202 		dev_err(dev->device, "Unknown command %d\n", cmd);  in bcm_kona_i2c_send_cmd_to_ctrl()
244 			dev_err(dev->device, "CMDBUSY timeout\n");  in bcm_kona_i2c_wait_if_busy()
279 		dev_err(dev->device, "controller timed out\n");  in bcm_kona_send_i2c_cmd()
314 		dev_err(dev->device, "RX FIFO time out\n");  in bcm_kona_i2c_read_fifo_single()
436 		dev_err(dev->device, "unexpected NAK\n");  in bcm_kona_i2c_write_fifo_single()
442 		dev_err(dev->device, "completion timed out\n");  in bcm_kona_i2c_write_fifo_single()
570 		dev_err(dev->device, "%s: clk_set_rate returned %d\n",  in bcm_kona_i2c_switch_to_hs()
581 		dev_err(dev->device, "High speed restart command failed\n");  in bcm_kona_i2c_switch_to_hs()
596 		dev_err(dev->device, "%s: clk_set_rate returned %d\n",  in bcm_kona_i2c_switch_to_std()
614 		dev_err(dev->device, "%s: peri clock enable failed. err %d\n",  in bcm_kona_i2c_xfer()
628 		dev_err(dev->device, "Start command failed rc = %d\n", rc);  in bcm_kona_i2c_xfer()
647 				dev_err(dev->device,  in bcm_kona_i2c_xfer()
657 				dev_err(dev->device,  in bcm_kona_i2c_xfer()
668 				dev_err(dev->device, "read failure\n");  in bcm_kona_i2c_xfer()
674 				dev_err(dev->device, "write failure");  in bcm_kona_i2c_xfer()
723 		dev_err(dev->device, "missing clock-frequency property\n");  in bcm_kona_i2c_assign_bus_speed()
776 		dev_err(dev->device, "couldn't get clock\n");  in bcm_kona_i2c_probe()
782 		dev_err(dev->device, "%s: clk_set_rate returned %d\n",  in bcm_kona_i2c_probe()
789 		dev_err(dev->device, "couldn't enable clock\n");  in bcm_kona_i2c_probe()
829 		dev_err(dev->device, "no irq resource\n");  in bcm_kona_i2c_probe()
838 		dev_err(dev->device, "failed to request irq %i\n", dev->irq);  in bcm_kona_i2c_probe()
865 		dev_err(dev->device, "failed to add adapter\n");  in bcm_kona_i2c_probe()