| /linux-4.4.14/drivers/regulator/ |
| D | lp8788-buck.c | 87 BUCK2, enumerator
161 case BUCK2: in lp8788_set_dvs()
178 case BUCK2: in lp8788_get_buck_dvs_ctrl_mode()
230 case BUCK2: in lp8788_select_buck_vout_addr()
387 .id = BUCK2,
443 case BUCK2: in lp8788_dvs_gpio_request()
469 if (id > BUCK2) in lp8788_init_dvs()
477 (id == BUCK2 && !pdata->buck2_dvs)) in lp8788_init_dvs()
|
| D | da9052-regulator.c | 335 DA9052_DCDC(BUCK2, 25, 500, 2075, 6, 6, DA9052_SUPPLY_VBPROGO),
352 DA9052_DCDC(BUCK2, 25, 500, 2075, 6, 6, DA9052_SUPPLY_VBPROGO),
|
| D | hi6421-regulator.c | 112 HI6421_REGULATOR_OF_MATCH(hi6421_buck2, BUCK2),
380 HI6421_BUCK012(BUCK2, 0x11, 0x7f, 0x10, 0x01, 0x10, 350, 100),
|
| D | da903x.c | 375 DA9030_DVC(BUCK2, 850, 1625, 25, BUCK2DVM1, 5, BUCK2DVM1, 7, RCTL11, 0),
399 DA9034_DVC(BUCK2, 725, 1500, 25, CDTV2, 5, VCC1, 2, OVER1, 1),
|
| D | 88pm800.c | 208 PM800_BUCK(buck2, BUCK2, BUCK_ENA, 1, 1200000, buck2_5_volt_range, 0x73),
|
| D | 88pm8607.c | 294 PM8607_DVC(BUCK2, GO, BIT(1), SUPPLIES_EN11, 1),
|
| D | da9055-regulator.c | 430 DA9055_BUCK(BUCK2, 25, 925, 2500, 6, 0, 3, 0),
|
| D | s5m8767.c | 425 s5m8767_regulator_desc(BUCK2),
|
| D | max8997.c | 876 MAX8997_VOLTAGE_REGULATOR(BUCK2, max8997_buck_ops),
|
| /linux-4.4.14/Documentation/devicetree/bindings/mfd/ |
| D | da9055.txt | 36 buck2 : regulator BUCK2
63 buck2: BUCK2 {
|
| D | s2mpa01.txt | 51 - Example: BUCK1, BUCK2, BUCK9
81 buck2_reg: BUCK2 {
|
| D | da9052-i2c.txt | 13 buck2 : regulator BUCK2
|
| D | s2mps11.txt | 108 - Example: BUCK1, BUCK2, BUCK9
144 buck2_reg: BUCK2 {
|
| D | max8998.txt | 70 - Example: BUCK1, BUCK2, BUCK3, BUCK4
|
| /linux-4.4.14/Documentation/devicetree/bindings/regulator/ |
| D | lp872x.txt | 18 bit[4]: BUCK2 enable control. 1 = enable, 0 = disable
19 bit[3]: BUCK2 output voltage register address. 1 = 0Ah, 0 = 0Bh
|
| D | max77802.txt | 13 - inb2-supply: The input supply for BUCK2
|
| D | max8997-regulator.txt | 75 - Example: BUCK1, BUCK2, BUCK3, BUCK7
|
| D | s5m8767-regulator.txt | 92 - Example: BUCK1, BUCK2, BUCK9
|
| /linux-4.4.14/arch/arm/boot/dts/ |
| D | pxa910-dkb.dts | 51 BUCK2 {
|
| D | exynos4210-origen.dts | 262 buck2_reg: BUCK2 {
|
| D | s5pv210-aquila.dts | 213 buck2_reg: BUCK2 {
|
| D | exynos5250-smdk5250.dts | 247 buck2_reg: BUCK2 {
|
| D | exynos5420-arndale-octa.dts | 283 buck2_reg: BUCK2 {
|
| D | exynos5422-odroidxu3-common.dtsi | 240 buck2_reg: BUCK2 {
|
| D | s5pv210-goni.dts | 211 buck2_reg: BUCK2 {
|
| D | exynos5420-smdk5420.dts | 271 buck2_reg: BUCK2 {
|
| D | exynos4210-trats.dts | 426 vint_breg: BUCK2 {
|
| D | exynos4412-odroid-common.dtsi | 368 buck2_reg: BUCK2 {
|
| D | exynos4210-universal_c210.dts | 456 buck2_reg: BUCK2 {
|
| D | exynos4412-origen.dts | 369 buck2_reg: BUCK2 {
|
| D | exynos5250-arndale.dts | 399 buck2_reg: BUCK2 {
|
| D | exynos5250-spring.dts | 278 buck2_reg: BUCK2 {
|
| D | exynos5250-snow-common.dtsi | 370 buck2_reg: BUCK2 {
|
| D | exynos3250-monk.dts | 367 buck2_reg: BUCK2 {
|
| D | exynos3250-rinato.dts | 520 buck2_reg: BUCK2 {
|
| D | exynos5420-peach-pit.dts | 234 buck2_reg: BUCK2 {
|
| D | exynos5800-peach-pi.dts | 221 buck2_reg: BUCK2 {
|
| D | exynos4412-trats2.dts | 776 buck2_reg: BUCK2 {
|
| /linux-4.4.14/arch/arm/mach-pxa/ |
| D | em-x270.c | 1202 DA9030_SUBDEV(regulator, BUCK2, &buck2_data),
|