Home
last modified time | relevance | path

Searched refs:SW3 (Results 1 – 15 of 15) sorted by relevance

/linux-4.4.14/Documentation/devicetree/bindings/mfd/
Dmc13xxx.txt59 sw3 : regulator SW3 (register 29, bit 20)
88 sw3 : regulator SW3 (register 26, bit 0)
/linux-4.4.14/include/linux/mfd/
Dezx-pcap.h131 #define SW3 19 macro
/linux-4.4.14/arch/arm/boot/dts/
Dpm9g45.dts168 label = "SW3";
Dimx53-qsrb.dts66 regulator-name = "SW3";
Dr8a7740-armadillo800eva.dts87 label = "SW3";
Dimx28-eukrea-mbmx28lc.dtsi36 label = "SW3";
Dsh73a0-kzm9g.dts113 label = "SW3";
/linux-4.4.14/arch/avr32/boards/atstk1000/
DKconfig50 bool "SW3: use TIMER1 (not SSC0 and GCLK)"
/linux-4.4.14/drivers/regulator/
Dpcap-regulator.c142 VREG_INFO(SW3, PCAP_REG_SWCTRL, 11, 12, 24, NA),
Dmc13783-regulator.c257 MC13783_DEFINE_SW(SW3, SWITCHERS5, SWITCHERS5, mc13783_sw3_val),
Dltc3589.c232 LTC3589_LINEAR_REG(SW3, B3DTV1),
Dmc13892-regulator.c273 MC13892_SW_DEFINE(SW3, SWITCHERS2, SWITCHERS2, mc13892_sw),
Dpfuze100-regulator.c325 PFUZE3000_SW3_REG(PFUZE3000, SW3, PFUZE100_SW3AVOL, 900000, 1650000, 50000),
/linux-4.4.14/Documentation/networking/
Darcnet-hardware.txt804 SW3 1-8: Node ID Select
820 The eight switches in group SW3 are used to set the node ID. Each node
1942 SW3 1-5: IRQ Select
1952 The eight switches in SW3 are used to set the node ID. Each node attached
2013 *) To enable the Boot ROM set the switch 8 of switch block SW3 to position ON.
2021 Switches 1-5 of the switch block SW3 control the IRQ level.
2036 The switches 6-7 of the switch block SW3 are used to determine the timeout
2772 | SW3 | || | |
2791 SW3 1-5: IRQ Select
2797 Although the jumpers SW1 and SW3 are marked SW, not JP, they are jumpers, not
[all …]
Dltpc.txt78 SW3 IRQ 9 (2 in original card documentation only applies to XT)