86 		pr_err("no proper response during fw download");  in validate_firmware_response()
87 		pr_err("data6 %x", skb->data[5]);  in validate_firmware_response()
111 		pr_err("Data length is too large len %d room %d", len,  in kim_check_data_len()
149 		pr_err(" received null from TTY ");  in kim_int_recv()
200 			pr_err("can't allocate mem for new packet");  in kim_int_recv()
223 		pr_err("kim: couldn't write 4 bytes");  in read_local_version()
230 		pr_err(" waiting for ver info- timed out or received signal");  in read_local_version()
270 		pr_err("invalid action after change remote baud command");  in skip_change_remote_baud()
299 		pr_err("kim: failed to read local ver");  in download_firmware()
307 		pr_err(" request_firmware failed(errno %ld) for %s", err,  in download_firmware()
348 					pr_err("Unable to get free "  in download_firmware()
359 				pr_err("Timeout while waiting for free "  in download_firmware()
386 				pr_err("Number of bytes written to uart "  in download_firmware()
399 				pr_err("response timeout/signaled during fw download ");  in download_firmware()
492 			pr_err("ldisc installation timeout");  in st_kim_start()
502 				pr_err("download firmware failed");  in st_kim_start()
548 		pr_err(" timed out waiting for ldisc to be un-installed");  in st_kim_stop()
741 		pr_err("no mem to allocate");  in kim_probe()
748 		pr_err(" ST core init failed");  in kim_probe()
759 		pr_err(" gpio %d request failed ", kim_gdata->nshutdown);  in kim_probe()
766 		pr_err(" unable to configure gpio %d", kim_gdata->nshutdown);  in kim_probe()
777 		pr_err("failed to create sysfs entries");  in kim_probe()
789 		pr_err(" debugfs entries creation failed ");  in kim_probe()