| /linux-4.1.27/Documentation/ABI/testing/ |
| D | sysfs-bus-pci-drivers-ehci_hcd | 10 high-speed device is plugged in, the connection is routed
12 is plugged in, the connection is routed to the companion
17 connection to be routed to the companion controller.
19 file causes connections on that port to be routed to the
|
| /linux-4.1.27/Documentation/devicetree/bindings/thermal/ |
| D | ti_soc_thermal.txt | 18 the talert signal is routed to;
21 line the tshut signal is routed to. The informed GPIO will
|
| /linux-4.1.27/net/can/ |
| D | Kconfig | 49 msg sending and can optionally modify routed CAN frames on the fly.
50 CAN frames can be routed between CAN network interfaces (one hop).
|
| /linux-4.1.27/Documentation/devicetree/bindings/pci/ |
| D | v3-v360epc-pci.txt | 15 as routed on the system.
|
| /linux-4.1.27/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | msi-pic.txt | 20 and routed to the host interrupt controller. the interrupts should
26 are routed to IPIC, and for 85xx/86xx cpu the interrupts are routed
|
| /linux-4.1.27/Documentation/devicetree/bindings/interrupt-controller/ |
| D | interrupts.txt | 13 which the interrupts are routed; see section 2 below for details.
20 interrupts are routed and contains a single phandle referring to the interrupt
|
| D | ti,omap4-wugen-mpu | 15 - interrupt-parent : a phandle to the GIC these interrupts are routed
|
| D | nvidia,tegra-ictlr.txt | 22 - interrupt-parent : a phandle to the GIC these interrupts are routed
|
| D | brcm,bcm7038-l1-intc.txt | 14 peripheral IRQs to be routed to any CPU
|
| /linux-4.1.27/Documentation/ia64/ |
| D | IRQ-redir.txt | 49 The IRQ is routed to the CPU with lowest XTP register value, the
55 manner. IRQs will be routed only to the selected target CPUs. Check
|
| /linux-4.1.27/arch/powerpc/boot/dts/ |
| D | mpc5121ads.dts | 78 * all irqs but touch screen are routed to irq0 (ipic 48)
79 * touch screen is statically routed to irq1 (ipic 17)
|
| D | rainier.dts | 340 /* All PCI interrupts are routed to IRQ 67 */
|
| D | sequoia.dts | 402 /* All PCI interrupts are routed to IRQ 67 */
|
| D | icon.dts | 313 /* PCI-X interrupt (SM502) is routed to extIRQ10 (UIC1, 19) */
|
| D | glacier.dts | 487 /* All PCI interrupts are routed to ext IRQ 2 -> UIC1-0 */
|
| D | canyonlands.dts | 450 /* All PCI interrupts are routed to ext IRQ 2 -> UIC1-0 */
|
| /linux-4.1.27/Documentation/devicetree/bindings/mailbox/ |
| D | omap-mailbox.txt | 11 interrupt lines. An output interrupt line is routed to an interrupt controller
25 routed to different processor sub-systems on DRA7xx as they are routed through
|
| /linux-4.1.27/Documentation/devicetree/bindings/usb/ |
| D | samsung-hsotg.txt | 18 interrupt signal of the HSOTG block is routed,
|
| /linux-4.1.27/Documentation/devicetree/bindings/dma/ |
| D | ti-edma.txt | 8 - interrupt-parent: Interrupt controller the interrupt is routed through
|
| /linux-4.1.27/drivers/staging/lustre/lnet/lnet/ |
| D | lib-ptl.c | 268 bool routed; in lnet_mt_of_match() local
281 routed = LNET_NIDNET(msg->msg_hdr.src_nid) != in lnet_mt_of_match()
285 (portal_rotor != LNET_PTL_ROTOR_ON && !routed)) { in lnet_mt_of_match()
292 if (portal_rotor == LNET_PTL_ROTOR_HASH_RT && routed) in lnet_mt_of_match()
|
| /linux-4.1.27/Documentation/networking/ |
| D | ipvs-sysctl.txt | 193 realservers so that they are routed as if they originate from the
194 director. Otherwise they are routed as if they are forwarded by the
198 of a packet originating from a director is routed differently to a
|
| D | policy-routing.txt | 143 If it is set, locally originated packets are routed
|
| D | generic-hdlc.txt | 7 - Normal (routed) and Ethernet-bridged (Ethernet device emulation)
|
| /linux-4.1.27/Documentation/sound/alsa/ |
| D | HD-Audio-Controls.txt | 66 When this enum control is enabled, the headphone output is routed
114 When this enum control is enabled, the headphone output is routed
|
| D | CMIPCI.txt | 30 disabled. Otherwise no signal will be routed to the rear speakers.
48 playback should be routed there as default. If not, there is a
162 "IEC958 In Monitor" - SPDIF input is routed to DAC.
|
| D | hdspm.txt | 353 channel (routed). This is against the ALSA-convention, where all
362 note: here the analog output is enabled (but not routed).
|
| D | compress_offload.txt | 64 decoded samples are routed to a physical output or logical back-end.
|
| /linux-4.1.27/Documentation/devicetree/bindings/soc/mediatek/ |
| D | pwrap.txt | 14 The signals of these pins are routed over the SPI bus using the pwrap
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | kirkwood-blackarmor-nas220.dts | 96 * Serial port routed to connector CN5
|
| D | ste-nomadik-nhk15.dts | 57 /* This is where the interrupt is routed on the NHK-15 debug board */
|
| D | ste-nomadik-stn8815.dtsi | 805 * routed and used for its 4-bit levelshifter.
|
| /linux-4.1.27/drivers/irqchip/ |
| D | Kconfig | 149 routed to one of the free irqchip interrupt lines.
