Searched refs:port3 (Results 1 – 12 of 12) sorted by relevance
| /linux-4.1.27/include/uapi/linux/ |
| D | serial.h | 88 int port3; member
|
| /linux-4.1.27/include/sound/ |
| D | emu8000.h | 71 unsigned long port3; /* Port usually at base+0x800 */ member
|
| D | emu8000_reg.h | 32 #define EMU8000_DATA3(e) ((e)->port3)
33 #define EMU8000_PTR(e) ((e)->port3+2)
|
| /linux-4.1.27/Documentation/devicetree/bindings/usb/ |
| D | pxa-usb.txt | 10 - "marvell,enable-port1", "marvell,enable-port2", "marvell,enable-port3"
|
| /linux-4.1.27/Documentation/networking/ |
| D | switchdev.txt | 13 port1 port2 port3 port4 MNGMNT | PCI-E |
|
| D | bonding.txt | 2073 |port3 port3|
2086 the outside world ("port3" on each switch). There is no technical
2117 example, in the above example, if the "port3" link fails at the remote
2119 monitor could be configured with a target at the remote end of port3,
2190 | Host A +------------+ switch |port3 +--------+
|
| /linux-4.1.27/sound/isa/sb/ |
| D | emu8000.c | 1108 hw->port3 = port + 0x800; in snd_emu8000_new()
1111 !(hw->res_port3 = request_region(hw->port3, 4, "Emu8000-3"))) { in snd_emu8000_new()
1112 …_printk(KERN_ERR "sbawe: can't grab ports 0x%lx, 0x%lx, 0x%lx\n", hw->port1, hw->port2, hw->port3); in snd_emu8000_new()
|
| /linux-4.1.27/Documentation/devicetree/bindings/net/ |
| D | keystone-netcp.txt | 78 - sgmii port3/4 module registers (only for NetCP 1.4)
84 index #1 - sgmii port3/4 module registers
|
| /linux-4.1.27/Documentation/devicetree/bindings/mfd/ |
| D | omap-usb-host.txt | 98 port3-mode = "ehci-phy";
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | omap5-uevm.dts | 617 port3-mode = "ehci-hsic";
|
| D | omap5-cm-t54.dts | 626 port3-mode = "ehci-hsic";
|
| /linux-4.1.27/drivers/net/ethernet/chelsio/cxgb3/ |
| D | t3_hw.c | 593 VPD_ENTRY(port3, 2); /* PHY3 complex */
|