Searched refs:reconfigure (Results 1 – 25 of 25) sorted by relevance
18 don't have a laptop which needs to dynamically reconfigure to the
26 - input : Initially configure the GPIO line as an input. Only reconfigure
370 unsigned int reconfigure; /* new slave config? */ member570 bchan->reconfigure = 1; in bam_slave_config()875 bchan->reconfigure = 0; in bam_apply_new_config()906 if (bchan->reconfigure) in bam_start_dma()
82 The workaround is to reconfigure the dat1 line as a GPIO upon suspend. To make
134 In some cases it may be possible to reconfigure your SDRAM layout to
484 .reconfigure = tenxpress_phy_reconfigure,
486 .reconfigure = qt202x_phy_reconfigure,
551 .reconfigure = txc43128_phy_reconfigure,
1047 rc = efx->phy_op->reconfigure(efx); in efx_init_port()2429 if (efx->phy_op->reconfigure(efx)) in efx_reset_up()2685 .reconfigure = efx_port_dummy_op_int,3094 efx->phy_op->reconfigure(efx); in efx_pm_thaw()
735 int (*reconfigure) (struct efx_nic *efx); member
811 .reconfigure = efx_mcdi_port_reconfigure,
725 rc = efx->phy_op->reconfigure(efx); in efx_ethtool_set_pauseparam()
1488 efx->phy_op->reconfigure(efx); in falcon_reconfigure_port()
32 and copy the configuration that you wish to use to .config. Then reconfigure
445 option to reconfigure the adapter by selecting a different value for the system519 self-test. If so, reconfigure the adapter selecting another choice for the 524 the adapter and reconfigure it by installing it in another PC to run the
70 allow userspace to reconfigure this GPIO's direction.
689 allow userspace to reconfigure this GPIO's direction.
15 need to reconfigure pins at run-time, for example to tri-state pins when the
228 case. In order to avoid such condition, either disable/reconfigure/enable the
193 This option enables the ability to dynamically reconfigure target
308 o A reboot is required to reconfigure both adaptive idle and RCU
92 the snd-usb-audio module will reconfigure the device on the fly.
386 FPGA platforms to partially reconfigure the FPGA at runtime.
170 active. This will reconfigure the array. Otherwise it can only
299 systems to easily identify and reconfigure I/O ports, IRQs and DMAs of ISA