|
| /linux-4.1.27/drivers/i2c/muxes/ |
| D | Kconfig | 57 This is useful for SoCs whose I2C module's signals can be routed to
|
| /linux-4.1.27/Documentation/devicetree/bindings/gpio/ |
| D | gpio.txt | 168 Some or all of the GPIOs provided by a GPIO controller may be routed to pins
219 Here, a single GPIO controller has GPIOs 0..9 routed to pin controller
220 pinctrl1's pins 20..29, and GPIOs 10..19 routed to pin controller pinctrl2's
|
| /linux-4.1.27/Documentation/devicetree/bindings/arm/omap/ |
| D | crossbar.txt | 15 - ti,max-crossbar-sources: Maximum number of crossbar sources that can be routed.
|
| /linux-4.1.27/Documentation/arm/pxa/ |
| D | mfp.txt | 43 can be routed from GPIO19 of the GPIO controller.
50 which can be routed to external through one or more MFPs (e.g. GPIO<0>
51 can be routed through either MFP_PIN_GPIO0 as well as MFP_PIN_GPIO0_2,
|
| /linux-4.1.27/Documentation/sound/alsa/soc/ |
| D | DPCM.txt | 13 way as the analog signal is routed in an ASoC codec driver. DPCM uses a DAPM
302 A hostless PCM stream is a stream that is not routed through the host CPU. An
320 In this case the PCM data is routed via the DSP. The host CPU in this use case
|
| /linux-4.1.27/arch/x86/crypto/ |
| D | crc32c-pcl-intel-asm_64.S | 63 # Define threshold where buffers are considered "small" and routed to more
|
| /linux-4.1.27/Documentation/pti/ |
| D | pti_intel_mid.txt | 15 be collected and routed to the pti driver, such as trace
|
| /linux-4.1.27/Documentation/devicetree/bindings/clock/ |
| D | exynos5260-clock.txt | 29 These clocks are fed into the clock controller and then routed to
|
| /linux-4.1.27/Documentation/hwmon/ |
| D | w83627hf | 58 it is possible or even likely for a w83627thf to have the VID signals routed
|
| /linux-4.1.27/Documentation/devicetree/bindings/mfd/ |
| D | max8998.txt | 24 the interrupts from MAX8998 are routed to.
|
| /linux-4.1.27/drivers/gpu/drm/msm/ |
| D | NOTES | 61 etc) are routed through MDP.
|
| /linux-4.1.27/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-st.txt | 3 Each multi-function pin is controlled, driven and routed through the
|
| /linux-4.1.27/arch/blackfin/mach-bf548/ |
| D | Kconfig | 41 BF548 ATAPI data and address PINs can be routed through
|
| /linux-4.1.27/Documentation/x86/ |
| D | earlyprintk.txt | 24 Interrupt: pin D routed to IRQ 19
|
| /linux-4.1.27/sound/drivers/ |
| D | Kconfig | 84 the standard ALSA PCM device. The devices are routed 0->1 and
|
| /linux-4.1.27/Documentation/power/ |
| D | suspend-and-interrupts.txt | 64 (such as an SoC) so that signals from a given line are routed in a different way
|
| D | pci.txt | 242 are routed separately and they need not pass through bridges (in principle they
243 may be routed directly to the system's core logic), but for PCI Express devices
|
| /linux-4.1.27/Documentation/isdn/ |
| D | README.x25 | 167 "01" to be routed to your created isdn network interface.
|
| /linux-4.1.27/net/ipv6/netfilter/ |
| D | Kconfig | 257 which can effect how the packet is routed.
|
| /linux-4.1.27/Documentation/scsi/ |
| D | advansys.txt | 109 b. Kernel messages are routed to console output. Check
|
| /linux-4.1.27/net/ipv4/netfilter/ |
| D | Kconfig | 308 which can effect how the packet is routed.
|
| /linux-4.1.27/Documentation/arm/OMAP/ |
| D | DSS | 106 These framebuffers can be routed flexibly to any overlays, thus allowing very
|
| /linux-4.1.27/drivers/net/ |
| D | Kconfig | 366 domain network stack. These can then be bridged or routed
|
| /linux-4.1.27/Documentation/nfc/ |
| D | nfc-hci.txt | 18 routed through netlink sockets to NFC Core and then to HCI. From this point,
|
| /linux-4.1.27/Documentation/cdrom/ |
| D | cdrom-standard.tex | 538 are routed through the call $dev_ioctl()$. In principle, `private'
813 operations, ones that are routed through the call $audio_ioctl()$, and
833 \subsubsection{$Ioctl$s routed through $audio_ioctl()$}
|
| /linux-4.1.27/drivers/misc/ |
| D | Kconfig | 133 trace data routed from various parts in the system out
|
| /linux-4.1.27/Documentation/PCI/ |
| D | pci-error-recovery.txt | 402 interrupts are routed to error-management capable slots and can deal
|
| /linux-4.1.27/Documentation/ |
| D | pinctrl.txt | 441 of the package the silicon performing the SPI logic can alternatively be routed
452 contain several I2C, SPI, SDIO/MMC, etc silicon blocks that can be routed to
|
| /linux-4.1.27/Documentation/virtual/kvm/ |
| D | timekeeping.txt | 192 The RTC generates an interrupt which is usually routed to IRQ 8. The interrupt
|
| /linux-4.1.27/Documentation/filesystems/ |
| D | proc.txt | 722 The way IRQs are routed is handled by the IO-APIC, and it's Round Robin
1116 your system and how much traffic was routed over those devices:
|
| /linux-4.1.27/Documentation/gpio/ |
| D | gpio-legacy.txt | 288 Some platforms allow some or all GPIO signals to be routed to different pins.
|