Lines Matching refs:devices

12 is so that devices can maintain their internal state and hubs can
13 detect connect-change events (devices being plugged in or unplugged).
25 wakes up all the devices attached to that controller are treated as
29 For many sorts of devices this behavior doesn't matter in the least.
36 devices.  The effect is exactly the same as if the device really had
49 it's as though you had unplugged all the USB devices.  Yes, it's
75 to each of the USB devices below that controller for which the
101 devices for which it is enabled.  You can enable the feature by doing
104 	echo 1 >/sys/bus/usb/devices/.../power/persist
110 devices where it really matters.
128 Furthermore, the USB-persist feature applies to _all_ USB devices, not
129 just mass-storage devices.  It might turn out to be equally useful for
145 entirely in their devices.
158 For those devices with avoid_reset_quirk attribute being set, persist