Lines Matching refs:board

8 sound is handled in slightly different ways on each board.
11 bttv-cards.c, which holds the information required for each board.
19 correct board type as insmod argument, "insmod bttv card=2" for
28 example.  If your board has one, you might have to load a helper
30 chip used on your board:  Bad luck.  Start writing a new one.  Well,
34 speakers connected directly to the grabber board.  Hint: check the
51 Most grabber board vendors use these pins to control an external chip
52 which does the sound routing.  But every board is a little different.
58 informations for each known board.  You basically have to create a new
59 line for your board.  The important fields are these two:
89 You can have a look at the board to see which of the gpio pins are