| /linux-4.1.27/drivers/net/ethernet/seeq/ |
| D | ether3.c | 124 while ((ether3_inw(REG_STATUS) & STAT_FIFOEMPTY) == 0) { in ether3_setbuffer()
330 while (ether3_inw(REG_STATUS) & (STAT_RXON|STAT_TXON)) in ether3_init_for_open()
424 while (ether3_inw(REG_STATUS) & (STAT_RXON|STAT_TXON)) in ether3_close()
464 ether3_inw(REG_STATUS), ether3_inw(REG_CONFIG1), ether3_inw(REG_CONFIG2)); in ether3_timeout()
531 if (!(ether3_inw(REG_STATUS) & STAT_TXON)) { in ether3_sendpacket()
559 status = ether3_inw(REG_STATUS); in ether3_interrupt()
678 if (!(ether3_inw(REG_STATUS) & STAT_RXON)) { in ether3_rx()
|
| D | ether3.h | 47 #define REG_STATUS (priv(dev)->seeq + 0x0000) macro
|
| /linux-4.1.27/drivers/media/tuners/ |
| D | max2165_priv.h | 42 #define REG_STATUS 0x11 macro
|
| D | max2165.c | 240 max2165_read_reg(priv, REG_STATUS, &status); in max2165_debug_status()
|
| /linux-4.1.27/drivers/media/dvb-frontends/ |
| D | lgs8gl5.c | 50 #define REG_STATUS 0xa4 macro
217 val = lgs8gl5_read_reg(state, REG_STATUS); in lgs8gl5_start_demod()
256 u8 flags = lgs8gl5_read_reg(state, REG_STATUS); in lgs8gl5_read_status()
|
| /linux-4.1.27/drivers/spi/ |
| D | spi-efm32.c | 43 #define REG_STATUS 0x10 macro
179 efm32_spi_read32(ddata, REG_STATUS) & REG_STATUS_TXBL) { in efm32_spi_filltx()
230 efm32_spi_read32(ddata, REG_STATUS) & in efm32_spi_rxirq()
260 efm32_spi_read32(ddata, REG_STATUS)); in efm32_spi_txirq()
|
| D | spi-meson-spifc.c | 32 #define REG_STATUS 0x10 macro
|
| /linux-4.1.27/drivers/staging/mt29f_spinand/ |
| D | mt29f_spinand.h | 43 #define REG_STATUS 0xc0/* timing */ macro
|
| D | mt29f_spinand.c | 155 cmd.addr[0] = REG_STATUS; in spinand_read_status()
|
| /linux-4.1.27/drivers/mmc/host/ |
| D | moxart-mmc.c | 46 #define REG_STATUS 40 macro
187 *status = readl(host->base + REG_STATUS); in moxart_wait_for_status()
410 if (readl(host->base + REG_STATUS) & CARD_DETECT) { in moxart_request()
473 status = readl(host->base + REG_STATUS); in moxart_irq()
547 return !!(readl(host->base + REG_STATUS) & WRITE_PROT); in moxart_get_ro()
|
| /linux-4.1.27/drivers/net/usb/ |
| D | net1080.c | 99 #define REG_STATUS ((u8)0x11) macro
288 if ((retval = nc_register_read(dev, REG_STATUS, &vp)) < 0) { in net1080_reset()
332 retval = nc_register_read(dev, REG_STATUS, &vp); in net1080_check_connect()
|
| /linux-4.1.27/drivers/pwm/ |
| D | pwm-vt8500.c | 43 #define REG_STATUS 0x40 macro
72 while ((readl(vt8500->base + REG_STATUS) & mask) && --loops) in pwm_busy_wait()
|
| /linux-4.1.27/drivers/power/ |
| D | sbs-battery.c | 42 REG_STATUS, enumerator
110 [REG_STATUS] =
694 ret = sbs_read_word_data(chip->client, sbs_data[REG_STATUS].addr); in sbs_delayed_work()
891 rc = sbs_read_word_data(client, sbs_data[REG_STATUS].addr); in sbs_probe()
|
| /linux-4.1.27/drivers/i2c/busses/ |
| D | i2c-efm32.c | 63 #define REG_STATUS 0x0c macro
277 efm32_i2c_read32(ddata, REG_STATUS)); in efm32_i2c_master_xfer()
|
| /linux-4.1.27/drivers/crypto/qce/ |
| D | regs-v5.h | 20 #define REG_STATUS 0x100 macro
|
| D | common.c | 221 qce_write(qce, REG_STATUS, 0); in qce_setup_config()
416 *status = qce_read(qce, REG_STATUS); in qce_check_status()
|
| /linux-4.1.27/drivers/media/i2c/s5c73m3/ |
| D | s5c73m3.h | 80 #define REG_STATUS S5C73M3_REG(0x0009, 0x5080) macro
|
| D | s5c73m3-core.c | 255 ret = s5c73m3_read(state, REG_STATUS, &status); in s5c73m3_check_status()
300 return s5c73m3_write(state, REG_STATUS, 0x0001); in s5c73m3_isp_command()
|
| /linux-4.1.27/drivers/tty/serial/ |
| D | crisv10.c | 181 #define REG_STATUS 1 macro
935 #define E100_CTS_GET(info) ((info)->ioport[REG_STATUS] & E100_CTS_MASK)
1833 rstat = info->ioport[REG_STATUS]; in receive_chars_dma()
1994 unsigned char rstat = info->ioport[REG_STATUS]; in force_eop_if_needed()
2311 rstat = info->ioport[REG_STATUS]; in handle_ser_rx_interrupt()
2425 rstat = info->ioport[REG_STATUS]; in handle_ser_tx_interrupt()
2442 rstat = info->ioport[REG_STATUS]; in handle_ser_tx_interrupt()
3021 count, info->ioport[REG_STATUS]); in rs_raw_write()
4124 unsigned char rstat = info->ioport[REG_STATUS]; in seq_line_info()
|
| /linux-4.1.27/drivers/scsi/ |
| D | eata.c | 578 #define REG_STATUS 7 macro
1015 while (!(inb(iobase + REG_STATUS) & DRQ_ASSERTED)) { in read_pio()
2305 reg = inb(shost->io_port + REG_STATUS); in ihdlr()
2321 reg = inb(shost->io_port + REG_STATUS); in ihdlr()
|
| /linux-4.1.27/drivers/usb/storage/ |
| D | isd200.c | 152 #define REG_STATUS 0x80 macro
510 REG_STATUS | REG_ERROR; in isd200_action()
|
| /linux-4.1.27/drivers/block/paride/ |
| D | ppc6lnx.c | 51 #define REG_STATUS 0x00 // status register macro
|
| /linux-4.1.27/drivers/media/platform/soc_camera/ |
| D | omap1_camera.c | 54 #define REG_STATUS 0x0C macro
|