Lines Matching refs:DEBC_printk
318 #define DEBC_printk(t, fmt, a...) \ macro
321 #define DEBC_printk(t, fmt, a...) macro
738 DEBC_printk(STp, "Stepping over filemark %s.\n", in cross_eof()
776 DEBC_printk(STp, "Flushing %d bytes.\n", transfer); in st_flush_write_buffer()
920 DEBC_printk(STp, "%socking drive door.\n", do_lock ? "L" : "Unl"); in do_door_lock()
1053 DEBC_printk(STp, "Mode change from %d to %d.\n", in check_tape()
1130 DEBC_printk(STp, "Can't read block limits.\n"); in check_tape()
1147 DEBC_printk(STp, "No Mode Sense.\n"); in check_tape()
1152 DEBC_printk(STp,"Mode sense. Length %d, " in check_tape()
1164 DEBC_printk(STp, "Density %x, tape length: %x, " in check_tape()
1191 DEBC_printk(STp, "Block size: %d, buffer size: %d (%d blocks).\n", in check_tape()
1198 DEBC_printk(STp, "Write protected\n"); in check_tape()
1212 DEBC_printk(STp, "Updating partition number in status.\n"); in check_tape()
1271 DEBC_printk(STp, "Device already in use.\n"); in st_open()
1360 DEBC_printk(STp, "switch_partition at close failed.\n"); in st_flush()
1376 DEBC_printk(STp, "Async write waits %d, finished %d.\n", in st_flush()
1418 DEBC_printk(STp, "Buffer flushed, %d EOF(s) written\n", cmd[4]); in st_flush()
1793 DEBC_printk(STp, "Error on write:\n"); in st_write()
1820 DEBC_printk(STp, "EOM with %d " in st_write()
1835 DEBC_printk(STp, "Retry " in st_write()
1849 DEBC_printk(STp, "EOM with " in st_write()
1960 DEBC_printk(STp, in read_tape()
2011 DEBC_printk(STp, "ILI but " in read_tape()
2031 DEBC_printk(STp, "EOF detected (%d " in read_tape()
2045 DEBC_printk(STp, "EOM detected (%d " in read_tape()
2052 DEBC_printk(STp, "Tape error while reading.\n"); in read_tape()
2056 DEBC_printk(STp, "Zero returned for " in read_tape()
2290 DEBC_printk(STp, "Initialized mode %d definition from mode 0\n",
2357 DEBC_printk(STp, "Default block size disabled.\n");
2360 DEBC_printk(STp,"Default block size set to "
2371 DEBC_printk(STp, "Long timeout set to %d seconds.\n",
2376 DEBC_printk(STp, "Normal timeout set to %d seconds.\n",
2397 DEBC_printk(STp,
2401 DEBC_printk(STp, "Density default set to %x\n",
2411 DEBC_printk(STp,
2415 DEBC_printk(STp,
2424 DEBC_printk(STp,
2429 DEBC_printk(STp, "Compression "
2435 DEBC_printk(STp, "Compression default "
2559 DEBC_printk(STp, "Compression mode page not supported.\n"); in st_compression()
2564 DEBC_printk(STp, "Compression state is %d.\n", in st_compression()
2569 DEBC_printk(STp, "Compression not supported.\n"); in st_compression()
2587 DEBC_printk(STp, "Compression change failed.\n"); in st_compression()
2590 DEBC_printk(STp, "Compression state changed to %d.\n", state); in st_compression()
2621 DEBC_printk(STp, " Enhanced %sload slot %2d.\n", in do_load_unload()
2838 DEBC_printk(STp, "Rewinding tape.\n"); in st_int_ioctl()
2842 DEBC_printk(STp, "No op on tape.\n"); in st_int_ioctl()
2852 DEBC_printk(STp, "Retensioning tape.\n"); in st_int_ioctl()
2870 DEBC_printk(STp, "Spacing to end of recorded medium.\n"); in st_int_ioctl()
2886 DEBC_printk(STp, "Erasing tape.\n"); in st_int_ioctl()
3128 DEBC_printk(STp, " Can't read tape position.\n"); in get_location()
3147 DEBC_printk(STp, "Got tape pos. blk %d part %d.\n", in get_location()
3174 DEBC_printk(STp, "Setting block to %d and partition to %d.\n", in set_location()
3189 DEBC_printk(STp, "Visited block %d for " in set_location()
3213 DEBC_printk(STp, "Trying to change partition " in set_location()
3313 DEBC_printk(STp, "Can't read medium partition page.\n"); in nbr_partitions()
3318 DEBC_printk(STp, "Number of partitions %d.\n", result); in nbr_partitions()
3352 DEBC_printk(STp, "Can't read partition mode page.\n"); in partition_tape()
3358 DEBC_printk(STp, "Partition page length is %d bytes.\n", in partition_tape()
3369 DEBC_printk(STp, "psd_cnt %d, max.parts %d, nbr_parts %d\n", in partition_tape()
3377 DEBC_printk(STp, "Formatting tape with one partition.\n"); in partition_tape()
3384 DEBC_printk(STp, "Formatting tape with two partitions " in partition_tape()