95 	printk(KERN_DEBUG "%s: registered netdevice %s\n",  in hostap_add_interface()
167 		printk(KERN_DEBUG "%s: using pre-allocated WDS netdevice %s\n",  in prism2_wds_add()
184 		printk(KERN_DEBUG "'%s' too long base device name\n",  in prism2_wds_add()
348 		printk(KERN_DEBUG "Could not read current WEP flags.\n");  in hostap_set_encryption()
378 		printk(KERN_DEBUG "Could not write new WEP flags (0x%x)\n",  in hostap_set_encryption()
404 			printk(KERN_DEBUG "Could not set key %d (len=%d)\n",  in hostap_set_encryption()
410 		printk(KERN_DEBUG "Could not set default keyid %d\n", idx);  in hostap_set_encryption()
417 	printk(KERN_DEBUG "%s: encryption setup failed\n", local->dev->name);  in hostap_set_encryption()
528 	printk(KERN_DEBUG "%s: RX status=0x%04x (port=%d, type=%d, "  in hostap_dump_rx_header()
535 	printk(KERN_DEBUG "   FC=0x%04x (type=%d:%d) dur=0x%04x seq=0x%04x "  in hostap_dump_rx_header()
544 	printk(KERN_DEBUG "   A1=%pM A2=%pM A3=%pM A4=%pM\n",  in hostap_dump_rx_header()
547 	printk(KERN_DEBUG "   dst=%pM src=%pM len=%d\n",  in hostap_dump_rx_header()
557 	printk(KERN_DEBUG "%s: TX status=0x%04x retry_count=%d tx_rate=%d "  in hostap_dump_tx_header()
563 	printk(KERN_DEBUG "   FC=0x%04x (type=%d:%d) dur=0x%04x seq=0x%04x "  in hostap_dump_tx_header()
572 	printk(KERN_DEBUG "   A1=%pM A2=%pM A3=%pM A4=%pM\n",  in hostap_dump_tx_header()
575 	printk(KERN_DEBUG "   dst=%pM src=%pM len=%d\n",  in hostap_dump_tx_header()
666 		printk(KERN_DEBUG "%s: could not set interface UP - no PRI "  in prism2_open()
791 	printk(KERN_DEBUG "%s: CMD=%04x EVSTAT=%04x "  in prism2_tx_timeout()
895 	printk(KERN_DEBUG "%s: enabling hostapd mode\n", dev->name);  in hostap_enable_hostapd()
911 	printk(KERN_DEBUG "%s: disabling hostapd mode\n", dev->name);  in hostap_disable_hostapd()
927 	printk(KERN_DEBUG "%s: enabling hostapd STA mode\n", dev->name);  in hostap_enable_hostapd_sta()
943 	printk(KERN_DEBUG "%s: disabling hostapd mode\n", dev->name);  in hostap_disable_hostapd_sta()