Searched refs:tx_mode (Results 1 – 12 of 12) sorted by relevance
| /linux-4.1.27/drivers/net/ethernet/samsung/sxgbe/ |
| D | sxgbe_mtl.c | 181 int tx_mode) in sxgbe_set_tx_mtl_mode() argument
187 if (tx_mode == SXGBE_MTL_SFMODE) { in sxgbe_set_tx_mtl_mode()
191 if (tx_mode <= 64) in sxgbe_set_tx_mtl_mode()
193 else if (tx_mode <= 96) in sxgbe_set_tx_mtl_mode()
195 else if (tx_mode <= 128) in sxgbe_set_tx_mtl_mode()
197 else if (tx_mode <= 192) in sxgbe_set_tx_mtl_mode()
199 else if (tx_mode <= 256) in sxgbe_set_tx_mtl_mode()
201 else if (tx_mode <= 384) in sxgbe_set_tx_mtl_mode()
|
| D | sxgbe_mtl.h | 78 int tx_mode);
|
| /linux-4.1.27/arch/arm/mach-omap2/ |
| D | serial.c | 149 u16 tx_mode, rx_mode; in omap_serial_check_wakeup() local
151 tx_mode = omap_mux_read(tx_partition, tx_mux->reg_offset); in omap_serial_check_wakeup()
158 if (OMAP_MODE_UART(rx_mode) && OMAP_MODE_UART(tx_mode)) in omap_serial_check_wakeup()
|
| /linux-4.1.27/drivers/usb/musb/ |
| D | musb_dsps.c | 95 u16 tx_mode; member
134 u32 tx_mode; member
843 .tx_mode = 0x70,
891 glue->context.tx_mode = dsps_readl(mbase, wrp->tx_mode); in dsps_suspend()
913 dsps_writel(mbase, wrp->tx_mode, glue->context.tx_mode); in dsps_resume()
|
| D | musb_cppi41.c | 55 u32 tx_mode; member
329 old_mode = controller->tx_mode; in cppi41_set_dma_mode()
338 controller->tx_mode = new_mode; in cppi41_set_dma_mode()
|
| /linux-4.1.27/drivers/tty/serial/ |
| D | samsung.h | 91 unsigned int tx_mode; member
|
| D | samsung.c | 196 ourport->tx_mode = 0; in s3c24xx_serial_stop_tx()
252 ourport->tx_mode = S3C24XX_TX_DMA; in enable_tx_dma()
278 ourport->tx_mode = S3C24XX_TX_PIO; in enable_tx_pio()
283 if (ourport->tx_mode != S3C24XX_TX_PIO) in s3c24xx_serial_start_tx_pio()
295 if (ourport->tx_mode != S3C24XX_TX_DMA) in s3c24xx_serial_start_tx_dma()
974 ourport->tx_mode = 0; in s3c24xx_serial_shutdown()
|
| D | ucc_uart.c | 132 u8 tx_mode; /* 0xC5, mode, 0=AHDLC, 1=UART */ member
729 out_8(&uccup->tx_mode, in qe_uart_init_ucc()
|
| /linux-4.1.27/drivers/net/ethernet/adaptec/ |
| D | starfire.c | 564 u32 tx_mode; member
981 np->tx_mode = TxFlowEnable|RxFlowEnable|PadEnable; /* modified when link is up. */ in netdev_open()
982 writel(MiiSoftReset | np->tx_mode, ioaddr + TxMode); in netdev_open()
984 writel(np->tx_mode, ioaddr + TxMode); in netdev_open()
1635 new_tx_mode = np->tx_mode & ~FullDuplex; /* duplex setting */ in netdev_media_change()
1638 if (np->tx_mode != new_tx_mode) { in netdev_media_change()
1639 np->tx_mode = new_tx_mode; in netdev_media_change()
1640 writel(np->tx_mode | MiiSoftReset, ioaddr + TxMode); in netdev_media_change()
1642 writel(np->tx_mode, ioaddr + TxMode); in netdev_media_change()
|
| /linux-4.1.27/drivers/net/ethernet/oki-semi/pch_gbe/ |
| D | pch_gbe_main.c | 832 u32 tx_mode, tcpip; in pch_gbe_setup_tctl() local
834 tx_mode = PCH_GBE_TM_LONG_PKT | in pch_gbe_setup_tctl()
840 iowrite32(tx_mode, &hw->reg->TX_MODE); in pch_gbe_setup_tctl()
|
| /linux-4.1.27/drivers/net/ethernet/broadcom/ |
| D | tg3.c | 1968 u32 old_tx_mode = tp->tx_mode; in tg3_setup_flow_control()
1994 tp->tx_mode |= TX_MODE_FLOW_CTRL_ENABLE; in tg3_setup_flow_control()
1996 tp->tx_mode &= ~TX_MODE_FLOW_CTRL_ENABLE; in tg3_setup_flow_control()
1998 if (old_tx_mode != tp->tx_mode) in tg3_setup_flow_control()
1999 tw32_f(MAC_TX_MODE, tp->tx_mode); in tg3_setup_flow_control()
8891 tp->tx_mode &= ~TX_MODE_ENABLE; in tg3_abort_hw()
8892 tw32_f(MAC_TX_MODE, tp->tx_mode); in tg3_abort_hw()
10550 tp->tx_mode = TX_MODE_ENABLE; in tg3_reset_hw()
10554 tp->tx_mode |= TX_MODE_MBUF_LOCKUP_FIX; in tg3_reset_hw()
10559 tp->tx_mode &= ~val; in tg3_reset_hw()
[all …]
|
| D | tg3.h | 3234 u32 tx_mode; member
|