Searched refs:bank_id (Results 1 - 4 of 4) sorted by relevance

/linux-4.1.27/drivers/gpio/
H A Dgpio-bcm-kona.c87 int bank_id, u32 lockcode) bcm_kona_gpio_write_lock_regs()
90 writel(lockcode, reg_base + GPIO_PWD_STATUS(bank_id)); bcm_kona_gpio_write_lock_regs()
98 int bank_id = GPIO_BANK(gpio); bcm_kona_gpio_lock_gpio() local
102 val = readl(kona_gpio->reg_base + GPIO_PWD_STATUS(bank_id)); bcm_kona_gpio_lock_gpio()
104 bcm_kona_gpio_write_lock_regs(kona_gpio->reg_base, bank_id, val); bcm_kona_gpio_lock_gpio()
114 int bank_id = GPIO_BANK(gpio); bcm_kona_gpio_unlock_gpio() local
118 val = readl(kona_gpio->reg_base + GPIO_PWD_STATUS(bank_id)); bcm_kona_gpio_unlock_gpio()
120 bcm_kona_gpio_write_lock_regs(kona_gpio->reg_base, bank_id, val); bcm_kona_gpio_unlock_gpio()
129 int bank_id = GPIO_BANK(gpio); bcm_kona_gpio_set() local
146 reg_offset = value ? GPIO_OUT_SET(bank_id) : GPIO_OUT_CLEAR(bank_id); bcm_kona_gpio_set()
160 int bank_id = GPIO_BANK(gpio); bcm_kona_gpio_get() local
175 GPIO_IN_STATUS(bank_id) : GPIO_OUT_STATUS(bank_id); bcm_kona_gpio_get()
225 int bank_id = GPIO_BANK(gpio); bcm_kona_gpio_direction_output() local
238 reg_offset = value ? GPIO_OUT_SET(bank_id) : GPIO_OUT_CLEAR(bank_id); bcm_kona_gpio_direction_output()
327 int bank_id = GPIO_BANK(gpio); bcm_kona_gpio_irq_ack() local
336 val = readl(reg_base + GPIO_INT_STATUS(bank_id)); bcm_kona_gpio_irq_ack()
338 writel(val, reg_base + GPIO_INT_STATUS(bank_id)); bcm_kona_gpio_irq_ack()
348 int bank_id = GPIO_BANK(gpio); bcm_kona_gpio_irq_mask() local
357 val = readl(reg_base + GPIO_INT_MASK(bank_id)); bcm_kona_gpio_irq_mask()
359 writel(val, reg_base + GPIO_INT_MASK(bank_id)); bcm_kona_gpio_irq_mask()
369 int bank_id = GPIO_BANK(gpio); bcm_kona_gpio_irq_unmask() local
378 val = readl(reg_base + GPIO_INT_MSKCLR(bank_id)); bcm_kona_gpio_irq_unmask()
380 writel(val, reg_base + GPIO_INT_MSKCLR(bank_id)); bcm_kona_gpio_irq_unmask()
433 int bit, bank_id; bcm_kona_gpio_irq_handler() local
446 bank_id = bank->id; bcm_kona_gpio_irq_handler()
448 while ((sta = readl(reg_base + GPIO_INT_STATUS(bank_id)) & bcm_kona_gpio_irq_handler()
449 (~(readl(reg_base + GPIO_INT_MASK(bank_id)))))) { bcm_kona_gpio_irq_handler()
451 int hwirq = GPIO_PER_BANK * bank_id + bit; bcm_kona_gpio_irq_handler()
459 writel(readl(reg_base + GPIO_INT_STATUS(bank_id)) | bcm_kona_gpio_irq_handler()
460 BIT(bit), reg_base + GPIO_INT_STATUS(bank_id)); bcm_kona_gpio_irq_handler()
86 bcm_kona_gpio_write_lock_regs(void __iomem *reg_base, int bank_id, u32 lockcode) bcm_kona_gpio_write_lock_regs() argument
/linux-4.1.27/arch/sparc/kernel/
H A Dchmc.c74 int bank_id; member in struct:chmc_bank_info
558 bank_in_controller = bp->bank_id & (CHMCTRL_NBANKS - 1); chmc_print_dimm()
634 bp->bank_id = (CHMCTRL_NBANKS * p->portid) + which_bank; chmc_interpret_one_decode_reg()
/linux-4.1.27/drivers/pinctrl/
H A Dpinctrl-at91.c660 dev_err(info->dev, "%s: pin conf %d bank_id %d >= nbanks %d\n", pin_check_config()
666 dev_err(info->dev, "%s: pin conf %d bank_id %d not enabled\n", pin_check_config()
/linux-4.1.27/drivers/net/wireless/ath/ath10k/
H A Dhtt.h1167 struct htt_frag_desc_bank_id bank_id[HTT_FRAG_DESC_BANK_MAX]; member in struct:htt_frag_desc_bank_cfg

Completed in 444 milliseconds