| /linux-4.1.27/drivers/staging/iio/cdc/ |
| D | ad7150.c | 170 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_params() local
181 value = chip->threshold[rising][chan]; in ad7150_write_event_params()
189 sens = chip->mag_sensitivity[rising][chan]; in ad7150_write_event_params()
190 timeout = chip->mag_timeout[rising][chan]; in ad7150_write_event_params()
193 sens = chip->thresh_sensitivity[rising][chan]; in ad7150_write_event_params()
194 timeout = chip->thresh_timeout[rising][chan]; in ad7150_write_event_params()
221 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_config() local
241 if (rising) in ad7150_write_event_config()
248 if (rising) in ad7150_write_event_config()
255 if (rising) in ad7150_write_event_config()
[all …]
|
| /linux-4.1.27/drivers/staging/comedi/drivers/ |
| D | ni_6527.c | 282 unsigned int rising, in ni6527_set_edge_detection() argument
287 rising &= mask; in ni6527_set_edge_detection()
293 rising |= readb(dev->mmio + in ni6527_set_edge_detection()
302 writeb(rising & 0xff, in ni6527_set_edge_detection()
308 rising >>= 8; in ni6527_set_edge_detection()
320 unsigned int rising, falling, shift; in ni6527_intr_insn_config() local
327 rising = data[1]; in ni6527_intr_insn_config()
329 ni6527_set_edge_detection(dev, mask, rising, falling); in ni6527_intr_insn_config()
338 rising = 0; in ni6527_intr_insn_config()
346 rising = 0; in ni6527_intr_insn_config()
[all …]
|
| D | ni_65xx.c | 301 unsigned int rising, in ni_65xx_update_edge_detection() argument
319 port_rising = rising >> bitshift; in ni_65xx_update_edge_detection()
323 port_rising = rising << -bitshift; in ni_65xx_update_edge_detection()
|
| /linux-4.1.27/Documentation/devicetree/bindings/gpio/ |
| D | gpio-stp-xway.txt | 26 - lantiq,rising : use rising instead of falling edge for the shift register
41 /* lantiq,rising; */
|
| D | cavium-octeon-gpio.txt | 21 1 - edge triggered on the rising edge.
37 * 2) Triggering (1 - edge rising
|
| /linux-4.1.27/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-lm3533-als | 7 in each direction (rising|falling) and a zone change occurs.
42 in_illuminance0_threshY_{falling,rising} thresholds.
|
| D | sysfs-gpio | 22 /edge ... r/w as: none, falling, rising, both
|
| D | sysfs-bus-iio | 744 <type>Y[_name]_thresh[_(rising|falling)]_hysteresis.
750 normal, for rising events the hysteresis is subtracted from the _value
|
| /linux-4.1.27/Documentation/devicetree/bindings/net/ |
| D | qca-qca7000-spi.txt | 10 and the second cell should specify the trigger type as rising edge
41 interrupts = <25 0x1>; /* Index: 25, rising edge */
|
| /linux-4.1.27/Documentation/devicetree/bindings/i2c/ |
| D | i2c-rk3x.txt | 24 - i2c-scl-rising-time-ns : Number of nanoseconds the SCL signal takes to rise
54 i2c-scl-rising-time-ns = <800>;
|
| /linux-4.1.27/Documentation/devicetree/bindings/video/ |
| D | display-timing.txt | 30 - active high = drive pixel data on rising edge/
33 sample data on rising edge
|
| /linux-4.1.27/Documentation/devicetree/bindings/pps/ |
| D | pps-gpio.txt | 12 (instead of by a rising edge)
|
| /linux-4.1.27/Documentation/devicetree/bindings/misc/ |
| D | bmp085.txt | 10 value range is 0-3 with rising sensitivity.
|
| /linux-4.1.27/Documentation/devicetree/bindings/mips/cavium/ |
| D | cib.txt | 37 * 2) Triggering (1 - edge rising
|
| /linux-4.1.27/Documentation/devicetree/bindings/pinctrl/ |
| D | nvidia,tegra20-pinmux.txt | 55 - nvidia,slew-rate-rising: Integer. Controls rising signal slew rate. 0 is
96 nvidia,pull-up-strength, nvidia,slew-rate-rising, nvidia,slew-rate-falling.
|
| D | pinctrl-st.txt | 69 - 1 = rising edge triggered
71 - 3 = rising and falling edge triggered
|
| D | samsung-pinctrl.txt | 119 - 1 = rising edge triggered
121 - 3 = rising and falling edge triggered
154 - 1 = rising edge triggered
156 - 3 = rising and falling edge triggered
|
| D | nvidia,tegra210-pinmux.txt | 72 - nvidia,slew-rate-rising: Integer. Controls rising signal slew rate. 0 is
|
| D | nvidia,tegra30-pinmux.txt | 86 nvidia,slew-rate-rising, nvidia,slew-rate-falling. Most but not all
|
| D | nvidia,tegra114-pinmux.txt | 75 nvidia,slew-rate-rising, nvidia,slew-rate-falling. Most but not all
|
| D | nvidia,tegra124-pinmux.txt | 88 nvidia,slew-rate-rising, nvidia,slew-rate-falling. Most but not all
|
| D | pinctrl-single.txt | 55 schmitt value (rising-edge & falling-edge) in the pinmux register.
|
| /linux-4.1.27/Documentation/gpio/ |
| D | sysfs.txt | 86 "edge" ... reads as either "none", "rising", "falling", or
97 for "rising" and "falling" edges will follow this
155 either rising or falling edge will be reconfigured to follow this setting.
