29 #define dprintk(args...) do { if (debug) { printk(KERN_DEBUG "DiB7000P: "); printk(args); printk("\…  macro
101 		dprintk("could not acquire lock");  in dib7000p_read_word()
119 		dprintk("i2c read error on %d", reg);  in dib7000p_read_word()
131 		dprintk("could not acquire lock");  in dib7000p_write_word()
177 	dprintk("setting output mode for demod %p to %d", &state->demod, mode);  in dib7000p_set_output_mode()
207 		dprintk("Unhandled output_mode passed to be set for demod %p", &state->demod);  in dib7000p_set_output_mode()
227 		dprintk("diversity combination deactivated - forced by COFDM parameters");  in dib7000p_set_diversity_in()
377 		dprintk("using default timf");  in dib7000p_set_bandwidth()
380 		dprintk("using updated timf");  in dib7000p_set_bandwidth()
497 …dprintk("Updating pll (prediv: old =  %d new = %d ; loopdiv : old = %d new = %d)", prediv, bw->pll…  in dib7000p_update_pll()
514 			dprintk("Waiting for PLL to lock");  in dib7000p_update_pll()
524 	dprintk("gpio dir: %x: val: %x, pwm_pos: %x", st->gpio_dir, st->gpio_val, st->cfg.gpio_pwm_pos);  in dib7000p_reset_gpio()
672 		dprintk("GPIO reset was not successful.");  in dib7000p_demod_reset()
684 		dprintk("OUTPUT_MODE could not be reset.");  in dib7000p_demod_reset()
762 		dprintk("no valid AGC configuration found for band 0x%02x", band);  in dib7000p_set_agc_config()
779 	dprintk("WBD: ref: %d, sel: %d, active: %d, alpha: %d",  in dib7000p_set_agc_config()
809 …dprintk("setting a frequency offset of %dkHz internal freq = %d invert = %d", offset_khz, internal…  in dib7000p_set_dds()
905 		dprintk("SPLIT %p: %hd", demod, agc_split);  in dib7000p_agc_startup()
937 	dprintk("updated timf_frequency: %d (default: %d)", state->timf, state->cfg.bw->timf);  in dib7000p_update_timf()
1205 	dprintk("relative position of the Spur: %dk (RF: %dk, XTAL: %dk)", f_rel, rf_khz, xtal);  in dib7000p_spur_protect()
1255 		dprintk("PALF COEF: %d re: %d im: %d", k, coef_re[k], coef_im[k]);  in dib7000p_spur_protect()
1283 		dprintk("SFN workaround is active");  in dib7000p_tune()
1393 	dprintk("checking demod on I2C address: %d (%x)", st->i2c_addr, st->i2c_addr);  in dib7000p_identify()
1396 		dprintk("wrong Vendor ID (read=0x%x)", value);  in dib7000p_identify()
1401 		dprintk("wrong Device ID (%x)", value);  in dib7000p_identify()
1539 		dprintk("autosearch returns: %d", found);  in dib7000p_set_frontend()
1954 		dprintk("Next all layers stats available in %u us.", time_us);  in dib7000p_get_stats()
2022 			dprintk("-D-  DiB7000PC detected");  in dib7000pc_detection()
2030 			dprintk("-D-  DiB7000PC detected");  in dib7000pc_detection()
2034 	dprintk("-D-  DiB7000PC not detected");  in dib7000pc_detection()
2053 	dprintk("PID filter enabled %d", onoff);  in dib7000p_pid_filter_ctrl()
2060 	dprintk("PID filter: index %x, PID %d, OnOff %d", id, pid, onoff);  in dib7000p_pid_filter()
2091 				dprintk("DiB7000P #%d: not identified\n", k);  in dib7000p_i2c_enumeration()
2103 		dprintk("IC %d initialized (to i2c_address 0x%x)", k, new_addr);  in dib7000p_i2c_enumeration()
2139 	dprintk("raw pow_i = %d", pow_i);  in dib7000p_get_adc_power()
2146 	dprintk(" mant = %d exp = %d", mant / 1000, exp);  in dib7000p_get_adc_power()
2149 	dprintk(" ix = %d", ix);  in dib7000p_get_adc_power()
2153 	dprintk(" pow_i = %d", pow_i);  in dib7000p_get_adc_power()
2188 			dprintk("Tuner ITF: write busy (overflow)");  in w7090p_tuner_write_serpar()
2208 			dprintk("TunerITF: read busy (overflow)");  in w7090p_tuner_read_serpar()
2217 			dprintk("TunerITF: read busy (empty)");  in w7090p_tuner_read_serpar()
2438 	dprintk("Configure DibStream Tx");  in dib7090_cfg_DibTx()
2458 	dprintk("Configure DibStream Rx");  in dib7090_cfg_DibRx()
2495 	dprintk("Enable Mpeg mux");  in dib7090_configMpegMux()
2516 			dprintk("SET MPEG ON DIBSTREAM TX");  in dib7090_setDibTxMux()
2521 			dprintk("SET DIV_OUT ON DIBSTREAM TX");  in dib7090_setDibTxMux()
2526 			dprintk("SET ADC_OUT ON DIBSTREAM TX");  in dib7090_setDibTxMux()
2542 			dprintk("SET DEM OUT OLD INTERF ON HOST BUS");  in dib7090_setHostBusMux()
2547 			dprintk("SET DIBSTREAM TX ON HOST BUS");  in dib7090_setHostBusMux()
2552 			dprintk("SET MPEG MUX ON HOST BUS");  in dib7090_setHostBusMux()
2568 			dprintk("%s mode OFF : by default Enable Mpeg INPUT", __func__);  in dib7090_set_diversity_in()
2584 			dprintk("%s ON : Enable diversity INPUT", __func__);  in dib7090_set_diversity_in()
2615 			dprintk("setting output mode TS_SERIAL using Mpeg Mux");  in dib7090_set_output_mode()
2619 			dprintk("setting output mode TS_SERIAL using Smooth bloc");  in dib7090_set_output_mode()
2627 			dprintk("setting output mode TS_PARALLEL_GATED using Mpeg Mux");  in dib7090_set_output_mode()
2631 			dprintk("setting output mode TS_PARALLEL_GATED using Smooth block");  in dib7090_set_output_mode()
2638 		dprintk("setting output mode TS_PARALLEL_CONT using Smooth block");  in dib7090_set_output_mode()
2644 		dprintk("setting output mode TS_FIFO using Smooth block");  in dib7090_set_output_mode()
2652 		dprintk("setting output mode MODE_DIVERSITY");  in dib7090_set_output_mode()
2658 		dprintk("setting output mode MODE_ANALOG_ADC");  in dib7090_set_output_mode()
2681 	dprintk("sleep dib7090: %d", onoff);  in dib7090_tuner_sleep()