Searched refs:ncs_write_pulse (Results 1 – 14 of 14) sorted by relevance
| /linux-4.1.27/arch/avr32/mach-at32ap/ |
| D | hsmc.c | 47 config->ncs_write_pulse = 0; in smc_set_timing()
80 if (timing->ncs_write_pulse > 0) in smc_set_timing()
81 config->ncs_write_pulse = ns2cyc(timing->ncs_write_pulse); in smc_set_timing()
120 cycle = config->ncs_write_setup + config->ncs_write_pulse + recover; in smc_set_timing()
153 | HSMC_BF(NCS_WR_PULSE, config->ncs_write_pulse) in smc_set_configuration()
|
| /linux-4.1.27/arch/avr32/mach-at32ap/include/mach/ |
| D | smc.h | 28 int ncs_write_pulse; member
56 u8 ncs_write_pulse; member
|
| /linux-4.1.27/arch/avr32/boards/hammerhead/ |
| D | flash.c | 44 .ncs_write_pulse = 65,
111 .ncs_write_pulse = 75, /* min. 26ns */
253 .ncs_write_pulse = 32,
|
| /linux-4.1.27/arch/arm/mach-at91/ |
| D | sam9_smc.c | 54 | AT91_SMC_NCS_WRPULSE_(config->ncs_write_pulse) in sam9_smc_cs_configure()
108 config->ncs_write_pulse = (val & AT91_SMC_NCS_WRPULSE) >> 8; in sam9_smc_cs_read()
|
| /linux-4.1.27/arch/avr32/boards/atngw100/ |
| D | flash.c | 26 .ncs_write_pulse = 65,
|
| D | setup.c | 62 .ncs_write_pulse = 30,
|
| /linux-4.1.27/arch/avr32/boards/atstk1000/ |
| D | flash.c | 26 .ncs_write_pulse = 65,
|
| D | atstk1002.c | 62 .ncs_write_pulse = 30,
|
| /linux-4.1.27/arch/avr32/boards/favr-32/ |
| D | flash.c | 26 .ncs_write_pulse = 65,
|
| /linux-4.1.27/arch/avr32/boards/merisc/ |
| D | flash.c | 26 .ncs_write_pulse = 8 * 14,
|
| /linux-4.1.27/arch/avr32/boards/mimc200/ |
| D | flash.c | 26 .ncs_write_pulse = 60,
|
| /linux-4.1.27/arch/arm/mach-at91/include/mach/ |
| D | at91sam9_smc.h | 30 u8 ncs_write_pulse; member
|
| /linux-4.1.27/drivers/ata/ |
| D | pata_at91.c | 252 smc.ncs_write_pulse = smc.ncs_read_pulse = cs_pulse; in set_smc_timing()
|
| D | pata_at32.c | 133 smc->ncs_write_pulse = smc->ncs_read_pulse; in pata_at32_setup_timing()
|