| /linux-4.4.14/arch/x86/boot/ |
| D | early_serial_console.c | 11 #define FCR 2 /* FIFO control */ macro
28 outb(0, port + FCR); /* no fifo */ in early_serial_init()
|
| /linux-4.4.14/arch/arm/mach-orion5x/ |
| D | tsx09-common.c | 41 writel(0x00, UART1_REG(FCR)); in qnap_tsx09_power_off()
|
| D | terastation_pro2-setup.c | 284 writel(0x07, UART1_REG(FCR)); in tsp2_power_off()
|
| D | kurobox_pro-setup.c | 305 writel(0x07, UART1_REG(FCR)); in kurobox_pro_power_off()
|
| /linux-4.4.14/arch/sparc/include/asm/ |
| D | ns87303.h | 16 #define FCR 0x03 macro
|
| D | floppy_64.h | 700 ns87303_modify(config, FCR, 0, FCR_LDE); in sun_floppy_init()
|
| /linux-4.4.14/drivers/usb/serial/ |
| D | io_16654.h | 36 #define FCR 2 // ! Fifo Control Register (Write) macro
|
| /linux-4.4.14/arch/x86/kernel/ |
| D | early_printk.c | 90 #define FCR 2 /* FIFO control */ macro
137 serial_out(early_serial_base, FCR, 0); /* no fifo */ in early_serial_hw_init()
|
| /linux-4.4.14/drivers/power/reset/ |
| D | qnap-poweroff.c | 70 writel(0x00, UART1_REG(FCR)); in qnap_power_off()
|
| /linux-4.4.14/drivers/net/hamradio/ |
| D | baycom_ser_fdx.c | 110 #define FCR(iobase) (iobase+2) macro
398 outb(0x01, FCR(iobase)); /* enable FIFOs */ in ser12_check_uart()
445 outb(0, FCR(dev->base_addr)); /* disable FIFOs */ in ser12_open()
|
| D | baycom_ser_hdx.c | 98 #define FCR(iobase) (iobase+2) macro
457 outb(0x01, FCR(iobase)); /* enable FIFOs */ in ser12_check_uart()
490 outb(0, FCR(dev->base_addr)); /* disable FIFOs */ in ser12_open()
|
| D | yam.c | 168 #define FCR(iobase) (iobase+2) macro
486 outb(0x00, FCR(dev->base_addr)); in yam_set_uart()
527 outb(0x01, FCR(iobase)); /* enable FIFOs */ in yam_check_uart()
|
| /linux-4.4.14/drivers/net/irda/ |
| D | nsc-ircc.h | 89 #define FCR 0x02 /* (write only) */ macro
|
| D | nsc-ircc.c | 1011 outb(FCR_RXTH|FCR_TXTH|FCR_TXSR|FCR_RXSR|FCR_FIFO_EN, iobase+FCR); in nsc_ircc_setup()
1321 outb(0x00, iobase+FCR); in nsc_ircc_change_speed()
1322 outb(FCR_FIFO_EN, iobase+FCR); in nsc_ircc_change_speed()
1328 iobase+FCR); in nsc_ircc_change_speed()
1736 outb(FCR_RXSR|FCR_FIFO_EN, iobase+FCR); in nsc_ircc_dma_receive()
|
| /linux-4.4.14/arch/frv/kernel/ |
| D | gdb-io.c | 58 __UART(FCR) = in gdbstub_io_init()
|
| /linux-4.4.14/Documentation/isdn/ |
| D | INTERFACE.fax | 141 Value of +FCR
|
| /linux-4.4.14/drivers/mtd/nand/ |
| D | diskonchip.c | 128 #define FCR 510 macro
171 s[i] ^= rs->alpha_to[rs_modnn(rs, tmp + (FCR + i) * j)]; in doc_ecc_decode()
177 syn[i] = rs_modnn(rs, rs->index_of[s[i]] + (NN - FCR - i)); in doc_ecc_decode()
1670 rs_decoder = init_rs(10, 0x409, FCR, 1, NROOTS); in init_nanddoc()
|
| /linux-4.4.14/drivers/isdn/hisax/ |
| D | hisax.h | 575 u_char FCR; member
|