Searched refs:proximity (Results 1 – 21 of 21) sorted by relevance
16 BH1770GLC and SFH7770 are combined ambient light and proximity sensors.17 ALS and proximity parts operates on their own, but they shares common I2C19 but ALS side results are used to estimate reliability of the proximity sensor.25 amount of reflected IR light and produces proximity result. Resolution is27 reliability of the proximity results. Thus ALS is always running while28 proximity detection is needed.32 by using a delayed work. As long as there is proximity threshold above33 interrupts the delayed work is pushed forward. So, when proximity level goes35 finally run. This is handled as no proximity indication.86 RO - measured proximity value[all …]
16 APDS990x is a combined ambient light and proximity sensor. ALS and proximity18 while the proximity functionality is enabled.88 RO - measured proximity value95 RW - enable / disable proximity - uses counting logic96 1 enables the proximity97 0 disables the proximity101 values: 0 or prox0_sensor_range value. 0 means no proximity,102 1023 means proximity. This causes minimal number of interrupts.111 RW - threshold level which trigs proximity events.
7 tristate "ISL 29018 light and proximity sensor"13 proximity infrared sensing from Intersil ISL29018.15 in lux, proximity infrared sensing and normal infrared sensing.26 of ambient light and proximity.36 tristate "TAOS TSL/TMD2x71 and TSL/TMD2x72 Family of light and proximity sensors"
24 tristate "SX9500 Semtech proximity sensor"31 proximity/button sensor.
77 This option enables proximity & RGB sensor using91 Say Y here if you have a Sharp GP2AP020A00F proximity/ALS combo-chip138 tristate "JSA1212 ALS and proximity sensor driver"143 proximity & ALS sensor device.172 ambient light and proximity sensor.222 tristate "VCNL4000 combined ALS and proximity sensor"226 combined ambient light and proximity sensor.
42 in proximity mode. When this is enabled, then the device should44 proximity reading. If this is not enabled, the driver can still52 This property is supported by proximity sensors and should be
27 obj-y += proximity/
77 source "drivers/iio/proximity/Kconfig"
9 of the cm36651 for proximity detection.
3 The proximity detector sensor requires power supply
50 the proximity of the ADIN2 pin to the OV pin. ADIN2 is, however, not available
352 SFH7770 (Osram) combined ambient light and proximity sensor chip.358 tristate "APDS990X combined als and proximity sensors"363 combined ambient light and proximity sensor chip.
343 /* ALS and proximity sensor */
346 /* ALS and proximity sensor */
173 proximity of the device and while the value of the BTN_TOUCH code is 0. If
154 are in radio proximity to allow drivers to connect to them. As well, it
264 Say Y here if you have a Sharp GP2AP002A00F proximity/als combo-chip
660 !rtlpriv->proximity.proxim_on) { in rtl_op_config()
2613 struct proxim proximity; member
2219 rtlpriv->proximity.proxim_on = false; in rtl_pci_probe()
1168 to SI units is not possible. Higher proximity measurements