| /linux-4.4.14/drivers/hsi/clients/ |
| D | Kconfig | 27 tristate "SSI protocol"
30 If you say Y here, you will enable the SSI protocol aka McSAAB.
35 tristate "HSI/SSI character driver"
38 If you say Y here, you will enable the HSI/SSI character driver.
40 serial communication with the cellular modem over HSI/SSI bus.
|
| /linux-4.4.14/Documentation/devicetree/bindings/sound/ |
| D | fsl,ssi.txt | 3 The SSI is a serial device that communicates with audio codecs. It can
13 - cell-index: The SSI, <0> = SSI1, <1> = SSI2, and so on.
32 If specified, the SSI is to be programmed in asynchronous
41 - clocks: "ipg" - Required clock for the SSI unit
42 "baud" - Required clock for SSI master mode. Otherwise this
51 codec connected to this SSI. This node is typically
55 where an incompatible codec is connected to this SSI, e.g.
62 "ac97-slave" - AC97 mode, SSI is clock slave
63 "ac97-master" - AC97 mode, SSI is clock master
74 On SOCs that have an SSI, specific DMA channels are hard-wired for playback
|
| D | renesas,rsnd.txt | 15 SRU/ADG/SSI if generation1
16 SRU/ADG/SSIU/SSI if generation2
17 - rcar_sound,ssi : Should contain SSI feature.
18 The number of SSI subnode should be same as HW.
41 SSI subnode properties:
42 - interrupts : Should contain SSI interrupt for PIO transfer
45 - no-busif : BUSIF is not ussed when [mem -> SSI] via DMA case
47 - dma-names : SSI case "rx" (=playback), "tx" (=capture)
70 <0 0xec541000 0 0x1280>, /* SSI */
|
| D | eukrea-tlv320.txt | 9 - ssi-controller : The phandle of the SSI controller.
|
| D | imx-audio-wm8962.txt | 9 - ssi-controller : The phandle of the i.MX SSI controller
|
| D | imx-audio-sgtl5000.txt | 9 - ssi-controller : The phandle of the i.MX SSI controller
|
| D | imx-audio-es8328.txt | 6 - ssi-controller : The phandle of the i.MX SSI controller
|
| D | fsl,asrc.txt | 6 Ends Audio controller such as ESAI, SSI and SAI. It has three pairs to support
|
| /linux-4.4.14/drivers/hsi/controllers/ |
| D | Kconfig | 7 tristate "OMAP SSI hardware driver"
10 SSI is a legacy version of HSI. It is usually used to connect
12 If you say Y here, you will enable the OMAP SSI hardware driver.
|
| /linux-4.4.14/firmware/dsp56k/ |
| D | bootstrap.asm | 23 ; SSI, Synchronous Serial Interface
26 M_CRA EQU $FFEC ; SSI Control Register A
27 M_CRB EQU $FFED ; SSI Control Register B
28 M_SR EQU $FFEE ; SSI Status Register
29 M_TSR EQU $FFEE ; SSI Time Slot Register
|
| /linux-4.4.14/Documentation/devicetree/bindings/dma/ |
| D | fsl-imx-sdma.txt | 27 0 MCU domain SSI
28 1 Shared SSI
49 22 SSI Dual FIFO (needs firmware ver >= 2)
|
| /linux-4.4.14/sound/soc/sh/ |
| D | Kconfig | 38 tristate "R-Car series SRU/SCU/SSIU/SSI support"
44 This option enables R-Car SRU/SCU/SSIU/SSI sound support
|
| /linux-4.4.14/arch/sh/kernel/cpu/sh4a/ |
| D | setup-sh7780.c | 311 SCIF1, SIOF, HSPI, MMCIF, TMU3, TMU4, TMU5, SSI, FLCTL, GPIO, enumerator
347 INTC_VECT(SSI, 0xe80),
362 SSI, MMCIF, HSPI, SIOF, PCIC5, PCIINTD, PCIINTC, PCIINTB,
377 { 0xffd40018, 0, 32, 8, /* INT2PRI6 */ { SIOF, HSPI, MMCIF, SSI } },
|
| D | setup-sh7734.c | 371 SSI, enumerator
447 INTC_GROUP(SSI, SSI0, SSI1, SSI2, SSI3),
495 SSI, /* SSI 0-3 */
513 { HUDI, SHDMAC, USB, SSI } },
|
| /linux-4.4.14/Documentation/devicetree/bindings/hsi/ |
| D | omap-ssi.txt | 1 OMAP SSI controller bindings
3 OMAP Synchronous Serial Interface (SSI) controller implements a legacy
|
| /linux-4.4.14/sound/soc/fsl/ |
| D | Kconfig | 27 tristate "Synchronous Serial Interface module (SSI) support"
32 Say Y if you want to add Synchronous Serial Interface (SSI)
230 to the SSI interface
253 via SSI/I2S over either SPI or I2C.
