43 			printk(KERN_INFO "%s %s: device not capable of full "  in ide_setup_pci_baseregs()
47 		printk(KERN_INFO "%s %s: placing both ports into native PCI "  in ide_setup_pci_baseregs()
52 			printk(KERN_ERR "%s %s: rewrite of PROGIF failed, "  in ide_setup_pci_baseregs()
96 			printk(KERN_ERR "%s %s: DMA base is invalid\n",  in ide_pci_dma_base()
119 			printk(KERN_INFO "%s %s: simplex device: DMA forced\n",  in ide_pci_check_simplex()
136 		printk(KERN_INFO "%s %s: simplex device: DMA disabled\n",  in ide_pci_check_simplex()
159 			printk(KERN_ERR "%s %s: error updating PCICMD\n",  in ide_pci_set_master()
172 	printk(KERN_INFO "%s %s: IDE controller (0x%04x:0x%04x rev 0x%02x)\n",  in ide_setup_pci_noise()
199 			printk(KERN_WARNING "%s %s: couldn't enable device\n",  in ide_pci_enable()
203 		printk(KERN_WARNING "%s %s: BIOS configuration fixed\n",  in ide_pci_enable()
214 		printk(KERN_ERR "%s %s: can't set DMA mask\n",  in ide_pci_enable()
233 		printk(KERN_ERR "%s %s: can't reserve resources\n",  in ide_pci_enable()
260 		printk(KERN_INFO "%s %s: device disabled (BIOS)\n",  in ide_pci_configure()
265 		printk(KERN_ERR "%s %s: error accessing PCI regs\n",  in ide_pci_configure()
270 		printk(KERN_ERR "%s %s: unable to enable IDE controller\n",  in ide_pci_configure()
326 			printk(KERN_ERR "%s %s: I/O baseregs (BIOS) are "  in ide_hw_configure()
341 		printk(KERN_ERR "%s %s: bad PCI BARs for port %d, skipping\n",  in ide_hw_configure()
388 			printk(KERN_INFO "    %s: MMIO-DMA\n", hwif->name);  in ide_hwif_setup_dma()
390 			printk(KERN_INFO "    %s: BM-DMA at 0x%04lx-0x%04lx\n",  in ide_hwif_setup_dma()
429 		printk(KERN_ERR "%s %s: error accessing PCI regs\n",  in ide_setup_pci_controller()
437 		printk(KERN_INFO "%s %s: device enabled (Linux)\n",  in ide_setup_pci_controller()
476 			printk(KERN_INFO "%s %s: IDE port disabled\n",  in ide_pci_setup_ports()
522 			printk(KERN_INFO "%s %s: not 100%% native mode: will "  in do_ide_setup_pci_device()
526 		printk(KERN_WARNING "%s %s: bad irq (%d): will probe later\n",  in do_ide_setup_pci_device()
529 		printk(KERN_INFO "%s %s: 100%% native mode on irq %d\n",  in do_ide_setup_pci_device()