Lines Matching refs:LCD

2 # Backlight & LCD drivers configuration
6 	bool "Backlight & LCD device support"
9 	  backlight and the LCD panel on some platforms, for example on PDAs.
14 # LCD
17         tristate "Lowlevel LCD controls"
20 	  This framework adds support for low-level control of LCD.
21 	  Some framebuffer devices connect to platform-specific LCD modules
23 	  (contrast and applying power to the LCD (not to the backlight!)).
25 	  To have support for your specific LCD panel you will have to
31 	tristate "LCD Panel support for SHARP corgi/spitz model"
34 	  Say y here to support the LCD panels usually found on SHARP
38 	tristate "Epson L4F00242T03 LCD"
43 	  for init and powering the LCD up/down through a sysfs interface.
46 	tristate "Samsung LMS283GF05 LCD"
51 	  for powering the LCD up/down through a sysfs interface.
54 	tristate "Samsung LTV350QV LCD Panel"
57 	  If you have a Samsung LTV350QV LCD panel, say y to include a
79 	tristate "Toppoly TDO24M  and TDO35S LCD Panels support"
82 	  If you have a Toppoly TDO24M/TDO35S series LCD panel, say y here to
94 	tristate "Platform LCD controls"
96 	  This driver provides a platform-device registered LCD power
100 	tristate "Sharp SL-6000 LCD Driver"
104 	  for its LCD.
107 	tristate "HP Jornada 700 series LCD Driver"
112 	  say Y to enable LCD control driver.
115 	tristate "S6E63M0 AMOLED LCD Driver"
119 	  If you have an S6E63M0 LCD Panel, say Y to enable its
120 	  LCD control driver.
123 	tristate "LD9040 AMOLED LCD Driver"
131 	tristate "AMS369FG06 AMOLED LCD Driver"
136 	  LCD control driver.
139 	tristate "LMS501KF03 LCD Driver"
143 	  If you have an LMS501KF03 LCD Panel, say Y to enable its
144 	  LCD control driver.
147 	tristate "Himax HX-8357 LCD Driver"
150 	  If you have a HX-8357 LCD panel, say Y to enable its LCD control
162 	  This framework adds support for low-level control of the LCD
165 	  To have support for your specific LCD panel you will have to
175 	  driver.  If the LCD "contrast control" on your board is wired
186 	  If you have a LCD backlight connected to the BRIGHT output of
222 	tristate "Sharp LOCOMO LCD/Backlight Driver"
227 	  enable the LCD/backlight driver.
230 	tristate "OMAP1 PWL-based LCD Backlight"
234 	  This driver controls the LCD backlight level and power for
265 	  If you have a LCD backlight adjustable by PWM, say Y to enable
272 	  If you have a LCD backlight connected to the WLED output of DA9030
285 	  If you have a LCD backlight connected to the WLED output of MAX8925
327 	  If you have a LCD backlight connected to the BST/BL_SNK output of
339 	  If you have a LCD backlight connected to the ADP8860, ADP8861 or
351 	  If you have a LCD backlight connected to the ADP8870,
448 	  If you have a LCD backlight adjustable by GPIO, say Y to enable