1358 	struct device *hub_dev = hub->intfdev;  in hub_configure()  local
1406 	dev_info(hub_dev, "%d port%s detected\n", maxchild,  in hub_configure()
1434 		dev_dbg(hub_dev, "compound device; port removable status: %s\n", portstr);  in hub_configure()
1436 		dev_dbg(hub_dev, "standalone hub\n");  in hub_configure()
1440 		dev_dbg(hub_dev, "ganged power switching\n");  in hub_configure()
1443 		dev_dbg(hub_dev, "individual port power switching\n");  in hub_configure()
1447 		dev_dbg(hub_dev, "no power switching (usb 1.0)\n");  in hub_configure()
1453 		dev_dbg(hub_dev, "global over-current protection\n");  in hub_configure()
1456 		dev_dbg(hub_dev, "individual port over-current protection\n");  in hub_configure()
1460 		dev_dbg(hub_dev, "no over-current protection\n");  in hub_configure()
1471 		dev_dbg(hub_dev, "Single TT\n");  in hub_configure()
1477 			dev_dbg(hub_dev, "TT per port\n");  in hub_configure()
1480 			dev_err(hub_dev, "Using single TT (err %d)\n",  in hub_configure()
1488 		dev_dbg(hub_dev, "Unrecognized hub protocol %d\n",  in hub_configure()
1498 			dev_dbg(hub_dev, "TT requires at most %d "  in hub_configure()
1505 		dev_dbg(hub_dev, "TT requires at most %d "  in hub_configure()
1511 		dev_dbg(hub_dev, "TT requires at most %d "  in hub_configure()
1517 		dev_dbg(hub_dev, "TT requires at most %d "  in hub_configure()
1526 		dev_dbg(hub_dev, "Port indicators are supported\n");  in hub_configure()
1529 	dev_dbg(hub_dev, "power on to power good time: %dms\n",  in hub_configure()
1556 		dev_dbg(hub_dev, "hub controller current requirement: %dmA\n",  in hub_configure()
1561 			dev_warn(hub_dev,  in hub_configure()
1572 		dev_dbg(hub_dev, "%umA bus power budget for each child\n",  in hub_configure()
1583 		dev_dbg(hub_dev, "local power source is %s\n",  in hub_configure()
1588 		dev_dbg(hub_dev, "%sover-current condition exists\n",  in hub_configure()
1654 	dev_err(hub_dev, "config failed, %s (err %d)\n",  in hub_configure()
5044 	struct device *hub_dev;  in hub_event()  local
5051 	hub_dev = hub->intfdev;  in hub_event()
5052 	intf = to_usb_interface(hub_dev);  in hub_event()
5054 	dev_dbg(hub_dev, "state %d ports %d chg %04x evt %04x\n",  in hub_event()
5076 		dev_dbg(hub_dev, "Can't autoresume: %d\n", ret);  in hub_event()
5085 		dev_dbg(hub_dev, "resetting for error %d\n", hub->error);  in hub_event()
5089 			dev_dbg(hub_dev, "error resetting hub: %d\n", ret);  in hub_event()
5126 		dev_err(hub_dev, "get_hub_status failed\n");  in hub_event()
5129 			dev_dbg(hub_dev, "power change\n");  in hub_event()
5141 			dev_dbg(hub_dev, "over-current change\n");  in hub_event()
5147 				dev_err(hub_dev, "over-current condition\n");  in hub_event()