Lines Matching refs:CAN

1 menu "CAN Device Drivers"
4 tristate "Virtual Local CAN Interface (vcan)"
7 virtual local CAN interface.
13 tristate "Serial / USB serial CAN Adaptors (slcan)"
16 CAN driver for several 'low cost' CAN interfaces that are attached
20 As only the sending and receiving of CAN frames is implemented, this
21 driver should work with the (serial/USB) CAN hardware from:
28 The slcan driver supports up to 10 CAN netdevices by default which
33 tristate "Platform CAN drivers with Netlink support"
36 Enables the common framework for platform CAN drivers with Netlink
37 support. This is the standard library for CAN drivers.
43 bool "CAN bit-timing calculation"
46 If enabled, CAN bit-timing parameters will be calculated for the
48 get started. This works fine for the most common CAN controllers
49 with standard bit-rates but may fail for exotic bit-rates or CAN
61 events on each supported CAN device.
67 tristate "Atmel AT91 onchip CAN controller"
70 This is a driver for the SoC CAN controller in Atmel's AT91SAM9263
75 tristate "TI High End CAN Controller"
77 Driver for TI HECC (High End CAN Controller) module found on many
82 tristate "Analog Devices Blackfin on-chip CAN"
84 Driver for the Analog Devices Blackfin on-chip CAN controllers
90 tristate "Janz VMOD-ICAN3 Intelligent CAN controller"
93 Driver for Janz VMOD-ICAN3 Intelligent CAN controller module, which
106 tristate "Intel EG20T PCH CAN controller"
109 This driver is for PCH CAN of Topcliff (Intel EG20T PCH) which
111 This driver can access CAN bus.
114 tristate "Aeroflex Gaisler GRCAN and GRHCAN CAN devices"
123 tristate "Renesas R-Car CAN controller"
126 Say Y here if you want to use CAN controller found on Renesas R-Car
133 tristate "Allwinner A10 CAN controller"
136 Say Y here if you want to use CAN controller found on Allwinner
143 tristate "Xilinx CAN"
147 Xilinx CAN driver. This driver supports both soft AXI CAN IP and
169 bool "CAN devices debugging messages"
171 Say Y here if you want the CAN device drivers to produce a bunch of
173 a problem with CAN support and want to see more of what is going