Lines Matching refs:use

40 standard utilities, use minicom and HyperTerminal, and work with
46 sysfs in /sys, and use "mdev" (in Busybox) or "udev" to make the
107 To use the gadget serial driver you must configure the Linux gadget
128 Your system should use mdev (from busybox) or udev to make the
137 you need to create /dev nodes by hand, the right numbers to use
145 If gadget serial is loaded as an ACM device you will want to use
147 serial is loaded as a bulk in/out device, you will want to use the
154 To use the Windows ACM driver you must have the "linux-cdc-acm.inf"
184 To use the Linux ACM driver you must configure the Linux host side
216 To use the Linux generic USB serial driver you must configure the
244 The legacy way is to use module parameters:
258 You can use minicom or HyperTerminal to try this out.
267 but use "/dev/ttyACM0" as the "Serial Device".  (If you have other
271 minicom similarly, but use "/dev/ttyUSB0" as the "Serial Device".
275 On a Windows host configure a new HyperTerminal session to use the