| /linux-4.1.27/include/video/ |
| H A D | omap-panel-data.h | 39 * @data_lines: number of DPI datalines
105 * @data_lines: number of DPI datalines
169 * @data_lines: number of DPI datalines
187 * @data_lines: number of DPI datalines
211 * @data_lines: number of DPI datalines
227 * @data_lines: number of DPI datalines
245 * @data_lines: number of DPI datalines
|
| H A D | mipi_display.h | 3 * Display Working Group standards: DSI, DCS, DBI, DPI
|
| /linux-4.1.27/Documentation/EDID/ |
| H A D | 800x600.S | 33 #define DPI 72 define
|
| H A D | 1024x768.S | 36 #define DPI 72 define
|
| H A D | 1280x1024.S | 36 #define DPI 72 define
|
| H A D | 1600x1200.S | 36 #define DPI 72 define
|
| H A D | 1680x1050.S | 36 #define DPI 96 define
|
| H A D | 1920x1080.S | 36 #define DPI 96 define
|
| H A D | edid.S | 54 #define xsize pixdpi2mm(XPIX,DPI)
55 #define ysize pixdpi2mm(YPIX,DPI)
|
| /linux-4.1.27/drivers/gpu/drm/gma500/ |
| H A D | mdfld_tpo_vid.c | 104 /*TPO DPI encoder helper funcs*/
114 /*TPO DPI encoder funcs*/
|
| H A D | mdfld_dsi_dpi.h | 65 /* MDFLD DPI helper functions */
|
| H A D | mdfld_dsi_dpi.c | 87 DRM_ERROR("MIPI: DPI FIFO was never cleared\n"); mdfld_wait_for_DPI_CTRL_FIFO()
184 dev_err(dev->dev, "DPI panel is already off\n"); mdfld_dsi_configure_down()
205 dev_err(dev->dev, "DPI panel is already on\n"); mdfld_dsi_configure_up()
521 /*set DPI timing registers*/ mdfld_dsi_dpi_controller_init()
891 /* set up DSI controller DPI interface */ mdfld_dsi_dpi_mode_set()
898 /*turn on DPI interface*/ mdfld_dsi_dpi_mode_set()
927 * Init DSI DPI encoder.
929 * return pointer of newly allocated DPI encoder, NULL on error
|
| H A D | mdfld_tmd_vid.c | 179 /*TPO DPI encoder helper funcs*/
189 /*TPO DPI encoder funcs*/
|
| H A D | mdfld_dsi_pkg_sender.c | 66 "DPI FIFO Under run",
648 * For video mode, don't enable DPI timing output here, mdfld_dsi_pkg_sender_init()
649 * will init the DPI timing output during mode setting. mdfld_dsi_pkg_sender_init()
|
| H A D | mdfld_device.c | 164 * Notes: FIXME_JLIU7 need to add the support for DPI MIPI & HDMI audio
238 * Notes: FIXME_JLIU7 need to add the support for DPI MIPI & HDMI audio
|
| H A D | mdfld_dsi_output.c | 593 DRM_ERROR("Create DPI encoder failed\n"); mdfld_dsi_output_init()
|
| H A D | psb_intel_reg.h | 918 /* DPI PIXEL FORMATS */
1175 * Bits D[6:4] DPI Pixel Format Definition
|
| /linux-4.1.27/drivers/video/fbdev/omap2/displays-new/ |
| H A D | encoder-tfp410.c | 2 * TFP410 DPI-to-DVI encoder driver
319 MODULE_DESCRIPTION("TFP410 DPI to DVI encoder driver");
|
| H A D | panel-dpi.c | 2 * Generic MIPI DPI Panel Driver
336 MODULE_DESCRIPTION("Generic MIPI DPI Panel Driver");
|
| /linux-4.1.27/arch/m68k/mm/ |
| H A D | memory.c | 152 /* RZ: cpush %bc DOES invalidate %ic, regardless of DPI */ push040()
191 * the DPI bit in the CACR; would it cause problems with temporarily changing
|
| /linux-4.1.27/include/drm/ |
| H A D | drm_dp_helper.h | 38 * DPI: DisplayPort Interoperability Guideline v1.1a
42 * 1.2 formally includes both eDP and DPI definitions.
88 # define DP_DETAILED_CAP_INFO_AVAILABLE (1 << 4) /* DPI */
106 #define DP_I2C_SPEED_CAP 0x00c /* DPI */
284 #define DP_I2C_SPEED_CONTROL_STATUS 0x109 /* DPI */
|
| /linux-4.1.27/drivers/video/fbdev/omap2/dss/ |
| H A D | dpi.c | 23 #define DSS_SUBSYS_NAME "DPI"
74 * XXX we can't currently use DSI PLL for DPI with OMAP3, as the DSI PLL dpi_get_pll()
75 * would also be used for DISPC fclk. Meaning, when the DPI output is dpi_get_pll()
617 * Return a hardcoded channel for the DPI output. This should work for
|
| H A D | dss.h | 351 /* DPI */
|
| /linux-4.1.27/arch/mips/include/asm/octeon/ |
| H A D | octeon-feature.h | 78 * access. Newer chips replaced this with SLI+DPI.
|
| /linux-4.1.27/net/sched/ |
| H A D | cls_rsvp.h | 27 DPI(="Destination Port ID"): triple (key, mask, offset).
46 resources. But DPI and SPI add the possibility to assign different
60 F.e. DPI can select ETH_P_IP (and necessary flags to make
|
| /linux-4.1.27/drivers/gpu/drm/i915/ |
| H A D | intel_dsi.c | 59 DRM_ERROR("DPI FIFOs are not empty\n"); wait_for_dsi_fifo_empty()
603 /* Due to some hardware limitations on BYT, MIPI Port C DPI intel_dsi_get_hw_state()
817 * In burst mode, value greater than one DPI line Time in byte intel_dsi_prepare()
821 * In non-burst mode, Value greater than one DPI frame time in intel_dsi_prepare()
|
| /linux-4.1.27/arch/arm/mach-omap2/ |
| H A D | display.c | 371 /* Create devices for DPI and SDI */ omap_display_init()
|
| /linux-4.1.27/drivers/video/fbdev/ |
| H A D | amba-clcd.c | 592 /* Only directly connected DPI panels supported for now */ clcdfb_of_get_mode()
|
| /linux-4.1.27/drivers/mfd/ |
| H A D | db8500-prcmu.c | 560 /* DPI 50000000 Hz */
|