Home
last modified time | relevance | path

Searched refs:ATA (Results 1 – 53 of 53) sorted by relevance

/linux-4.4.14/drivers/ata/
DKconfig13 menuconfig ATA config
14 tristate "Serial ATA and Parallel ATA drivers (libata)"
21 If you want to use an ATA hard disk, ATA tape drive, ATA CD-ROM or
22 any other ATA device under Linux, say Y and make sure that you know
23 the name of your ATA host adapter (the card inside your computer
24 that "speaks" the ATA protocol, also called ATA controller),
27 NOTE: ATA enables basic SCSI support; *however*,
32 if ATA
39 bool "Verbose ATA error reporting"
42 This option adds parsing of ATA command descriptions and error bits
[all …]
/linux-4.4.14/arch/sh/boards/mach-landisk/
Dirq.c30 ATA, /* ATA */ enumerator
42 INTC_IRQ(ATA, IRQ_ATA),
51 { BUTTON, POWER, FATA, ATA,
/linux-4.4.14/drivers/scsi/libsas/
DKconfig34 bool "ATA support for libsas (requires libata)"
36 depends on ATA = y || ATA = SCSI_SAS_LIBSAS
38 Builds in ATA support into libsas. Will necessitate
/linux-4.4.14/Documentation/blockdev/
Dmflash.txt15 2 different operation (ATA, IO) modes. ATA mode doesn't need any new
17 one chip SSD. IO mode is ATA-like custom mode for the host that doesn't have
21 A. IO mode based on ATA protocol and uses some custom command. (read confirm,
/linux-4.4.14/drivers/dma/bestcomm/
DKconfig13 optional for some drivers (like ATA), but required for
23 This option enables the support for the ATA task.
/linux-4.4.14/drivers/ide/
DKconfig2 # IDE ATA ATAPI Block device driver configuration
10 tristate "ATA/ATAPI/MFM/RLL support (DEPRECATED)"
14 If you say Y here, your kernel will be able to manage ATA/(E)IDE and
19 changes applied. Users of ATA hardware are encouraged to migrate to
20 the newer ATA subsystem ("Serial ATA (prod) and Parallel ATA
51 There are two drivers for Serial ATA controllers.
55 you may take a look at "Serial ATA (prod) and Parallel ATA
70 tristate "generic ATA/ATAPI disk support"
73 Support for ATA/ATAPI disks (including ATAPI floppy drives).
81 bool "ATA disk support"
[all …]
/linux-4.4.14/Documentation/laptops/
Ddisk-shock-protection.txt20 ATA/ATAPI-7 specifies the IDLE IMMEDIATE command with unload feature.
38 For each ATA device, the kernel exports the file
75 reality. In fact, the ATA specs clearly state that the time for an
76 unload operation to complete is vendor specific. The hint in ATA-7
78 been dropped in ATA-8.
108 version of the ATA standard than ATA-7, but do support the unload
/linux-4.4.14/Documentation/arm/Samsung-S3C24XX/
DS3C2412.txt111 ATA
114 No current support for the on-board ATA block.
/linux-4.4.14/arch/powerpc/platforms/maple/
DKconfig14 select ATA_NONSTANDARD if ATA
/linux-4.4.14/Documentation/ide/
D00-INDEX12 - important info for users of ATA devices (IDE/EIDE disks and CD-ROMS).
Dide.txt57 14 & 15). There can be up to two drives per interface, as per the ATA-6 spec.
236 ATA = AT (the old IBM 286 computer) Attachment Interface, a draft American
240 The latest standards define some enhancements, known as the ATA-6 spec,
243 ATAPI = ATA Packet Interface, a new protocol for controlling the drives,
Dide-tape.txt65 sharing a (fast) ATA-2 disk with any (slow) new ATAPI device.
/linux-4.4.14/Documentation/devicetree/bindings/ata/
Dbrcm,sata-brcmstb.txt3 SATA nodes are defined to describe on-chip Serial ATA controllers.
Dfsl-sata.txt3 SATA nodes are defined to describe on-chip Serial ATA controllers.
Dexynos-sata.txt3 SATA nodes are defined to describe on-chip Serial ATA controllers.
Dqcom-sata.txt3 SATA nodes are defined to describe on-chip Serial ATA controllers.
Dsata_highbank.txt3 SATA nodes are defined to describe on-chip Serial ATA controllers.
Dahci-platform.txt3 SATA nodes are defined to describe on-chip Serial ATA controllers.
Dapm-xgene.txt3 SATA host controller nodes are defined to describe on-chip Serial ATA
/linux-4.4.14/Documentation/ABI/testing/
Dsysfs-ata6 Provide a place in sysfs for storing the ATA topology of the system. This allows
7 retrieving various information about ATA objects.
/linux-4.4.14/drivers/usb/storage/
DKconfig66 tristate "ISD-200 USB/ATA Bridge support"
70 on the In-Systems Design ISD-200 USB/ATA bridge.
