Searched refs:PSM (Results 1 - 42 of 42) sorted by relevance

/linux-4.1.27/drivers/media/tuners/
H A Dtda18218_priv.h34 #define R08_PSM1 0x08 /* PSM byte 1 */
55 #define R1D_PSM2 0x1d /* PSM byte 2 */
56 #define R1E_PSM3 0x1e /* PSM byte 3 */
57 #define R1F_PSM4 0x1f /* PSM byte 4 */
/linux-4.1.27/drivers/net/wireless/iwlwifi/mvm/
H A Dfw-api-power.h168 * PSM transition - legacy PM
170 * PSM transition - legacy PM
227 * PSM transition - legacy PM
229 * PSM transition - legacy PM
235 * PSM transition - uAPSD
237 * PSM transition - uAPSD
/linux-4.1.27/drivers/net/wireless/ti/wlcore/
H A Dconf.h152 * in WLAN PSM / BT master/slave BR
161 * in WLAN PSM / BT master/slave EDR
239 * Defines whether the SG will force WLAN host to enter/exit PSM
241 * Range: 1 - SG can force, 0 - host handles PSM
944 * Specifies the maximum number of times to try PSM entry if it fails
952 * Specifies the maximum number of times to try PSM exit if it fails
960 * Specifies the maximum number of times to try transmit the PSM entry
961 * null-func frame for each PSM entry attempt
974 * Specifies whether dynamic PS should be disabled and PSM forced.
H A Dps.c286 wl1271_debug(DEBUG_PSM, "start mac80211 PSM on hlid %d pkts %d " wl12xx_ps_link_start()
317 wl1271_debug(DEBUG_PSM, "end mac80211 PSM on hlid %d", hlid); wl12xx_ps_link_end()
H A Dwlcore_i.h423 /* retry counter for PSM entries */
H A Ddebugfs.c299 /* In case we're already in PSM, trigger it again to set new timeout dynamic_ps_timeout_write()
366 /* In case we're already in PSM, trigger it again to switch mode forced_ps_write()
H A Dacx.h124 /* illegal out of band value of PSM mode */
H A Dtx.c140 * connected to the AP. Otherwise the FW would not set the PSM bit. wl1271_tx_regulate_link()
H A Dmain.c365 * connected to the AP. Otherwise the FW would not set the PSM bit. wl12xx_irq_ps_regulate_link()
/linux-4.1.27/drivers/net/wireless/ath/carl9170/
H A Dfwdesc.h66 /* Firmware PSM support | CARL9170_CMD_PSM */
75 /* Firmware supports PSM in the 5GHZ Band */
H A Ddebug.c384 "FORCE CAM" : (ar->ps.state ? "PSM" : "CAM"))); carl9170_debugfs_sta_psm_read()
389 ADD(buf, *len, bufsize, "last CAM->PSM transition: %d ms ago.\n", carl9170_debugfs_sta_psm_read()
H A Dcarl9170.h442 /* PSM */
/linux-4.1.27/drivers/net/ethernet/marvell/
H A Dsky2.h203 PSM_CONFIG_REG1_EN_GPHY_INT_PSM = 1<<20, /* Enable GPHY INT for PSM */
204 PSM_CONFIG_REG1_DIS_PSM_TIMER = 1<<19, /* Disable PSM Timer */
222 PSM_CONFIG_REG1_PSM_PCIE_L1_POL = 1<<18, /* PCIE L1 Event Polarity for PSM */
223 PSM_CONFIG_REG1_TIMER_STAT = 1<<17, /* PSM Timer Status */
231 PSM_CONFIG_REG1_DIS_LOADER = 1<<9, /* Disable Loader SM after PSM Goes back to IDLE */
232 PSM_CONFIG_REG1_DO_PWDN = 1<<8, /* Do Power Down, Start PSM Scheme */
233 PSM_CONFIG_REG1_DIS_PIG = 1<<7, /* Disable Plug-in-Go SM after PSM Goes back to IDLE */