|
| D | gpio.txt | 118 delays the rising edge of SCK, and the I2C master adjusts its signaling rate
|
| D | gpio-legacy.txt | 438 slower clock delays the rising edge of SCK, and the I2C master adjusts its
705 "edge" ... reads as either "none", "rising", "falling", or
716 for "rising" and "falling" edges will follow this
775 rising or falling edge will be reconfigured to follow this setting.
|
| /linux-4.1.27/Documentation/devicetree/bindings/drm/tilcdc/ |
| D | panel.txt | 11 - sync-edge: Horizontal and Vertical Sync Edge: 0=rising 1=falling
|
| /linux-4.1.27/Documentation/devicetree/bindings/sound/ |
| D | cs35l32.txt | 39 - cirrus,battery-recovery : Low battery nominal recovery threshold, rising VP.
|
| /linux-4.1.27/Documentation/zh_CN/ |
| D | gpio.txt | 599 "edge" ... 读取得到“none”、“rising”、“falling”或者“both”。
606 翻转这个属性的(读写)值。已存在或之后通过"edge"属性设置了"rising"
|
| /linux-4.1.27/Documentation/devicetree/bindings/iio/adc/ |
| D | at91_adc.txt | 64 trigger-name = "external-rising";
|
| /linux-4.1.27/Documentation/sound/alsa/soc/ |
| D | DAI.txt | 56 o Mode B - MSB is transmitted on rising edge of FRAME/SYNC.
|
| /linux-4.1.27/Documentation/input/ |
| D | rotary-encoder.txt | 9 and by triggering on falling and rising edges, the turn direction can
|
| D | amijoy.txt | 68 the rising edge of SCLK. MLD output is used to parallel load
|
| /linux-4.1.27/Documentation/fb/ |
| D | ep93xx-fb.txt | 55 data on the rising edge.
|
| D | pxafb.txt | 58 0 => falling edge, 1 => rising edge
|
| /linux-4.1.27/Documentation/devicetree/bindings/usb/ |
| D | nvidia,tegra20-usb-phy.txt | 49 - nvidia,xcvr-lsrslew : LS rising slew rate control.
|
| /linux-4.1.27/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | mpc5200.txt | 136 sense mode; 1 for edge rising, 2 for edge falling.
194 'n' is sense (0: level high, 1: edge rising, 2: edge falling 3: level low)
|
| /linux-4.1.27/Documentation/devicetree/bindings/mfd/ |
| D | ab8500.txt | 43 : VBUS_DET_R : : VBUS rising detected
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | tegra114-roth.dts | 755 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_SLOW>;
764 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
773 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
|
| D | tegra124-venice2.dts | 442 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
451 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
461 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
|
| D | tegra114-dalmore.dts | 729 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_SLOW>;
738 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
747 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
|
| D | tegra30-cardhu.dtsi | 148 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FAST>;
|
| D | tegra20-whistler.dts | 254 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
|
| D | tegra20-ventana.dts | 274 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_SLOWEST>;
|
| D | tegra20-seaboard.dts | 277 nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_SLOWEST>;
|
| D | at91sam9x5.dtsi | 1004 trigger-name = "external-rising";
|
| D | at91sam9g45.dtsi | 1039 trigger-name = "external-rising";
|
| D | sama5d3.dtsi | 330 trigger-name = "external-rising";
|
| D | sama5d4.dtsi | 1104 trigger-name = "external-rising";
|
| D | tegra30-beaver.dts | 1718 nvidia,slew-rate-rising = <1>;
|
| /linux-4.1.27/Documentation/devicetree/bindings/bus/ |
| D | ti-gpmc.txt | 86 to the GPMC_CLK rising edge used by the
|
| /linux-4.1.27/drivers/pinctrl/nomadik/ |
| D | pinctrl-nomadik.c | 417 u32 rising = nmk_chip->rimsc & BIT(offset); in nmk_gpio_disable_lazy_irq() local
422 if (!rising && !falling) in nmk_gpio_disable_lazy_irq()
428 if (rising) { in nmk_gpio_disable_lazy_irq()
|
| /linux-4.1.27/Documentation/hwmon/ |
| D | adm9240 | 63 with independent fan speed measurement cycles counting alternating rising
|
| /linux-4.1.27/Documentation/devicetree/bindings/media/ |
| D | video-interfaces.txt | 89 - pclk-sample: sample data on rising (1) or falling (0) edge of the pixel clock
|
| /linux-4.1.27/Documentation/arm/pxa/ |
| D | mfp.txt | 164 Bit 4: EDGE_RISE_EN - enable detection of rising edge on this pin
|
| /linux-4.1.27/Documentation/ |
| D | IRQ-domain.txt | 11 show a rising tendency: for example subdrivers of different kinds
|
| D | workqueue.txt | 42 rising, some systems saturated the default 32k PID space just booting
|
| D | parport-lowlevel.txt | 1119 commonly generated on the rising edge of nAck.
|
| /linux-4.1.27/arch/mips/boot/dts/cavium-octeon/ |
| D | octeon_68xx.dts | 40 * 2) Triggering (1 - edge rising
|
| D | octeon_3xxx.dts | 39 * 2) Triggering (1 - edge rising
|
| /linux-4.1.27/Documentation/spi/ |
| D | spi-summary | 100 clock starts low, so the first (leading) edge is rising, and
124 and always clock data in/out on rising clock edges.
|