131 		hw_dbg(hw, "ixgbe_fc_rx_pause not valid in strict IEEE mode\n");  in ixgbe_setup_fc()
222 		hw_dbg(hw, "Flow control param set incorrectly\n");  in ixgbe_setup_fc()
239 		hw_dbg(hw, "Set up FC; PCS1GLCTL = 0x%08X\n", reg);  in ixgbe_setup_fc()
262 	hw_dbg(hw, "Set up FC; IXGBE_AUTOC = 0x%08X\n", reg);  in ixgbe_setup_fc()
503 		hw_dbg(hw, "PBA string buffer was null\n");  in ixgbe_read_pba_string_generic()
509 		hw_dbg(hw, "NVM Read Error\n");  in ixgbe_read_pba_string_generic()
515 		hw_dbg(hw, "NVM Read Error\n");  in ixgbe_read_pba_string_generic()
525 		hw_dbg(hw, "NVM PBA number is not stored as string\n");  in ixgbe_read_pba_string_generic()
529 			hw_dbg(hw, "PBA string buffer too small\n");  in ixgbe_read_pba_string_generic()
561 		hw_dbg(hw, "NVM Read Error\n");  in ixgbe_read_pba_string_generic()
566 		hw_dbg(hw, "NVM PBA number section invalid length\n");  in ixgbe_read_pba_string_generic()
572 		hw_dbg(hw, "PBA string buffer too small\n");  in ixgbe_read_pba_string_generic()
583 			hw_dbg(hw, "NVM Read Error\n");  in ixgbe_read_pba_string_generic()
827 		hw_dbg(hw, "Eeprom params: type = %d, size = %d, address bits: %d\n",  in ixgbe_init_eeprom_params_generic()
1129 			hw_dbg(hw, "Eeprom read timed out\n");  in ixgbe_read_eerd_buffer_generic()
1173 	hw_dbg(hw, "Detected EEPROM page size = %d words.\n",  in ixgbe_detect_eeprom_page_size_generic()
1222 			hw_dbg(hw, "Eeprom write EEWR timed out\n");  in ixgbe_write_eewr_buffer_generic()
1230 			hw_dbg(hw, "Eeprom write EEWR timed out\n");  in ixgbe_write_eewr_buffer_generic()
1310 		hw_dbg(hw, "Could not acquire EEPROM grant\n");  in ixgbe_acquire_eeprom()
1350 		hw_dbg(hw, "Driver can't access the Eeprom - SMBI Semaphore not granted.\n");  in ixgbe_get_eeprom_semaphore()
1365 			hw_dbg(hw, "Software semaphore SMBI between device drivers not granted.\n");  in ixgbe_get_eeprom_semaphore()
1392 		hw_dbg(hw, "SWESMBI Software EEPROM semaphore not granted.\n");  in ixgbe_get_eeprom_semaphore()
1449 		hw_dbg(hw, "SPI EEPROM Status error\n");  in ixgbe_ready_eeprom()
1651 			hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_calc_eeprom_checksum_generic()
1660 			hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_calc_eeprom_checksum_generic()
1669 			hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_calc_eeprom_checksum_generic()
1678 				hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_calc_eeprom_checksum_generic()
1712 		hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_validate_eeprom_checksum_generic()
1724 		hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_validate_eeprom_checksum_generic()
1757 		hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_update_eeprom_checksum_generic()
1790 		hw_dbg(hw, "RAR index %d is out of range.\n", index);  in ixgbe_set_rar_generic()
1837 		hw_dbg(hw, "RAR index %d is out of range.\n", index);  in ixgbe_clear_rar_generic()
1880 		hw_dbg(hw, " Keeping Current RAR0 Addr =%pM\n", hw->mac.addr);  in ixgbe_init_rx_addrs_generic()
