Chapter 5. API reference

Table of Contents

struct pre_voltage_change_data — Data sent with PRE_VOLTAGE_CHANGE event

struct regulator_bulk_data — Data used for bulk regulator operations.

struct regulator_state — regulator state during low power system states

struct regulation_constraints — regulator operating constraints.

struct regulator_consumer_supply — supply -> device mapping

struct regulator_init_data — regulator platform initialisation data.

struct regulator_linear_range — specify linear voltage ranges

struct regulator_ops — regulator operations.

struct regulator_desc — Static regulator descriptor

struct regulator_config — Dynamic regulator descriptor

regulator_get — lookup and obtain a reference to a regulator.

regulator_get_exclusive — obtain exclusive access to a regulator.

regulator_get_optional — obtain optional access to a regulator.

regulator_put — "free" the regulator source

regulator_register_supply_alias — Provide device alias for supply lookup

regulator_unregister_supply_alias — Remove device alias

regulator_bulk_register_supply_alias — register multiple aliases

regulator_bulk_unregister_supply_alias — unregister multiple aliases

regulator_enable — enable regulator output

regulator_disable — disable regulator output

regulator_force_disable — force disable regulator output

regulator_disable_deferred — disable regulator output with delay

regulator_is_enabled — is the regulator output enabled

regulator_can_change_voltage — check if regulator can change voltage

regulator_count_voltages count regulator_list_voltage selectors

regulator_list_voltage — enumerate supported voltages

regulator_get_hardware_vsel_register — get the HW voltage selector register

regulator_list_hardware_vsel — get the HW-specific register value for a selector

regulator_get_linear_step — return the voltage step size between VSEL values

regulator_is_supported_voltage — check if a voltage range can be supported

regulator_set_voltage — set regulator output voltage

regulator_set_voltage_time — get raise/fall time

regulator_set_voltage_time_sel — get raise/fall time

regulator_sync_voltage — re-apply last regulator output voltage

regulator_get_voltage — get regulator output voltage

regulator_set_current_limit — set regulator output current limit

regulator_get_current_limit — get regulator output current

regulator_set_mode — set regulator operating mode

regulator_get_mode — get regulator operating mode

regulator_set_load — set regulator load

regulator_allow_bypass — allow the regulator to go into bypass mode

regulator_register_notifier — register regulator event notifier

regulator_unregister_notifier — unregister regulator event notifier

regulator_bulk_get — get multiple regulator consumers

regulator_bulk_enable — enable multiple regulator consumers

regulator_bulk_disable — disable multiple regulator consumers

regulator_bulk_force_disable — force disable multiple regulator consumers

regulator_bulk_free — free multiple regulator consumers

regulator_notifier_call_chain — call regulator event notifier

regulator_mode_to_status — convert a regulator mode into a status

regulator_register — register regulator

regulator_unregister — unregister regulator

regulator_suspend_prepare — prepare regulators for system wide suspend

regulator_suspend_finish — resume regulators from system wide suspend

regulator_has_full_constraints — the system has fully specified constraints

rdev_get_drvdata — get rdev regulator driver data

regulator_get_drvdata — get regulator driver data

regulator_set_drvdata — set regulator driver data

rdev_get_id — get regulator ID