234 PSM_CONFIG_REG1_DIS_PERST = 1<<6, /* Disable Internal PCIe Reset after PSM Goes back to IDLE */
235 PSM_CONFIG_REG1_EN_REG18_PD = 1<<5, /* Enable REG18 Power Down for PSM */
236 PSM_CONFIG_REG1_EN_PSM_LOAD = 1<<4, /* Disable EEPROM Loader after PSM Goes back to IDLE */
237 PSM_CONFIG_REG1_EN_PSM_HOT_RST = 1<<3, /* Enable PCIe Hot Reset for PSM */
238 PSM_CONFIG_REG1_EN_PSM_PERST = 1<<2, /* Enable PCIe Reset Event for PSM */
239 PSM_CONFIG_REG1_EN_PSM_PCIE_L1 = 1<<1, /* Enable PCIe L1 Event for PSM */
240 PSM_CONFIG_REG1_EN_PSM = 1<<0, /* Enable PSM Scheme */
243 /* PSM_CONFIG_REG4 0x0168 PSM Config Register 4 */
428 Y2_IS_PSM_ACK = 1<<7, /* PSM Acknowledge (Yukon-Optima only) */
/linux-4.1.27/drivers/net/wireless/ti/wl1251/
H A Devent.c59 wl1251_debug(DEBUG_PSM, "PSM entry failed"); wl1251_event_ps_report()
H A Dwl1251.h373 /* PSM mode requested */
376 /* retry counter for PSM entries */
H A Dmain.c678 * mac80211 enables PSM only if we're already associated. wl1251_op_config()
/linux-4.1.27/arch/powerpc/platforms/52xx/
H A Dlite5200.c138 * USB Rh descriptor A: NPS = 0, PSM = 0 */ lite5200_suspend_prepare()
/linux-4.1.27/drivers/net/wireless/prism54/
H A Dislpci_dev.h117 dma_addr_t device_psm_buffer; /* host memory for PSM buffering (bus address) */
/linux-4.1.27/drivers/net/wireless/ti/wl18xx/
H A Dacx.c200 * When the host is suspended, we don't want to get any fast-link/PSM
H A Dacx.h334 * enable/disable fast-link/PSM notification from FW
/linux-4.1.27/drivers/net/wireless/brcm80211/brcmsmac/
H A Dd11.h241 /* PSM Block *//* 0x480 - 0x500 */
506 /* non-specific gen-stat bits that are set by PSM */
508 /* non-specific gen-stat bits that are set by PSM */
512 /* non-specific gen-stat bits that are set by PSM */
976 /* PSM Block */
1552 /* PSM SHM variable offsets */
H A Dmain.c592 * The PSM needs to be suspended for this call.
1385 /* IHR accesses are always enabled, PSM disabled, HPS off and WAKE on */ brcms_c_mctrl_reset()
3172 * reset PSM
3193 /* reset PSM */ brcms_b_coreinit()
3202 /* let the PSM run to the suspended state, set mode to BSS STA */ brcms_b_coreinit()
3324 /* write retry limits to SCR, this done after PSM init */ brcms_b_coreinit()
7832 brcms_err(core, "wl%d: PSM microcode watchdog fired at %d " brcms_c_dpc()
7835 printk_once("%s : PSM Watchdog, chipid 0x%x, chiprev 0x%x\n", brcms_c_dpc()
/linux-4.1.27/net/bluetooth/
H A Dl2cap_sock.c56 /* PSM must be odd and lsb of upper byte must be 0 */ l2cap_validate_bredr_psm()
73 /* Restrict fixed, SIG assigned PSM values to CAP_NET_BIND_SERVICE */ l2cap_validate_le_psm()
H A Dl2cap_core.c6866 /* Store remote BD_ADDR and PSM for msg_name */ l2cap_conless_channel()
7022 /* PSM must be odd and lsb of upper byte must be 0 */ is_valid_psm()
/linux-4.1.27/drivers/infiniband/hw/qib/
H A Dqib_init.c77 "0 -> PSM allocation close to HCA, 1 -> PSM allocation local to process");
