Lines Matching refs:We

70 	 * Turn off the selection hardware.  We need to reset the
104 	 * We have at least one queued SCB now and we don't have any 
163 	 * We aren't expecting a bus free, so interrupt
186 		 * We've just been selected.  Assert BSY and
240 		 * initiator.  We follow the guidlines from section 6.5
267 		 * immediately follow the identify.  We test for a valid
411  * We carefully toggle SPIOEN to allow us to return the 
454 		 * We've just re-selected an initiator.
570 		 * We reuse the first 8 bytes of the TARG_SCSIRATE
690 	 * We assume that the kernel driver may reset us
698 	 * We don't know the target we will connect to,
754 	 * We fetch a "cacheline aligned" and sized amount of data
833 		/* We don't have any valid S/G elements */
848 	/* We have seen a data phase for the first time */
854 	 * flag in the highest byte of the data count.  We cannot
937 		 * We have two goals here.  Do as much other work
946 			 * the flushing process now.  We'll poke
954 		 * We assume that, even though data may still be
988 		 * in addition to the currently active element.  We
1003 		/* We are not the last seg */
1040 			 * We enable the auto-ack feature on DT capable
1082 			 * We don't need to worry about maintaining the
1118 		 * We will be "done" DMAing when the transfer count goes to
1277 	 * the SCB.  We use STCNT instead of HCNT, since it's a reflection
1345 		 * initiator before changing phase.  We only need to
1602  * We received a "command complete" message.  Put the SCB_TAG into the QOUTFIFO,
1619 	 * and then attempt to complete the command again.  We should use a
1777  * code do the rest.  We also reset/reallocate the FIFO to make
1782 						 * We'll reload them
1855 		 * We only allow one untagged command per-target
2069 	 * We didn't find it.  Page in the SCB.