295 ESAI/SAI/SSI and connect with external CODECs such as WM8962, CS42888
|
| /linux-4.4.14/Documentation/devicetree/bindings/mfd/ |
| D | mc13xxx.txt | 14 - adc-port: Contain PMIC SSI port number used for ADC.
15 - dac-port: Contain PMIC SSI port number used for DAC.
|
| /linux-4.4.14/Documentation/devicetree/bindings/clock/ti/ |
| D | interface.txt | 22 "ti,omap3-ssi-interface-clock" - interface clock with SSI specific HW handling
|
| /linux-4.4.14/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | dma.txt | 204 DMA driver, such as the SSI sound drivers for the MPC8610. Therefore, any DMA
206 "fsl,elo-dma-channel" or "fsl,eloplus-dma-channel". For the SSI drivers, for
|
| /linux-4.4.14/arch/frv/kernel/ |
| D | cmode.S | 127 # DSTS.SSI field.
|
| /linux-4.4.14/Documentation/video4linux/ |
| D | si476x.txt | 169 0x24 | assi | Adjacent channel SSI
|
| /linux-4.4.14/drivers/scsi/sym53c8xx_2/ |
| D | sym_defs.h | 148 #define SSI 0x08 /* int: script: single step */ macro
|
| D | sym_hipd.c | 1866 OUTB(np, nc_dien , MDPE|BF|SSI|SIR|IID);
2909 else if (dstat & SSI) OUTONB_STD();
|
| /linux-4.4.14/Documentation/networking/ |
| D | phonet.txt | 18 - the SSI bus with some TI OMAP processors.
|
| /linux-4.4.14/arch/arm/boot/dts/ |
| D | r8a7790-lager.dts | 13 * SSI-AK4643
|
| D | r8a7791-koelsch.dts | 14 * SSI-AK4643
|
| D | r8a7778.dtsi | 242 <0xffd91000 0x240>, /* SSI */
|
| D | r8a7791.dtsi | 1652 <0 0xec541000 0 0x280>, /* SSI */
|
| D | r8a7790.dtsi | 1602 <0 0xec541000 0 0x280>, /* SSI */
|
| /linux-4.4.14/drivers/scsi/ |
| D | ncr53c8xx.h | 668 #define SSI 0x08 /* int: script: single step */ macro
|
| D | ncr53c8xx.c | 5316 OUTB (nc_dien , MDPE|BF|ABRT|SSI|SIR|IID); in ncr_init()
5975 if (!(sist & (SBMC|PAR)) && !(dstat & SSI)) { in ncr_exception()
|
| /linux-4.4.14/drivers/net/wan/ |
| D | Kconfig | 63 tristate "LanMedia Corp. SSI/V.35, T1/E1, HSSI, T3 boards"
|
| /linux-4.4.14/arch/ia64/ |
| D | Kconfig | 424 This option specifies the maximum number of nodes in your SSI system.
|
| /linux-4.4.14/drivers/spi/ |
| D | Kconfig | 26 (half duplex), SSP, SSI, and PSP. This driver framework should
|