Searched refs:shunt (Results 1 – 13 of 13) sorted by relevance
35 in0_input shunt voltage (mV)36 in0_input_highest shunt voltage historical maximum reading (mV)37 in0_input_lowest shunt voltage historical minimum reading (mV)38 in0_reset_history reset shunt voltage history39 in0_max shunt voltage max alarm limit (mV)40 in0_min shunt voltage min alarm limit (mV)41 in0_crit_max shunt voltage crit max alarm limit (mV)42 in0_crit_min shunt voltage crit min alarm limit (mV)43 in0_max_alarm shunt voltage max alarm limit exceeded44 in0_min_alarm shunt voltage min alarm limit exceeded[all …]
40 The INA219 is a high-side current shunt and power monitor with an I2C41 interface. The INA219 monitors both shunt drop and supply voltage, with44 The INA220 is a high or low side current shunt and power monitor with an I2C45 interface. The INA220 monitors both shunt drop and supply voltage.47 The INA226 is a current shunt and power monitor with an I2C interface.48 The INA226 monitors both a shunt voltage drop and bus supply voltage.50 INA230 and INA231 are high or low side current shunt and power monitors51 with an I2C interface. The chips monitor both a shunt voltage drop and54 The shunt value in micro-ohms can be set via platform data or device tree at61 bus and shunt voltage conversion times multiplied by the averaging rate. We
9 - shunt-resistor17 shunt-resistor = <5000>;
13 - shunt-resistor21 shunt-resistor = <1000>;
186 shunt-resistor = <1000>;192 shunt-resistor = <1000>;198 shunt-resistor = <1000>;204 shunt-resistor = <1000>;210 shunt-resistor = <1000>;216 shunt-resistor = <1000>;
116 shunt-resistor = <1000>;121 shunt-resistor = <1000>;126 shunt-resistor = <1000>;131 shunt-resistor = <1000>;
119 shunt-resistor = <1000>;124 shunt-resistor = <1000>;129 shunt-resistor = <1000>;134 shunt-resistor = <1000>;
178 shunt-resistor = <1000>;184 shunt-resistor = <1000>;
179 shunt-resistor = <1000>;
515 u32 shunt; in ina209_init_client() local531 shunt = pdata->shunt_uohms; in ina209_init_client()533 &shunt)) { in ina209_init_client()534 if (shunt == 0) in ina209_init_client()537 shunt = data->calibration_orig ? in ina209_init_client()550 clamp_val(40960000 / shunt, 1, 65535)); in ina209_init_client()
365 shunt-resistor = <10000>;372 shunt-resistor = <10000>;379 shunt-resistor = <10000>;386 shunt-resistor = <10000>;
106 shunt-resistor = <1000>;112 shunt-resistor = <1000>;