Lines Matching refs:option
8 This option enables the ETRAX FS built-in 10/100Mbit Ethernet
15 This option disables all MDIO communication with an ethernet
16 transceiver connected to the MII interface. This option shall
18 switch. This option should normally be disabled. If enabled,
87 Selecting this option will make it run in DMA mode.
100 Selecting this option will make it run in DMA mode.
113 This option enables MTD mapping of flash devices. Needed to use
120 When this option is not set, mtd0 refers to the first partition
141 This option enables MTD mapping of NAND flash devices. Needed to use
175 This option enables a driver for the stream co-processor
182 This option enables the SD/MMC host controller interface.