enum wiphy_flags — wiphy capability flags
enum wiphy_flags {
WIPHY_FLAG_NETNS_OK,
WIPHY_FLAG_PS_ON_BY_DEFAULT,
WIPHY_FLAG_4ADDR_AP,
WIPHY_FLAG_4ADDR_STATION,
WIPHY_FLAG_CONTROL_PORT_PROTOCOL,
WIPHY_FLAG_IBSS_RSN,
WIPHY_FLAG_MESH_AUTH,
WIPHY_FLAG_SUPPORTS_SCHED_SCAN,
WIPHY_FLAG_SUPPORTS_FW_ROAM,
WIPHY_FLAG_AP_UAPSD,
WIPHY_FLAG_SUPPORTS_TDLS,
WIPHY_FLAG_TDLS_EXTERNAL_SETUP,
WIPHY_FLAG_HAVE_AP_SME,
WIPHY_FLAG_REPORTS_OBSS,
WIPHY_FLAG_AP_PROBE_RESP_OFFLOAD,
WIPHY_FLAG_OFFCHAN_TX,
WIPHY_FLAG_HAS_REMAIN_ON_CHANNEL,
WIPHY_FLAG_SUPPORTS_5_10_MHZ,
WIPHY_FLAG_HAS_CHANNEL_SWITCH
}; if not set, do not allow changing the netns of this wiphy at all
if set to true, powersave will be enabled
by default -- this flag will be set depending on the kernel's default
on wiphy_new, but can be changed by the driver if it has a good
reason to override the default
supports 4addr mode even on AP (with a single station on a VLAN interface)
supports 4addr mode even as a station
This device supports setting the control port protocol ethertype. The device also honours the control_port_no_encrypt flag.
The device supports IBSS RSN.
The device supports mesh authentication by routing
auth frames to userspace. See NL80211_MESH_SETUP_USERSPACE_AUTH.
The device supports scheduled scans.
The device supports roaming feature in the firmware.
The device supports uapsd on AP.
The device supports TDLS (802.11z) operation.
The device does not handle TDLS (802.11z)
link setup/discovery operations internally. Setup, discovery and
teardown packets should be sent through the NL80211_CMD_TDLS_MGMT
command. When this flag is not set, NL80211_CMD_TDLS_OPER should be
used for asking the driver/firmware to perform a TDLS operation.
device integrates AP SME
the device will report beacons from other BSSes
when there are virtual interfaces in AP mode by calling
cfg80211_report_obss_beacon.
When operating as an AP, the device responds to probe-requests in hardware.
Device supports direct off-channel TX.
Device supports remain-on-channel call.
Device supports 5 MHz and 10 MHz channels.
Device supports channel switch in beaconing mode (AP, IBSS, Mesh, ...).