism is documented in
|
| /linux-4.4.14/arch/x86/kernel/apic/ |
| D | io_apic.c | 1317 printk(KERN_DEBUG "....... : arbitration: %02X\n", reg_02.bits.arbitration); in print_IO_APIC()
|
| /linux-4.4.14/drivers/scsi/aic7xxx/ |
| D | aic7xxx.reg | 557 * After successful arbitration for the memory port, the SEECS bit of
|
| D | aic7xxx.seq | 54 * bus arbitration. The problem with this is that we must keep track of the
|
| /linux-4.4.14/drivers/scsi/ |
| D | Kconfig | 1625 This option increases the delay after a SCSI arbitration to
|