Searched refs:settle (Results 1 – 23 of 23) sorted by relevance
| /linux-4.1.27/Documentation/devicetree/bindings/media/ |
| D | samsung-mipi-csis.txt | 46 - samsung,csis-hs-settle : (optional) differential receiver (HS-RX) settle time;
78 samsung,csis-hs-settle = <12>;
|
| D | samsung-fimc.txt | 205 samsung,csis-hs-settle = <12>;
|
| /linux-4.1.27/arch/arm/mach-omap1/ |
| D | sram.S | 46 mov r4, #0x0700 @ let the clocks settle
|
| /linux-4.1.27/Documentation/devicetree/bindings/iio/adc/ |
| D | qcom,spmi-vadc.txt | 75 - qcom,hw-settle-time:
119 qcom,hw-settle-time = <200>;
|
| /linux-4.1.27/drivers/s390/cio/ |
| D | css.h | 95 int (*settle)(void); member
|
| D | css.c | 1046 if (cssdrv->settle) in css_settle()
1047 return cssdrv->settle(); in css_settle()
|
| D | device.c | 188 .settle = io_subchannel_settle,
|
| /linux-4.1.27/Documentation/devicetree/bindings/input/touchscreen/ |
| D | brcm,iproc-touchscreen.txt | 15 the tsc waits to allow the voltage to settle after
|
| /linux-4.1.27/Documentation/devicetree/bindings/input/ |
| D | ads7846.txt | 35 ti,settle-delay-usec Settling time of the analog signals;
|
| /linux-4.1.27/drivers/scsi/aic7xxx/ |
| D | Kconfig.aic79xx | 42 The bus settle delay following all error recovery actions is
|
| D | Kconfig.aic7xxx | 47 The bus settle delay following all error recovery actions is
|
| D | aic7xxx.seq | 2014 * the normal bus settle delay. [SCSI III SPI 10.11.0]
|
| D | aic79xx.seq | 1395 * they were asserted within the bus settle delay window.
|
| /linux-4.1.27/drivers/media/platform/exynos4-is/ |
| D | mipi-csis.c | 350 static void s5pcsis_set_hsync_settle(struct csis_state *state, int settle) in s5pcsis_set_hsync_settle() argument
354 val = (val & ~S5PCSIS_DPHYCTRL_HSS_MASK) | (settle << 27); in s5pcsis_set_hsync_settle()
|
| /linux-4.1.27/Documentation/devicetree/bindings/regulator/ |
| D | ti-abb-regulator.txt | 21 to settle down(target time for SR2_WTCNT_VALUE).
|
| /linux-4.1.27/Documentation/devicetree/bindings/pci/ |
| D | mvebu-pci.txt | 146 /* wait 20ms for device settle after reset deassertion */
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | exynos4412-trats2.dts | 819 samsung,csis-hs-settle = <12>;
839 samsung,csis-hs-settle = <18>;
|
| /linux-4.1.27/drivers/scsi/sym53c8xx_2/ |
| D | sym_glue.c | 70 module_param_named(settle, sym_driver_setup.settle_delay, byte, 0);
84 MODULE_PARM_DESC(settle, "Settle delay in seconds. Default 3");
|
| /linux-4.1.27/arch/arm/mach-s3c24xx/ |
| D | Kconfig | 121 S3C24XX series CPUfreq driver. The PLL takes time to settle
|
| /linux-4.1.27/Documentation/scsi/ |
| D | ncr53c8xx.txt | 874 settle time 10 seconds settle:10
886 tags:0,sync:50,debug:0,burst:7,led:0,wide:1,settle:2,diff:0,irqm:0
899 tags:32,sync:12,debug:0,burst:7,led:1,wide:1,settle:2,diff:0,irqm:0
|
| D | ChangeLog.ncr53c8xx | 365 mode to settle. Delays used while resetting the controller
|
| D | sym53c8xx_2.txt | 521 settle=n delay for n seconds
|
| /linux-4.1.27/drivers/scsi/ |
| D | Kconfig | 954 control register to let things settle out. Enabling this option may
|