176 tristate "SAT emulation on Cypress USB/ATA Bridge with ATACB"
180 on the Cypress USB/ATA bridge supporting ATACB. This will allow you
/linux-4.4.14/arch/unicore32/configs/
Dunicore32_defconfig97 # Serial ATA (prod) and Parallel ATA (experimental) drivers
/linux-4.4.14/Documentation/aoe/
Dtodo.txt9 Because ATA over Ethernet is not fragmented by the kernel's IP code,
Daoe.txt1 ATA over Ethernet is a network protocol that provides simple access to
47 limit ATA over Ethernet traffic to eth2 and eth4. AoE traffic from
120 all network interfaces may be used for ATA over Ethernet. Here is a
/linux-4.4.14/arch/mips/txx9/
DKconfig118 bool "ATA"
/linux-4.4.14/Documentation/ioctl/
Dhdio.txt245 ATA drive identity information. For full description, see
247 the ATA specification.
520 executes an ATA soft reset on the controller.
526 Note: If you don't have a copy of the ANSI ATA specification
529 Execute an ATA disk command directly by writing the "taskfile"
731 Note: If you don't have a copy of the ANSI ATA specification
794 Note: If you don't have a copy of the ANSI ATA specification
/linux-4.4.14/Documentation/devicetree/bindings/dma/
Dfsl-imx-sdma.txt37 10 ATA
/linux-4.4.14/drivers/scsi/
Deata_generic.h224 ATA:1, /* ATA device connected (not supported) */ member
DKconfig78 Serial ATA (SATA) or Parallel ATA (PATA) hard disks,
351 tristate "3ware 5/6/7/8xxx ATA-RAID support"
354 3ware is the only hardware ATA-Raid product in Linux to date.
1105 depends on PCI && SCSI && ATA
/linux-4.4.14/block/
DKconfig88 T10/SCSI Data Integrity Field or the T13/ATA External Path
/linux-4.4.14/Documentation/isdn/
DREADME.audio88 with ATA, depending on the calling service, the emulator
DREADME88 ATA Answer incoming call.
226 local ATA was given.
/linux-4.4.14/Documentation/cris/
DREADME46 * ATA
/linux-4.4.14/Documentation/driver-model/
Ddevres.txt22 example, a plain SFF ATA controller (that is, good old PCI IDE) in
/linux-4.4.14/arch/powerpc/platforms/44x/
DKconfig222 select ATA
/linux-4.4.14/Documentation/m68k/
DREADME.buddha123 to the ATA-X3T9 manual.
/linux-4.4.14/Documentation/devicetree/bindings/powerpc/fsl/
Dmpc5200.txt97 ata@<addr> fsl,mpc5200-ata IDE ATA interface
/linux-4.4.14/drivers/mtd/devices/
DKconfig194 the system as an ATA drive.
/linux-4.4.14/arch/xtensa/configs/
Dcommon_defconfig162 # ATA/ATAPI/MFM/RLL support
/linux-4.4.14/Documentation/cdrom/
Dide-cd251 the standard Linux ATA disk drive probe. If you own one of these drives,
252 you can bypass the ATA probing which confuses these CDROM drives, by
/linux-4.4.14/drivers/block/
DKconfig435 tristate "ATA over Ethernet support"
438 This driver provides Support for ATA over Ethernet block
/linux-4.4.14/Documentation/acpi/
Dnamespace.txt222 | M | ATA Controller | xSDT | LNXIOBAY |
/linux-4.4.14/lib/
DKconfig422 simple text pattern matching. It originated in the ATA code
/linux-4.4.14/
DCREDITS746 D: Original designer and co-author of ATA Taskfile
1465 D: Active-ATA-Chipset maddness..........
1467 D: ATA-Disconnect, ATA-TCQ
1468 D: ATA-Smart Kernel Daemon
1469 D: Serial ATA
1470 D: ATA Command Block and Taskfile
1471 S: Linux ATA Development (LAD)
DMAINTAINERS1811 ATA OVER ETHERNET (AOE) DRIVER
6285 LIBATA SUBSYSTEM (Serial and Parallel ATA drivers)
/linux-4.4.14/Documentation/scsi/
Darcmsr_spec.txt405 ** GUI_MAX_ATA_MODE : Set maximum ATA mode to be used
/linux-4.4.14/arch/ia64/
DKconfig65 select ATA_NONSTANDARD if ATA
/linux-4.4.14/drivers/misc/
DKconfig210 driver (SCSI/ATA) which supports enclosures
/linux-4.4.14/Documentation/
D00-INDEX73 - description of AoE (ATA over Ethernet) along with config examples.
DSubmittingPatches488 libata: Un-break ATA blacklist
Dkernel-parameters.txt1828 the ATA ID string printed on console by libata. If
3947 t = NO_ATA_1X (don't allow ATA(12) and ATA(16)
/linux-4.4.14/arch/arm/boot/dts/
Dtegra124-jetson-tk1.dts1646 /* Serial ATA */
/linux-4.4.14/arch/cris/include/uapi/arch-v10/arch/
Dsv_addr.agh3008 !* ATA interface registers