184 if (ctxt < dd->first_user_ctxt) { /* N/A for PSM contexts */ qib_create_ctxtdata()
H A Dqib_tx.c467 * Tell PSM to disarm buffers again before trying to reuse them. qib_cancel_sends()
H A Dqib_user_sdma.c71 u16 frag_size; /* frag size used by PSM */
426 * If running this driver under PSM with message size qib_user_sdma_page_to_frags()
H A Dqib_common.h704 /* fields below are simplified, but should match PSM */
H A Dqib.h886 * number of ctxts available for PSM open
/linux-4.1.27/drivers/net/wireless/b43legacy/
H A Dmain.c1697 /* Jump the microcode PSM to offset 0 */ b43legacy_upload_microcode()
1702 /* Zero out all microcode PSM registers and shared memory. */ b43legacy_upload_microcode()
1739 /* Start the microcode PSM */ b43legacy_upload_microcode()
3219 /* Stop the microcode PSM. */ b43legacy_wireless_core_exit()
/linux-4.1.27/drivers/usb/host/
H A Dohci-dbg.c210 (temp & RH_A_PSM) ? " PSM" : "", ohci_dump_roothub()
/linux-4.1.27/include/net/bluetooth/
H A Dl2cap.h247 /* protocol/service multiplexer (PSM) */
/linux-4.1.27/drivers/net/wireless/b43/
H A Db43.h281 #define B43_SHM_SH_PSM 0x05F4 /* PSM transmitter address match block (rev < 5) */
366 #define B43_HF_TSSIRPSMW 0x000000000200ULL /* TSSI reset PSM ucode workaround */
H A Dmain.c2629 /* Jump the microcode PSM to offset 0 */ b43_upload_microcode()
2634 /* Zero out all microcode PSM registers and shared memory. */ b43_upload_microcode()
2665 /* Start the microcode PSM */ b43_upload_microcode()
2759 /* Stop the microcode PSM. */ b43_upload_microcode()
4815 /* Stop the microcode PSM. */ b43_wireless_core_exit()
/linux-4.1.27/arch/blackfin/mach-bf533/include/mach/
H A DdefBF532.h802 #define PSM 0x00400000 /* SDRAM power-up sequence = Precharge, mode register set, 8 CBR refresh cycles */ macro
/linux-4.1.27/arch/blackfin/mach-bf518/include/mach/
H A DdefBF512.h1005 #define PSM 0x00400000 /* Power-Up Sequence (Mode Register Before/After* Refresh) */ macro
/linux-4.1.27/arch/blackfin/mach-bf527/include/mach/
H A DdefBF522.h1006 #define PSM 0x00400000 /* Power-Up Sequence (Mode Register Before/After* Refresh) */ macro
/linux-4.1.27/arch/blackfin/mach-bf537/include/mach/
H A DdefBF534.h1327 #define PSM 0x00400000 /* Power-Up Sequence (Mode Register Before/After* Refresh) */ macro
/linux-4.1.27/arch/blackfin/mach-bf561/include/mach/
H A DdefBF561.h1344 #define PSM 0x00400000 /* SDRAM power-up sequence = Precharge, mode register set, 8 CBR refresh cycles */ macro
/linux-4.1.27/arch/blackfin/mach-bf538/include/mach/
H A DdefBF538.h1719 #define PSM 0x00400000 /* SDRAM power-up sequence = Precharge, mode register set, 8 CBR refresh cycles */ macro
/linux-4.1.27/net/mac80211/
H A Dmlme.c1487 * Go to full PSM if the user configures a very low ieee80211_recalc_ps()
/linux-4.1.27/include/net/
H A Dmac80211.h3070 * channel. We must stay on the channel (no PSM, scan, etc.), since a TDLS

Completed in 2519 milliseconds