1883 		hw_dbg(hw, "Overriding MAC Address in RAR[0]\n");  in ixgbe_init_rx_addrs_generic()
1884 		hw_dbg(hw, " New MAC Addr =%pM\n", hw->mac.addr);  in ixgbe_init_rx_addrs_generic()
1896 	hw_dbg(hw, "Clearing RAR[1-%d]\n", rar_entries - 1);  in ixgbe_init_rx_addrs_generic()
1906 	hw_dbg(hw, " Clearing MTA\n");  in ixgbe_init_rx_addrs_generic()
1946 		hw_dbg(hw, "MC filter type param set incorrectly\n");  in ixgbe_mta_vector()
1971 	hw_dbg(hw, " bit-vector = 0x%03X\n", vector);  in ixgbe_set_mta()
2011 	hw_dbg(hw, " Clearing MTA\n");  in ixgbe_update_mc_addr_list_generic()
2016 		hw_dbg(hw, " Adding the multicast addresses:\n");  in ixgbe_update_mc_addr_list_generic()
2029 	hw_dbg(hw, "ixgbe_update_mc_addr_list_generic Complete\n");  in ixgbe_update_mc_addr_list_generic()
2089 				hw_dbg(hw, "Invalid water mark configuration\n");  in ixgbe_fc_enable_generic()
2146 		hw_dbg(hw, "Flow control param set incorrectly\n");  in ixgbe_fc_enable_generic()
2216 			hw_dbg(hw, "Flow Control = FULL.\n");  in ixgbe_negotiate_fc()
2219 			hw_dbg(hw, "Flow Control=RX PAUSE frames only\n");  in ixgbe_negotiate_fc()
2224 		hw_dbg(hw, "Flow Control = TX PAUSE frames only.\n");  in ixgbe_negotiate_fc()
2228 		hw_dbg(hw, "Flow Control = RX PAUSE frames only.\n");  in ixgbe_negotiate_fc()
2231 		hw_dbg(hw, "Flow Control = NONE.\n");  in ixgbe_negotiate_fc()
2477 	hw_dbg(hw, "GIO Master Disable bit didn't clear - requesting resets\n");  in ixgbe_disable_pcie_master()
2497 	hw_dbg(hw, "PCIe transaction pending bit also did not clear.\n");  in ixgbe_disable_pcie_master()
2624 		hw_dbg(hw, "Rx unit being enabled before security path fully disabled. Continuing with init.\n");  in ixgbe_disable_rx_buff_generic()
2878 		hw_dbg(hw, "RAR index %d is out of range.\n", rar);  in ixgbe_clear_vmdq_generic()
2927 		hw_dbg(hw, "RAR index %d is out of range.\n", rar);  in ixgbe_set_vmdq_generic()
3021 			hw_dbg(hw, "No space in VLVF.\n");  in ixgbe_find_vlvf_slot()
3215 		hw_dbg(hw, "LINKS changed from %08X to %08X\n",  in ixgbe_check_mac_link_generic()
3509 		hw_dbg(hw, "Buffer length failure buffersize-%d.\n", length);  in ixgbe_host_interface_command()
3520 		hw_dbg(hw, "IXGBE_HOST_EN bit disabled.\n");  in ixgbe_host_interface_command()
3526 		hw_dbg(hw, "Buffer length failure, not aligned to dword");  in ixgbe_host_interface_command()
3553 		hw_dbg(hw, "Command has failed with no status valid.\n");  in ixgbe_host_interface_command()
3575 		hw_dbg(hw, "Buffer not large enough for reply message.\n");  in ixgbe_host_interface_command()
3980 			hw_dbg(hw, "Unexpected media type\n");  in ixgbe_setup_mac_link_multispeed_fiber()
4040 			hw_dbg(hw, "Unexpected media type\n");  in ixgbe_setup_mac_link_multispeed_fiber()
4114 		hw_dbg(hw, "Invalid fixed module speed\n");  in ixgbe_set_soft_rate_select_speed()
4123 		hw_dbg(hw, "Failed to read Rx Rate Select RS0\n");  in ixgbe_set_soft_rate_select_speed()
4133 		hw_dbg(hw, "Failed to write Rx Rate Select RS0\n");  in ixgbe_set_soft_rate_select_speed()